Search NASA⌕ Search

Engineering topics

Wilson, A. J.

Publications and source records attributed to Wilson, A. J..

Imaging out-of-plane polarized emission patterns on gap mode SERS substrates: from high molecular coverage to the single molecule regime

Gap mode surface-enhanced Raman scattering (SERS) substrates are created when a single nanoparticle is deposited on a thin metal film, creating a region of significant electromagnetic field enhancement in the gap between the nanoparticle and the film due to excitation of a vertically-oriented, out-of-plane dipole plasmon mode, e.g. the gap plasmon. When molecules are located in the gap and couple to the gap plasmon mode, the resulting emission is polarized perpendicular to the thin film, generating SERS emission patterns that have a characteristic donut shape. We analyze these SERS emission patterns using a dipole emission model and extract out-of-plane and in-plane emission angles associated with the gap plasmon mode. Fluctuations in both of these angles reveal dynamic heterogeneity due to molecular motion within the hot spot that changes as a function of molecular coverage. We also reveal static heterogeneity associated with structural defects in the thin film component of the gap mode substrates, indicating that even nanometer-scale surface roughness can impact the quality of gap mode emission.

Chemistry↗

Fabrication process of a high temperature polymer matrix engine duct

The process that was used in the molding of an advanced composite outer by-pass duct planned for the F404 engine is discussed. This duct was developed as a potential replacement for the existing titanium duct in order to reduce both the weight and cost of the duct. The composite duct is now going into the manufacturing technology portion of the program. The duct is fabricated using graphite cloth impregnated with the PMR-15 matrix system.

Pratt, R. D.↗

Composite engine duct fabrication

The trimonomer polyimide resin reinforced with graphite fibers, PMR15, is lower in weight (by 20 percent) and less expensive than titanium. The duct walls are of solid laminate and are made of woven T300 graphite cloth. The original concept for the duct involved a solid shell of T300/PMR15 made up of seven plies of cloth tapered to eleven plies at each end. The bosses and built-up areas around the cutouts are also of T300/PMR15. The end flages riveted to the shell, however, are of titanium. A buckling test demonstrated the ability of the composite analytical design techniques employed to predict the buckling strength of the composite shell. Engines tests are described, noting that the successful repair of a hole demonstrated an important advantage over titanium. The development work now being done to eliminate the titanium end flanges is described, noting that an all-composite duct is in prospect. The savings estimated with a titanium-flanged composite duct are $16,891,000 (1982 dollars) and $35,504,000 (then-year dollars); the savings possible with an all-composite duct are put at $27,025,000 (1982 dollars) and $56,806,000 (then-year dollars).

Pratt, R. D.↗

Pneumatic flow comparator

Pneumatic flow comparator provides simple go, no-go evaluation of individual tubes. Flow characteristics of tubes used to form the walls of regeneratively cooled combustors must be identical within very close tolerances to ensure equally distributed coolant flow throughout the combustor wall.

Wilson, A. J.↗

Fluorescent particles enable visualization of gas flow

Fluorescent particles enable visualization of the flow patterns of gases at slow velocities. Through a transparent section in the gas line, a camera views the visible light emitted by the particles carried by the gas stream. Fine definition of the particle tracks are obtained at slow camera shutter speeds.

Wilson, A. J.↗