Search NASA⌕ Search

Engineering topics

Wu, Feng

Publications and source records attributed to Wu, Feng.

86 records · Page 5

Organic-Acid-Assisted Fabrication of Low-Cost Li-Rich Cathode Material (Li[Li1/6Fe1/6Ni1/6Mn1/2]O-2) for Lithium-Ion Battery

A novel Li-rich cathode Li[Li1/6Fe1/6Ni1/6Mn1/2]O-2 (0.4Li(2)MnO(3-)0.6LiFe(1/3)Ni(1/3)Mn(1/3)O(2)) was synthesized by a solgel method, which uses citric acid (SC), tartaric acid (ST), or adipic acid (SA) as a chelating agent. The structural, morphological, and electrochemical properties of the prepared samples were characterized by various methods. X-ray diffraction showed that single-phase materials are formed mainly with typical alpha-NaFeO2 layered structure (R3 m), and the SC sample has the lowest Li/Ni cation disorder. The morphological study indicated homogeneous primary particles in good distribution size (100 nm) with small aggregates. The Fe, Ni, and Mn valences were determined by X-ray absorption near-edge structure analysis. In coin cell tests, the initial reversible discharge capacity of an SA electrode was 289.7 mAh g(-1) at the 0.1C rate in the 1.54.8 V voltage range, while an SC electrode showed a better cycling stability with relatively high capacity retention. At the 2C rate, the SC electrode can deliver a discharge capacity of 150 mAh g(-1) after 50 cycles. Differential capacity vs voltage curves were employed to further investigate the electrochemical reactions and the structural change process during cycling. This low-cost, Fe-based compound prepared by the solgel method has the potential to be used as the high capacity cathode material for Liion batteries.

cathode↗

Atom probe tomography studies of Al₂O₃ gate dielectrics on GaN

Atom probe tomography was used to achieve three-dimensional characterization of in situ Al₂O₃/GaN structures grown by metal organic chemical vapor deposition (MOCVD). Al₂O₃ dielectrics grown at three different temperatures of 700, 900, and 1000 °C were analyzed and compared. A low temperature GaN cap layer grown atop Al₂O₃ enabled a high success rate in the atom probe experiments. The Al₂O₃/GaN interfaces were found to be intermixed with Ga, N, and O over the distance of a few nm. Impurity measurements data showed that the 1000 °C sample contains higher amounts of C (4 × 10¹⁹/cm³) and lower amounts of H (7 × 10¹⁹/cm³), whereas the 700 °C sample exhibits lower C impurities (<10¹⁷/cm³) and higher H incorporation (2.2 × 10²⁰/cm³). On comparing with Al₂O₃ grown by atomic layer deposition (ALD), it was found that the MOCVD Al₂O₃/GaN interface is comparatively abrupt. Scanning transmission electron microscopy data showed that the 900 °C and 1000 °C MOCVD films exhibit polycrystalline nature, while the ALD films were found to be amorphous.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

Synthesis-Microstructure-Performance Relationship of Layered Transition Metal Oxides as Cathode for Rechargeable Sodium Batteries Prepared by High-Temperature Calcination

Research on sodium batteries has made a comeback because of concern regarding the limited resources and cost of lithium for Li-ion batteries. From the standpoint of electrochemistry and economics, Mn- or Fe-based layered transition metal oxides should be the most suitable cathode candidates for affordable sodium batteries. Herein, this paper reports a novel cathode material, layered Na 1+x (Fe y/2 Ni y/2 Mn 1–y ) 1–x O 2 (x = 0.1–0.5), synthesized through a facile coprecipitation process combined with subsequent calcination. For such cathode material calcined at 800 °C for 20 h, the Na/Na 1+x (Fe y/2 Ni y/2 Mn 1–y ) 1–x O 2 (x = 0.4) electrode exhibited a good capacity of 99.1 mAh g –1 (cycled at 1.5–4.0 V) and capacity retention over 87% after 50 cycles. Optimization of this material would make layered transition metal oxides a strong candidate for the Na-ion battery cathode.

25 ENERGY STORAGE↗

Systematic investigation on topological properties of layered GaS and GaSe under strain

The topological properties of layered β-GaS and ε-GaSe under strain are systematically investigated by ab initio calculations with the electronic exchange-correlation interactions treated beyond the generalized gradient approximation (GGA). Based on the GW method and the Tran-Blaha modified Becke-Johnson potential approach, we find that while ε-GaSe can be strain-engineered to become a topological insulator, β-GaS remains a trivial one even under strong strain, which is different from the prediction based on GGA. The reliability of the fixed volume assumption rooted in nearly all the previous calculations is discussed. By comparing to strain calculations with optimized inter-layer distance, we find that the fixed volume assumption is qualitatively valid for β-GaS and ε-GaSe, but there are quantitative differences between the results from the fixed volume treatment and those from more realistic treatments. This work indicates that it is risky to use theoretical approaches like GGA that suffer from the band gap problem to address physical properties, including, in particular, the topological nature of band structures, for which the band gap plays a crucial role. In the latter case, careful calibration against more reliable methods like the GW approach is strongly recommended.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

High-electron-mobility GaN grown on free-standing GaN templates by ammonia-based molecular beam epitaxy

The dependence of electron mobility on growth conditions and threading dislocation density (TDD) was studied for n{sup −}-GaN layers grown by ammonia-based molecular beam epitaxy. Electron mobility was found to strongly depend on TDD, growth temperature, and Si-doping concentration. Temperature-dependent Hall data were fit to established transport and charge-balance equations. Dislocation scattering was analyzed over a wide range of TDDs (∼2 × 10{sup 6} cm{sup −2} to ∼2 × 10{sup 10} cm{sup −2}) on GaN films grown under similar conditions. A correlation between TDD and fitted acceptor states was observed, corresponding to an acceptor state for almost every c lattice translation along each threading dislocation. Optimized GaN growth on free-standing GaN templates with a low TDD (∼2 × 10{sup 6} cm{sup −2}) resulted in electron mobilities of 1265 cm{sup 2}/Vs at 296 K and 3327 cm{sup 2}/Vs at 113 K.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

Stacking faults and interface roughening in semipolar (202{sup ¯}1{sup ¯}) single InGaN quantum wells for long wavelength emission

The microstructure of InGaN single quantum wells (QWs) grown in semipolar (202{sup ¯}1{sup ¯}) orientation on GaN substrates was studied by transmission electron microscopy. Stress relaxation in the lattice mismatch In{sub x}Ga{sub 1−x}N layer was realized by forming partial misfit dislocations associated with basal plane stacking faults (BPSFs). For given composition x = 0.24, BPSFs formation was observed when the QW thickness exceeded 4 nm. The high density of partial threading dislocations that bound the BPSFs is detrimental to light-emitting device performance. Interface roughening (faceting) was observed for both upper and lower QW interfaces (more pronounced for upper interface) and was found to increase with the thickness of the QW. BPSFs had a tendency to nucleate at roughened interface valleys.

36 MATERIALS SCIENCE↗

Elimination of columnar microstructure in N-face InAlN, lattice-matched to GaN, grown by plasma-assisted molecular beam epitaxy in the N-rich regime

The microstructure of N-face InAlN layers, lattice-matched to GaN, was investigated by scanning transmission electron microscopy and atom probe tomography. These layers were grown by plasma-assisted molecular beam epitaxy (PAMBE) in the N-rich regime. Microstructural analysis shows an absence of the lateral composition modulation that was previously observed in InAlN films grown by PAMBE. A room temperature two-dimensional electron gas (2DEG) mobility of 1100 cm{sup 2}/V s and 2DEG sheet charge density of 1.9 × 10{sup 13} cm{sup −2} was measured for N-face GaN/AlN/GaN/InAlN high-electron-mobility transistors with lattice-matched InAlN back barriers.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

Observation of columnar microstructure in lattice-matched InAlN/GaN grown by plasma assisted molecular beam epitaxy

Nominally lattice matched InAlN/GaN was grown by plasma-assisted molecular beam epitaxy, and the intrinsic microstructure was investigated via x-ray diffraction, transmission electron microscopy, and atom probe tomography. The InAlN showed a cellular structure, which was comprised of ~10 nm wide Al-rich cores and ~1 nm In-rich InAlN intercellular boundaries. Despite the strong laterally non-uniform In distribution, both vertical and lateral lattices are unperturbed by the cellular structure, as evidenced by strong thickness fringes in on-axis ω-2θ high resolution x-ray diffraction scans, coherence lengths derived from on-axis (0002) and off-axis (10{anti 1}2) ω-2θ high resolution x-ray diffraction scans, and a modified Williamson-Hall analysis for on-axis reflections.

36 MATERIALS SCIENCE↗

Polarity inversion of N-face GaN using an aluminum oxide interlayer

The polarity of GaN grown by plasma-assisted molecular beam epitaxy was inverted from N-face to Ga-face by inserting a composite AlN/aluminum oxide (AlO{sub x}) interlayer structure at the inversion interface. The change in polarity was verified in situ by reflection high energy electron diffraction via intensity transients and postgrowth surface reconstructions, and ex situ by convergent beam electron diffraction and etch studies in an aqueous potassium hydroxide solution. The inverted materials showed smooth surfaces and good electrical properties. AlGaN/GaN high electron mobility transistors fabricated on the inverted epilayers showed good dc and high frequency performance. A current-gain cutoff frequency (f{sub T}) of 21 GHz and maximum oscillation frequency (f{sub max}) of 61 GHz were measured in devices with a gate length of 0.7 {mu}m. These data compare favorably to those of Ga-face AlGaN/GaN devices with a similar structure grown on Si-face SiC substrates.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

Ultralow nonalloyed Ohmic contact resistance to self aligned N-polar GaN high electron mobility transistors by In(Ga)N regrowth

Ultralow Ohmic contact resistance and a self-aligned device structure are necessary to reduce the effect of parasitic elements and obtain higher f{sub t} and f{sub max} in high electron mobility transistors (HEMTs). N-polar (0001) GaN HEMTs, offer a natural advantage over Ga-polar HEMTs, in terms of contact resistance since the contact is not made through a high band gap material [Al(Ga)N]. In this work, we extend the advantage by making use of polarization induced three-dimensional electron-gas through regrowth of graded InGaN and thin InN cap in the contact regions by plasma (molecular beam epitaxy), to obtain an ultralow Ohmic contact resistance of 27 OMEGA mum to a GaN 2DEG.

36 MATERIALS SCIENCE↗

Evaluation of threading dislocation densities in In- and N-face InN

The threading dislocation (TD) structure and density has been studied in In- and N-face InN films grown on GaN by plasma-assisted molecular beam epitaxy. The TD densities were determined by nondestructive x-ray diffraction rocking curve measurements in on-axis symmetric and off-axis skew symmetric geometries and calibrated by transmission electron microscopy measurements. TD densities were dominated by edge-type TDs with screw-component TDs accounting for less than 10% of the total TD density. A significant decrease in edge-type TD density was observed for In-face InN films grown at increasingly higher substrate temperatures. In-face InN films grown with excess In exhibited lower TD densities compared to films grown under N-rich conditions. The edge-type TD density of N-face InN films was independent of substrate temperature due to the higher allowable growth temperatures for N-face InN compared to In-face InN. TD densities in In-face InN also showed a strong dependence on film thickness. Films grown at a thickness of less than 1 {mu}m had higher TD densities compared with films grown thicker than 1 {mu}m. The lowest measured TD density for an In-face InN film was {approx}1.5x10{sup 10}/cm{sup 2} for 1 {mu}m thick films.

36 MATERIALS SCIENCE↗

The action of a dietary retinoid on gene expression and cancer induction in electron-irradiated rat skin

Current models of radiation carcinogenesis generally assume that the DNA is damaged in a variety of ways by the radiation and that subsequent cell divisions contribute to the conversion of the damage to heritable mutations. Cancer may seem complex and intractable, but its complexity provides multiple opportunities for preventive interventions. Mitotic inhibitors are among the strongest cancer preventive agents, not only slowing the growth rate of preneoplasias but also increasing the fidelity of DNA repair processes. Ionizing radiation, including electrons, is a strong inducer of cancer in rat skin, and dietary retinoids have shown potent cancer preventive activity in the same system. A non-toxic dietary dose of retinyl acetate altered gene expression levels 24 hours after electron irradiation of rat skin. Of the 8740 genes on an Affymetrix rat expression array, the radiation significantly (5 fold or higher) altered 188, while the retinoid altered 231, including 16 radiation-altered genes that were reversely altered. While radiation strongly affected the expression of stress response, immune/inflammation and nucleic acid metabolism genes, the retinoid most strongly affected proliferation-related genes, including some significant reversals, such as, keratin 14, retinol binding protein, and calcium binding proteins. These results point to reversal of proliferation-relevant genes as a likely basis for the anti-radiogenic effects of dietary retinyl acetate.

Non-NASA Center↗