Engineering topics

Wood, S. C.

Publications and source records attributed to Wood, S. C..

4 records

NASA NTRS1974

Apollo 16 mission report. Supplement 2: Service Propulsion system final flight evaluation

The Apollo 16 Mission was the sixteenth in a series of flights using Apollo flight hardware and included the fifth lunar landing of the Apollo Program. The Apollo 16 Mission utilized CSM 113 which was equipped with SPS Engine S/N 66 (Injector S/N 137). The engine configuration and expected performance characteristics are presented. Since previous flight results of the SPS have consistently shown the existence of a negative mixture ratio shift, SPS Engine S/N 66 was reorificed to increase the mixture ratio for this mission. The propellant unbalance for the two major engine firings is compared with the predicted unbalance. Although the unbalance at the end of the TEI burn is significantly different than the predicted unbalance, the propellant mixture ratio was well within limits. The SPS performed six burns during the mission, with a total burn duration of 575.3 seconds. The ignition time, burn duration and velocity gain for each of the six SPS burns are reported.

Smith, R. J.↗

NASA NTRS1972

Apollo 15 mission report. Supplement 2: Service propulsion system final flight evaluation

The command and service module 112 service propulsion system performance for the Apollo 15 mission was evaluated and found to be satisfactory. The following items were considered: (1) the steady-state performance as determined from analysis of the third and eight burns; (2) techniques, problems, and assumptions; (3) flight analysis results as compared to the preflight predicted performance; (4) the propellant utilization and gaging system operation; (5) the pressurization system performance; (6) transient data; and (7) revision of estimated propellant consumption.

Smith, R. J.↗

NASA NTRS1972

Apollo 14 mission report. Supplement 5: Descent propulsion system final flight evaluation

The performance of the LM-8 descent propulsion system during the Apollo 14 mission was evaluated and found to be satisfactory. The average engine effective specific impulse was 0.1 second higher than predicted, but well within the predicted l sigma uncertainty. The engine performance corrected to standard inlet conditions for the FTP portion of the burn at 43 seconds after ignition was as follows: thrust, 9802, lbf; specific impulse, 304.1 sec; and propellant mixture ratio, 1603. These values are + or - 0.8, -0.06, and + or - 0.3 percent different respectively, from the values reported from engine acceptance tests and were within specification limits.

Avvenire, A. T.↗

NASA NTRS1972

Apollo 15 mission report, supplement 4: Descent propulsion system final flight evaluation

The results of a postflight analysis of the LM-10 Descent Propulsion System (DPS) during the Apollo 15 Mission are reported. The analysis determined the steady state performance of the DPS during the descent phase of the manned lunar landing. Flight measurement discrepancies are discussed. Simulated throttle performance results are cited along with overall performance results. Evaluations of the propellant quantity gaging system, propellant loading, pressurization system, and engine are reported. Graphic illustrations of the evaluations are included.

Avvenire, A. T.↗