Quantum Communications at NASA Glenn Research Center
This presentation outlines the past history and current research program in quantum communications at NASA Glenn Research Center.
photon↗
Engineering topics
Wilson, Jeffrey
Publications and source records attributed to Wilson, Jeffrey.
AeroMACS C-Band Interference Modeling and Simulation Results
A new C-band (5091-5150 MHz) airport communications system designated as Aeronautical Mobile Airport Communications System (AeroMACS) is being planned under the Federal Aviation Administration s NextGen program. It is necessary to establish practical limits on AeroMACS transmission power from airports so that the threshold of interference into the Mobile Satellite Service (Globalstar) feeder uplinks is not exceeded. To help provide guidelines for these limits, interference models have been created with the commercial software Visualyse Professional. In this presentation, simulation results were shown for the aggregate interference power at low earth orbit from AeroMACS transmitters at each of up to 757 airports in the United States, Canada, Mexico, and the surrounding area. Both omni-directional and sectoral antenna configurations were modeled. Effects of antenna height, beamwidth, and tilt were presented.
Wilson, Jeffrey↗
High-Power, High-Efficiency Ka-Band Space Traveling-Wave Tube
The L-3 Communications Model 999H traveling-wave tube (TWT) has been demonstrated to generate an output power of 144 W at 60-percent overall efficiency in continuous-wave operation over the frequency band from 31.8 to 32.3 GHz. The best TWT heretofore commercially available for operation in the affected frequency band is characterized by an output power of only 35 W and an efficiency of 50 percent. Moreover, whereas prior TWTs are limited to single output power levels, it has been shown that the output power of the Model 999H can be varied from 54 to 144 W. A TWT is a vacuum electronic device used to amplify microwave signals. TWTs are typically used in free-space communication systems because they are capable of operating at power and efficiency levels significantly higher than those of solid-state devices. In a TWT, an electron beam is generated by an electron gun consisting of a cathode, focusing electrodes, and an anode. The electrons pass through a hole in the anode and are focused into a cylindrical beam by a stack of periodic permanent magnets and travel along the axis of an electrically conductive helix, along which propagates an electromagnetic wave that has been launched by an input signal that is to be amplified. The beam travels within the helix at a velocity close to the phase velocity of the electromagnetic wave. The electromagnetic field decelerates some of the electrons and accelerates others, causing the beam to become formed into electron bunches, which further interact with the electromagnetic wave in such a manner as to surrender kinetic energy to the wave, thereby amplifying the wave. The net result is to amplify the input signal by a factor of about 100,000. After the electrons have passed along the helix, they impinge on electrodes in a collector. The collector decelerates the electrons in such a manner as to recover most of the remaining kinetic energy and thereby significantly increase the power efficiency of the TWT.
Krawczyk, Richard↗