Engineering topics

Williams, G. E.

Publications and source records attributed to Williams, G. E..

4 records

NASA NTRS1991

The cryogenic on-orbit liquid analytical tool (COOLANT) - A computer program for evaluating the thermodynamic performance of orbital cryogen storage facilities

The United States plans to establish a permanent manned presence at the Space Station Freedom in low earth orbit (LEO) and then carry out exploration of the solar system from this base. These plans may require orbital cryogenic propellant storage depots. The COOLANT program has been developed to analyze the thermodynamic performance of these depots to support design tradeoff studies. It was developed as part of the Long Term Cryogenic Storage Facility Systems Study for NASA/MSFC. This paper discusses the program structure and capabilities of the COOLANT program. In addition, the results of an analysis of a 200,000 lbm hydrogen/oxygen storage depot tankset using COOLANT are presented.

Taylor, W. J.↗

NASA NTRS1989

Balloon-borne characterization of the Martian surface and lower atmosphere

A recent NASA-sponsored design course at Utah State University (USU) has focused upon a Mars Lander/Rover system designed to descend from a Martian orbit and deploy both surface and balloon-borne instruments to examine the Martian surface and lower atmosphere. The latter stages of the USU design effort placed major emphasis on the design of the balloon rover. This paper presents the results of that emphasis by discussing the payload requirements, identification of the design parameters, surface vs. descent deployment, design tradeoff studies, site-influenced departures from the baseline design, the final design concept, and the resulting balloon performance. A single hydrogen superpressure balloon is selected for use in the design mission. The paper concludes that characterization of the Martian surface and lower atmosphere by a descent-deployed, balloon-borne rover is a viable concept that should be actively pursued.

Redd, F. J.↗

NASA NTRS1987

Design considerations for a Martian Balloon Rover

The present NASA-sponsored design feasibility study for a balloon-borne sensor platform that is to be used over environmentally dissimilar sites on Mars gives attention to specific environmental and configurational parameters of a baseline balloon design, with a view to day/night altitude variations in response to temperature extremes. It is concluded that a Martian Balloon Rover can be developed using current technology; projected reductions in high-strength fabric density and radiation-resistant coatings will further enhance mission effectiveness, permitting either balloon size reductions or payload capacity increases.

Redd, F.↗

NASA NTRS1980

Chemical vapor deposited tungsten with dispersed carbides for Space Shuttle check valves

A chemical vapor deposited tungsten with dispersed carbides was selected as the material for Space Shuttle Orbital Maneuvering and Reaction Control Systems check valve poppets and seats. The selection followed a NASA-sponsored prototype check valve development program utilizing the cutter-seal shell poppet concept. The poppet material is deposited as a coating approximately 0.9 mm thick and fabricated into a shell as a free standing body. The seat material is deposited as a coating 1.1 mm thick on a seat blank, and the cutter seal is machined in the coating. Module tests demonstrated that the material could be ground and lapped to very sharp edges and could cut through typical system contaminants without excessive damage to the sealing surfaces. The material was also determined to be unaffected by exposure to a strongly oxidizing storable propellant.

Williams, G. E.↗