Skip to content

Engineering topics

Wohlwend, Jennifer L.

Publications and source records attributed to Wohlwend, Jennifer L..

28 records · Page 2

All sources NASA NTRS DOE OSTI

DOE OSTI2023

Performance Assessment for the E-Area Low-Level Radioactive Waste Disposal Facility at the Savannah River Site: Appendix F

As a supplement to Chapter 6, Section 6.1.1.3, Table F-1 through Table F-24 provide tabular results of the sensitivity analysis calculations for waste disposal timing (Sensitivity Case S6) in NR07E (Cases 3 and 4) and NR26E (Cases 1 through 4). The title of each table identifies the DU, sensitivity case, and performance measure. Section F.1.1 (Table F-1 through Table F-8) presents results for NR07E and Section F.1.2 (Table F-9 through Table F-24) presents results for NR26E. In each table, radionuclides are sorted from highest to lowest nominal concentration or dose factor. Nominal values are when waste disposal occurs at the start of operations; timeline values are when waste disposal occurs at the end of operations. The differences (Δ values) in the last column of each table equal the timeline concentration or dose factor minus the nominal concentration or dose factor, where DF and CF are shorthand designations for dose factor and concentration factor, respectively.

12 MANAGEMENT OF RADIOACTIVE AND NON-RADIOACTIVE W↗

DOE OSTI2023

Performance Assessment for the E-Area Low-Level Radioactive Waste Disposal Facility at the Savannah River Site: Appendix G

This appendix contains supporting information and key data used during the IHI analysis, including the following: • A list of parent radionuclides requiring IHI inventory limits (Section G.1) • Tables of IHI acute and chronic dose factors, inventory limits, and concentration limits for all DUs (Section G.2) • IHI acute and chronic dose history time profiles for all DUs (Section G.3)

12 MANAGEMENT OF RADIOACTIVE AND NON-RADIOACTIVE W↗

DOE OSTI2023

Performance Assessment for the E-Area Low-Level Radioactive Waste Disposal Facility at the Savannah River Site: Appendix H

This section provides supporting material for the development of DU-specific final inventory limits for the GW pathways for every generic waste form and SWF parent radionuclide requiring an inventory limit. The final inventory limits are based on nominal PA transport simulations using PORFLOW as reported in Chapter 5. The nominal PA settings represent the compliance case where some modeling parameter settings are defined based on conservative (pessimistically leaning) arguments. In the overall computational approach employed in this PA, a multitiered radionuclide screening process is adopted as discussed in Chapter 2, Section 2.3.7. In the multitiered process, the initial list of 1,252 parent radionuclides is shortened substantially using conservative, but simple, transport models, along with a reasonably low cutoff criterion of 0.1% SOF value. Multidimensional PORFLOW flow and transport modeling is employed for every parent radionuclide that failed the GW screening. The generic waste form limits represent Tier-3 analyses, while Tier-4 analyses are employed for SWF limits, where warranted.

12 MANAGEMENT OF RADIOACTIVE AND NON-RADIOACTIVE W↗

DOE OSTI2023

Performance Assessment for the E-Area Low-Level Radioactive Waste Disposal Facility at the Savannah River Site: Appendix I

As stated in Section 9.1.2.2, a final inventory of parent radionuclides is projected for every DU at the time of facility operational closure in 2065. These final closure inventories are upper-bound estimates wherein each DU is assumed to reach its activity capacity. Composition vectors based on existing DU inventories are employed to estimate the final compositions of all existing and future DUs. Specifically, (1) the existing DU compositions are assumed to remain constant; (2) future DUs are assigned averaged existing compositions based on appropriately averaged DUs. This information is detailed in Appendix H, Section H.7. In addition, the variability in composition among existing DUs is used to generate log-normal distributions for uncertainty quantification, which is detailed in Section I.1.1.

12 MANAGEMENT OF RADIOACTIVE AND NON-RADIOACTIVE W↗

DOE OSTI2022

Permanent Foam Fixatives for Radioactive Contamination Control: Environmental Chamber Testing

The Department of Energy (DOE) Office of Environmental Management (EM) is tasked with closing cleanup sites throughout the DOE-EM complex. A major component of successfully closing the sites is the deactivation and decommissioning (D&D) of radioactively contaminated buildings in nuclear facilities. Deactivation consists of the process of placing a contaminated facility in stable condition in order to minimize any risks that could affect workers, the public, and the environment. Successful deactivation and decommissioning consists of leaving the buildings in an agreed upon end state to provide future protection against hazards. Hazards include radiation but can also include asbestos, polychlorinated biphenyls, and other environmental and physical hazards.

12 MANAGEMENT OF RADIOACTIVE AND NON-RADIOACTIVE W↗

DOE OSTI2022

Radiation Hardened Foam Cold Test Plan – Phase-I: Foam Adhesion, Contamination Fixation, Moisture Stresses, Pipe Cutting, and Thermal Profile Testing

This document outlines the Phase-I test objectives and implementation plan for a down-selective foam fixative technology intended to facilitate activities in support of the Savannah River Site (SRS) F/H labs deactivation and decommissioning (D&D) efforts. It is a collaborative effort between Savannah River National Laboratory (SRNL), Florida International University (FIU), and the SRS F/H labs team intended to test and evaluate the potential of an intumescent, fire-retardant foam in mitigating the release of contamination during dismantling operations on radioactively contaminated piping in legacy facilities. The cold test plan addresses specific requirements highlighted by site and safety personnel and will be executed in FIU’s Outdoor Test and Evaluation Facility using a mock-up that replicates the operational conditions at the proposed hot test location at F/H labs. Results from the cold test plan will inform the hot test at F/H labs, which will use the foam fixative to confine and/or isolate residual contamination within a 3-dimensional void space of Hastelloy C-22 piping designated for removal from the site and transported to a proper disposal facility. Phase-I testing will address eight test objectives: (1) evaluation of the adhesion and bonding properties of foam fixative in piping, (2) evaluation of the adhesion of the foam fixative in piping under varying moisture conditions, (3) determination of the heat profile of the foam fixative during curing, (4) determination of the relationship between pipe diameter and foam fixative quantity, (5) determination of the internal pipe pressure after foam deployment and curing, (6) development of a leak test standard operating procedure to test for the effectiveness of the foam plug, (7) initiation of a literature review to determine if using a hot tap is a viable method to deliver foam into piping, and (8) initiation of a 10-foot mock up test that will be used in Phase-II cold testing. The cold test will be conducted at FIU and all testing activities will comply with SRNL Conduct of R&D Protocols (SRNL-IM-2020-00019).

12 MANAGEMENT OF RADIOACTIVE AND NON-RADIOACTIVE W↗

DOE OSTI2020

GoldSim E-Area Low-Level Waste Facility Aquifer Zone Model Calibration Methodology

This report documents the development and calibration of the E-Area Low-Level Waste Facility (ELLWF) Gold Sim aquifer model. It provides a methodology on how a Gold Sim aquifer model can be calibrated to specific PORFLOW-based aquifer predictions. The calibration activity presented within this report focuses on the Slit Trench #06 (ST06) location that resides within the center set of Slit Trenches. This Gold Sim-based aquifer model is a generic model capable of being calibrated to any of the other trench locations within E-Area. In addition, subsequent activities (beyond the scope of this effort) will couple this GoldSim-based aquifer model to various GoldSim-based trench models, with the intent of performing stochastic analyses that couple all pertinent fate and transport processes from the ground surface up to the 100-m point of assessment (POA).

12 MANAGEMENT OF RADIOACTIVE AND NON-RADIOACTIVE W↗

DOE OSTI2020

GoldSim E-Area Low-Level Waste Lacility Vadose Zone Model Benchmarking

This report documents the development and benchmarking of the E-Area Low-Level Waste Facility (ELLWF) GoldSim Engineered and Slit Trench (ET and ST) vadose zone models. Subsequent activities (beyond the scope of this effort) will couple the GoldSim-based vadose zone models to the GoldSim aquifer model, with the intent of performing stochastic analyses that couple all pertinent fate and transport processes from the ground surface up to the 100-m Point of Assessment (POA). The benchmarking presented within this report focuses on the Slit Trench 06 (ST06) bydrostratigraphic location that resides within the center set of slit trenches. These GoldSim-based vadose zone models are generic models capable of being benchmarked to any of the other trench locations within E-Area.

12 MANAGEMENT OF RADIOACTIVE AND NON-RADIOACTIVE W↗

DOE OSTI2020

E-Area Low-Level Waste Facility GoldSim System Model

This report documents the development of the E-Area Low-Level Waste Facility (ELLWF) trench system model. The GoldSim® Monte Carlo simulation software is utilized to model the release and transport of radiological inventory disposed (both currently and in the future) within Engineered and Slit Trenches. This model is in support of the sensitivity and uncertainty analysis for the ELLWF Performance Assessment. The ELLWF system model utilizes a hybrid-approach to accurately describe the disposal system. The Hydrologic Evaluation of Landfill Performance model provides the infiltration data to both PORFLOW and GoldSim. PORFLOW is used to calibrate the GoldSim model to ensure confidence in the stochastic results. Finally, the concentrations from GoldSim transport simulations are fed into the SRNL Dose Toolkit to calculate dose impacts and assess plume interaction

12 MANAGEMENT OF RADIOACTIVE AND NON-RADIOACTIVE W↗

DOE OSTI2020

FY2019 Performance Assessment Annual Review for the E-Area Low-Level Waste Facility

The Savannah River Site (SRS) E-Area Low-Level Waste Facility (ELLWF) consists of six types of disposal units described in the Performance Assessment (PA) (WSRC, 2008): Low Activity Waste Vault (LAWV), Intermediate Level Vault (ILV), Trenches [Slit Trenches (STs), Engineered Trenches (ETs), and Component-in-Grout (CIG) Trenches], and Naval Reactor Component Disposal Areas (NRCDAs). The ELLWF is a part of the Solid Waste Management Facility (SWMF). SWMF is managed and operated by the SRS Management and Operations prime contractor, Savannah River Nuclear Solutions (SRNS). Within SRNS, the Solid Waste Management (SWM) organization is responsible for operating the SWMF, and the Savannah River National Laboratory (SRNL) is the technical agency responsible for preparing and maintaining the PA. SWMF operations have been performed at SRS since 1952. The mission of the SWMF is to provide storage, processing, disposal, and shipment of radioactive, hazardous, and mixed waste. The SWMF is committed to treat, store, and dispose of these waste products in a manner that protects the environment and the health and safety of the facility worker, the co-located worker, and the offsite general public. Wastes handled in the SWMF include low level waste, transuranic waste, hazardous waste, Toxic Substances Control Act waste, and mixed waste (containing both hazardous and radioactive constituents).

12 MANAGEMENT OF RADIOACTIVE AND NON-RADIOACTIVE W↗