High altitude test program for a Mars subsonic parachute
This paper describes one method by which an Earth qualification test program for Mars parachute can be conducted.
Mars↗
Engineering topics
Witkowski, A.
Publications and source records attributed to Witkowski, A..
Mars Exploration Rover parachute decelerator system program review
In the Mars Exploration Rover (MER) Mission, NASA returns to the red planet, following the extremely successful Mars Pathfinder in 1997. The mission will send two lander-rovers to the surface of Mars with separate launches in May and June, 2003. This paper describes the Parachute Decelerator System for the entry vehicle.
Mars Exploration Rover MER parachute decelerator s↗
Opening Loads Analyses for Various Disk-Gap-Band Parachutes
Detailed opening loads data is presented for 18 tests of Disk-Gap-Band (DGB) parachutes of varying geometry with nominal diameters ranging from 43.2 to 50.1 ft. All of the test parachutes were deployed from a mortar. Six of these tests were conducted via drop testing with drop test vehicles weighing approximately 3,000 or 8,000 lb. Twelve tests were conducted in the National Full-Scale Aerodynamics Complex 80- by 120-foot wind tunnel at the NASA Ames Research Center. The purpose of these tests was to structurally qualify the parachute for the Mars Exploration Rover mission. A key requirement of all tests was that peak parachute load had to be reached at full inflation to more closely simulate the load profile encountered during operation at Mars. Peak loads measured during the tests were in the range from 12,889 to 30,027 lb. Of the two test methods, the wind tunnel tests yielded more accurate and repeatable data. Application of an apparent mass model to the opening loads data yielded insights into the nature of these loads. Although the apparent mass model could reconstruct specific tests with reasonable accuracy, the use of this model for predictive analyses was not accurate enough to set test conditions for either the drop or wind tunnel tests. A simpler empirical model was found to be suitable for predicting opening loads for the wind tunnel tests to a satisfactory level of accuracy. However, this simple empirical model is not applicable to the drop tests.
Cruz, J. R.↗