Engineering topics
Publications and source records attributed to Wong, T. C..
The two-dimensional flow over a blunt leading-edge plate is simulated on the basis of an Euler/Navier-Stokes zonal scheme. The scheme uses an implicit upwind finite-volume scheme, which is based on the van Leer flux-vector splitting. It is shown that the Euler/Navier-Stokes zonal scheme with downstream boundary-layer compatibility conditions is accurate and efficient.
Approximate solutions for potential flow past an axisymmetric slender body and past a thin airfoil are calculated using a uniform perturbation method and then compared with either the exact analytical solution or the solution obtained using a purely numerical method. The perturbation method is based upon a representation of the disturbance flow as the superposition of singularities distributed entirely within the body, while the numerical (panel) method is based upon a distribution of singularities on the surface of the body. It is found that the perturbation method provides very good results for small values of the slenderness ratio and for small angles of attack. Moreover, for comparable accuracy, the perturbation method is simpler to implement, requires less computer memory, and generally uses less computation time than the panel method. In particular, the uniform perturbation method yields good resolution near the regions of the leading and trailing edges where other methods fail or require special attention.
The aerodynamic characteristics of potential flow past an axisymmetric slender body and a thin airfoil are calculated using a uniform perturbation analysis method. The method is based on the superposition of potentials of point singularities distributed inside the body. The strength distribution satisfies a linear integral equation by enforcing the flow tangency condition on the surface of the body. The complete uniform asymptotic expansion of its solution is obtained with respect to the slenderness ratio by modifying and adapting an existing technique. Results calculated by the perturbation analysis method are compared with the existing surface singularity panel method and some available analytical solutions for a number of cases under identical conditions. From these comparisons, it is found that the perturbation analysis method can provide quite accurate results for bodies with small slenderness ratio. The present method is much simpler and requires less memory and computation time than existing surface singularity panel methods of comparable accuracy.