Search NASA⌕ Search

Engineering topics

Wilson, L.

Publications and source records attributed to Wilson, L..

At least 37 records · Page 2

Mode of emplacement of lunar mare volcanic deposits: Graben formation due to near surface deformation accompanying dike emplacement at Rima Parry 5

Theoretical analyses, together with the observed style of emplacement of lunar mare volcanic deposits, strongly suggest that mare volcanic eruptions are fed by dikes from source regions at the base of the crust or deeper in the lunar mantle. Some dikes intrude into the lower crust, while others penetrate to the surface and are the sources for voluminous outpourings of lava. Still others stall near the surface generating a near-surface extensional stress field. We have investigated the hypothesis that some lunar linear rilles (graben) are the near-surface manifestations of dikes intruded to shallow depths. For a specific example (Rima Parry 5), we show that the geometry of the faults implies a mean dike width of about 150 m and depth to the dike top of about 500 m, values consistent with other theoretical and observational data on lunar dike geometry. Localized pyroclastic deposits along Rima Parry 5 are evidence for the presence of near-surface magma, and are interpreted to be the result of degassing and pyroclastic eruption subsequent to the emplacement of the dike.

Head, J. W.↗

Lava flow-field morphological classification and interpretation: Examples from Venus

Recent analyses suggest that thermal constraints will act to limit the maximum length of an advancing lava flow being fed at a given volume or mass effusion rate from a vent. These constraints can be characterized through the Gratz number, which has a large value at the vent and decreases down flow; under a wide range of conditions, motion apparently ceases when the Gratz number has decreased to a value close to 300. In cooling-limited flows, effusion from the vent should be steady; the flow front thickens, eventually stops due to this cooling, and the central channel does not drain. If the vent remains active, a break-out flow will form from some point on the margin of the initial flow unit. If flows on planetary surfaces can be shown to be cooling limited, eruption rates can be estimated. In this analysis, we illustrate the morphological characteristics of various flow configurations, and we describe the application of these concepts to a flow length histogram for a hypothetical flow field and then apply this to an example on Venus.

Head, J. W.↗

Thermal and rheological controls on magma migration in dikes: Examples from the east rift zone of Kilauea volcano, Hawaii

Long-lived eruptions from basaltic volcanoes involving episodic or steady activity indicate that a delicate balance has been struck between the rate of magma cooling in the dike system feeding the vent and the rate of magma supply to the dike system from a reservoir. We describe some key factors, involving the relationships between magma temperature, magma rheology, and dike geometry that control the nature of such eruptions.

Parfitt, E. A.↗

Formation of perched lava ponds on basaltic volcanoes: Interaction between cooling rate and flow geometry allows estimation of lava effusion rates

Perched lava ponds are infrequent but distinctive topographic features formed during some basaltic eruptions. Two such ponds, each approximately 150 m in diameter, formed during the 1968 eruption at Napau Crater and the 1974 eruption of Mauna Ulu, both on Kilauea Volcano, Hawaii. Each one formed where a channelized, high volume flux lava flow encountered a sharp reduction of slope: the flow spread out radially and stalled, forming a well-defined terminal levee enclosing a nearly circular lava pond. We describe a model of how cooling limits the motion of lava spreading radially into a pond and compare this with the case of a channelized flow. The difference in geometry has a major effect, such that the size of a pond is a good indicator of the volume flux of the lava forming it. Lateral spreading on distal shallow slopes is a major factor limiting the lengths of lava flows.

Wilson, L.↗

A classification scheme for the morphology of lava flow fields

Analysis of the processes controlling the advance of lava flows shows that, if no other factors intervene, thermal constraints will act to limit the maximum length of a flow being fed at a given volume or mass effusion rate from a vent. These constraints can be characterized through the Gratz number, which takes on a large value at the vent and decreases down flow. Early application of this principle showed that, despite the many subtleties of modes of heat loss from flows, motion apparently ceases when the Gratz number has decreased to a value close to 300. Recent analyses of flow units from the 1983-86 Pu'u 'O'o eruption of Kilauea and of other, more silicic lava flow units confirm this finding.

Wilson, L.↗

Factors controlling the structures of magma chambers in basaltic volcanoes

The depths, vertical extents, and lateral extents of magma chambers and their formation are discussed. The depth to the center of a magma chamber is most probably determined by the density structure of the lithosphere; this process is explained. It is commonly assumed that magma chambers grow until the stress on the roof, floor, and side-wall boundaries exceed the strength of the wall rocks. Attempts to grow further lead to dike propagation events which reduce the stresses below the critical values of rock failure. The tensile or compressive failure of the walls is discussed with respect to magma migration. The later growth of magma chambers is accomplished by lateral dike injection into the country rocks. The factors controlling the patterns of growth and cooling of such dikes are briefly mentioned.

Wilson, L.↗

Terrestrial analogs to lunar sinuous rilles - Kauhako Crater and channel, Kalaupapa, Molokai, and other Hawaiian lava conduit systems

Two source vents, one explosive and one effusive erupted to form a cinder cone and low lava shield that together compose the Kalaupapa peninsula of Molokai, Hawaii, A 50-100-m-wide channel/tube system extends 2.3 km northward from kauhako crater in the center of the shield. Based on modeling, a volume of up to about 0.2 cu km of lava erupted at a rate of 260 cu m/sec to flow through the Kauhako conduit system in one of the last eruptive episodes on the peninsula. Channel downcutting by thermal erosion occurred at a rate of about 10 micron/sec to help form the 30-m-deep conduit. Two smaller, secondary tube systems formed east of the main lava channel/tube. Several other lava conduit systems on the islands of Oahu and Hawaii were also compared to the Kauhako and lunar sinuous rille systems. These other lava conduits include Whittington, Kupaianaha, and Mauna Ulu lava tubes. Morphologically, the Hawaiian tube systems studied are very similar to lunar sinuous rilles in that they have deep head craters, sinuous channels, and gentle slopes. Thermal erosion is postulated to be an important factor in the formation of these terrestrial channel systems and by analogy is inferred to be an important process involved in the formation of lunar sinuous rilles.

Coombs, C. R.↗

Polygenic eruptions on Alba Patera, Mars

A new model for the evolution of the martian volcano Alba Patera is constructed. Numerous digitate channel networks on the flanks of the volcano are interpreted to be carved by sapping due to the release of nonjuvenile water from unconsolidated flank deposits. The particle size of these deposits is estimated to be 3-10 microns, which, together with theoretical modelling of the disperison of explosively derived volcanic materials, leads to the conclusion that the flank deposits on Alba Patera are low-relief pyroclastic flows. The recognition of numerous late-stage summit and subterminal lava flows thus makes Alba Patera a unique martian volcano that is transitional between the older pyroclastic-dominated highland paterae and the more recent effusive central-vent volcanoes such as the Tharsis Montes.

Mouginis-Mark, P. J.↗

Characteristics of Basaltic Lava Flows on Venus

Some ideas relating to the formation of lava flows on Venus are reviewed. The surface morphological features seen in the panoramic images made by the Venera 13 and 14 landers are examined in detail. The major element compositions measured by the Soviet probes indicate that the surface rocks at the Venera 13 site resemble a terrestrial tholeite composite whereas the Venera 14 rocks are similar to terrestrial alkali basalts. Few data exist on the rheological properties of such magma types on Earth; these properties are a strong function of magma volatile content, and there are important gaps in our knowledge of the typical volatiles to be associated with the magmas on Venus. However, the suggestion that Venusian magmas may be water poor together with consideration of the fact that the high Venusian surface temperatures may cause magmas to experience up to 50 K less cooling during their rise to the surface than corresponding terrestrial counterparts, leads to the finding that Venusian magmas may typically have plastic viscosities, E, up to a factor of three greater than terrestrial counterparts on eruption. A similar analysis of yield strength variations with temperature, magma composition and volatile content suggests that temperature will exert the main control and that Venusian magma yield strengths, Y, may be a factor of several times smaller than those of terrestrial equivalents.

Wilson, L.↗

Emplacement of Long Lava Flows on Mauna Loa (hawaii) and Alba (mars)

Spacecraft images revealed that extremely long lava flows (more than 200 km long) exist on the surface of Mars and Io. Compared to terrestial volcanic eruptions, the occurrence of these long flows is very unusual, and may hint at a different style of either magma production or eruption. Attempts to model the emplacement of the long flows on other planets, using a Bingham rheological model, were only partially successful. The objective is to conduct field measurements on long lava flows in Hawaii (where individual flows such as those of 1859 and 1881 exceed 40 km in length) in order to document and interpret their flow characteristics. In this way, a better understanding of the formation of long lava flows is sought as well as a determination of whether the Mauna Loa flows are terrestrial analogs to the long flows seen on Mars and Io.

Mouginismark, P. J.↗

Submarine Volcanic Eruptions and Potential Analogs for Venus

As part of an analysis program to better understand the diversity of volcanic processes on the terrestrial planets, an investigation of the volcanic landforms which exist on the Earth's ocean floor was initiated. In part, this analysis is focused toward gaining a better understanding of submarine volcanic landforms in their own right, but also it is hoped that these features may show similarities to volcanic landforms on Venus, due to the high ambient water (Earth) and atmospheric (Venus) pressures. A series of numerical modelling experiments was performed to investigate the relative importance of such attributes as water pressure and temperature on the eruption process, and to determine the rate of cooling and emplacement of lava flows in the submarine environment. Investigations to date show that the confining water pressure and the buoyancy effects of the surrounding water significantly affect the styles of volcanism on the ocean floor. In the case of Venusian volcanism, confining pressures will not be as great as that found at the ocean's abyssal plains, but nevertheless the general trend toward reducing magma vesiculation will hold true for Venus as well as the ocean floor. Furthermore, other analogs may also be found between submarine volcanism and Venusian activity.

Wilson, L.↗

Theoretical aspects of photoclinometric terrain profiling on the Galilean satellites

For large parts of the surfaces of the Galilean satellites there is no stereoscopic high resolution imagery, and so for shadow-free regions far from the terminator, the only method of obtaining topograpic information is photoclinometry, the technique of converting brightness variations into local surface tilts and hence into topographic profiles and contour maps. The conversion from brightness changes to slopes require knowledge of the angular photometric function for the type of planetary surface terrain being analyzed, i.e., the relationship describing the brightness of the surface as a function of the angles of incidence (I) and emergence (E) of light at a surface element. In order to investigate the effects of these changes on the shapes of topographic profiles deduced from the functions, an area of grooved terrain (lines 500-505, samples 550-650 on frame 20640.27 0060J2) using wide ranges of values of all the adjustable parameters in Hapke's new photometric function were analyzed.

Wilson, L.↗

Monitoring and queuing for sift

The SIFT instrumentation is called the "Window." This window was designed to collect internal data from SIFT while having minimal overhead. Window consists of Sender and Relay components. Sender is to be run on processors 0..5 and Relay will run on processor 6. Sender will gather values (currently 12) during the subframe allocated to a task and broadcast these values at the start of the next subframe. This timing was selected to guarantee Relay 3.2ms to collect and transmit the data.

Wilson, L.↗

A comparison of volcanic eruption processes on earth, moon, Mars, Io and Venus

The physical, chemical, and atmospheric characteristics of the silicate planets and satellites are surveyed in terms of their effects on the volcanic evolution of the surfaces of these bodies. The equations relating the parameters affecting magma ascent through the crust and eruption are analyzed, and three major types of eruption are characterized: effusive, steady explosive, and unsteady explosive. This analytical framework is then used to predict the nature of volcanic activity on each of the planets and satellites, and the predictions are compared with actual observations. Outstanding problems are discussed, with emphasis on the need for a general model of planetary interior dynamics applicable to bodies with varying degrees of interior viscosity, mantle activity, and lithospheric plate tectonics.

Wilson, L.↗

Explosive volcanism on Hecates Tholus, Mars - Investigation of eruption conditions

From a reexamination of the medium and high-resolution Viking images of Amazonian and Hesperian age volcanic centers on Mars, it is believed that an excellent example of well-preserved explosive activity does indeed exist close to the summit of Hecates Tholus. A mantled region to the west of the summit caldera is seen as an example of a geologically very recent plinian air fall ash deposit. Morphological evidence is presented for describing this as explosively generated material, and numerical models of magma ascent and eruption in the Martian environment are used to estimate the physical characteristics (eruption cloud height, magma discharge rate, magma volatile content, duration of activity, and vent size) for this event. Attention is also given to the implication of this eruptive style for the composition of the erupted magma.

Mouginis-Mark, P. J.↗

Magma vesiculation and pyroclastic volcanism on Venus

Theoretical consideration of the magma vesiculation process under observed and inferred venusian surface conditions suggests that vesicles should form in basaltic melts, especially if CO2 is the primary magmatic volatile. However, the high surface atmospheric pressure (about 90 bars) and density on Venus retard bubble coalescence and disruption sufficiently to make explosive volcanism unlikely. The products of explosive volcanism (fire fountains, convecting eruption clouds, pyroclastic flows, and topography-mantling deposits of ash, spatter, and scoria) should be rare on Venus, and effusive eruptions should dominate. The volume fraction of vesicles in basaltic rocks on Venus are predicted to be less than in chemically similar rocks on earth. Detection of pyroclastic landforms or eruption products on Venus would indicate either abnormally high volatile contents of Venus magmas (2.5-4 wt%) or different environmental conditions (e.g., lower atmospheric pressure) in previous geologic history.

Garvin, J. B.↗

Ascent and eruption of basaltic magma on the earth and moon

The ascent and emplacement of basaltic magma on the earth and moon is modeled by the application of geological and physical observations and constraints. Relatively simple mathematical models of the motion of gas/liquid mixtures are shown to be adequate in the treatment of basaltic eruptions, provided that allowance is made for the coalescence of gas bubbles and that realistic geological and petrochemical constraints are applied to the numerical values of variables. Because gas exsolution from magmas on the earth and moon commonly occur at depths of less than 2 km, it is generally convenient to consider separately the rise of bubble-free magmatic liquid at depth in a planetary crust and the more complex motions occurring near the surface with gas exsolution.

Wilson, L.↗