Search NASA⌕ Search

Engineering topics

Wu, N. Eva

Publications and source records attributed to Wu, N. Eva.

13 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS2002

Linear Parameter Varying Control for Actuator Failure

A robust linear parameter varying (LPV) control synthesis is carried out for an HiMAT vehicle subject to loss of control effectiveness. The scheduling parameter is selected to be a function of the estimates of the control effectiveness factors. The estimates are provided on-line by a two-stage Kalman estimator. The inherent conservatism of the LPV design is reducing through the use of a scaling factor on the uncertainty block that represents the estimation errors of the effectiveness factors. Simulations of the controlled system with the on-line estimator show that a superior fault-tolerance can be achieved.

Shin, Jong-Yeob↗
NASA NTRS2002

Control Reconfigurability of Linear Time-Invariant Systems

For any fault-tolerant control method to take effect, sufficient redundancy must exist in the plant (process) to be controlled. This paper is intended to establish a means of measuring the level of redundancy in connection with feedback control by borrowing the notion of the second-order modes. In particular, it is assumed that foreseeable faults of a process are parameterized in the model of the process. The smallest second-order mode is used as a measure of the potentiality of the process to maintain a certain performance through control reconfiguration at the occurrence of the worst faults over a prescribed set in the fault parameter space. This measure is called by the authors a control reconfigurability. The control reconfigurability is calculated for two process models to show its relevance to redundant actuating capabilities in the models.

Wu, N. Eva↗
NASA NTRS2002

Linear Parameter Varying Control Synthesis for Actuator Failure, Based on Estimated Parameter

The design of a linear parameter varying (LPV) controller for an aircraft at actuator failure cases is presented. The controller synthesis for actuator failure cases is formulated into linear matrix inequality (LMI) optimizations based on an estimated failure parameter with pre-defined estimation error bounds. The inherent conservatism of an LPV control synthesis methodology is reduced using a scaling factor on the uncertainty block which represents estimated parameter uncertainties. The fault parameter is estimated using the two-stage Kalman filter. The simulation results of the designed LPV controller for a HiMXT (Highly Maneuverable Aircraft Technology) vehicle with the on-line estimator show that the desired performance and robustness objectives are achieved for actuator failure cases.

Shin, Jong-Yeob↗
NASA NTRS2001

UNIPASS for AvSP? A Broader View

UNIPASS is a general-purpose probabilistic computer program consisting of three major modules, including preprocessor, solver and postprocessor. UNIPASS contains a user-friendly Graphical User Interface (GUI), numerous state-of-the-art probabilistic analysis techniques, a large library of statistical distributions and a function module with a large library of support functions that can easily define any complex limit-state function in a scripting FORTRAN-like syntax format. Its inverse probability analysis and sensitivities analysis capabilities make it a powerful design aid in any product cycle. Its precise numerical analysis engine is accurate enough to push the failure probabilities of a design to well below 10 (exp -50). UNIPASS is equipped with advanced artificial intelligence that is designed to handle systems with an essentially unlimited number of random variables with ease and efficiency. Its modular arrangement allows you to tailor an analysis to the desired level of accuracy and efficiency. The depth and comprehensiveness of UNIPASS are built upon the decades of experience and expertise of industry leaders including Boeing Aircraft, NASA and the DoD. Its rich content also makes UNIPASS a valuable instructional tool for random processes and probabilistic mechanics. The topics include: 1) Reliability in AvSP; 2) Role of UNIPASS in AvSP; and 3) Examples. This paper is in viewgraph form.

Wu, N. Eva↗
NASA NTRS2001

Reliability Analysis for AFTI-F16 SRFCS Using ASSIST and SURE

This paper reports the results of a study on reliability analysis of an AFTI-16 Self-Repairing Flight Control System (SRFCS) using software tools SURE (Semi-Markov Unreliability Range Evaluator and ASSIST (Abstract Semi-Markov Specification Interface to the SURE Tool). The purpose of the study is to investigate the potential utility of the software tools in the ongoing effort of the NASA Aviation Safety Program, where the class of systems must be extended beyond the originally intended serving class of electronic digital processors. The study concludes that SURE and ASSIST are applicable to reliability, analysis of flight control systems. They are especially efficient for sensitivity analysis that quantifies the dependence of system reliability on model parameters. The study also confirms an earlier finding on the dominant role of a parameter called a failure coverage. The paper will remark on issues related to the improvement of coverage and the optimization of redundancy level.

Wu, N. Eva↗
NASA NTRS2001

Reliability of Fault Tolerant Control Systems

This paper reports Part I of a two part effort, that is intended to delineate the relationship between reliability and fault tolerant control in a quantitative manner. Reliability analysis of fault-tolerant control systems is performed using Markov models. Reliability properties, peculiar to fault-tolerant control systems are emphasized. As a consequence, coverage of failures through redundancy management can be severely limited. It is shown that in the early life of a syi1ein composed of highly reliable subsystems, the reliability of the overall system is affine with respect to coverage, and inadequate coverage induces dominant single point failures. The utility of some existing software tools for assessing the reliability of fault tolerant control systems is also discussed. Coverage modeling is attempted in Part II in a way that captures its dependence on the control performance and on the diagnostic resolution.

Wu, N. Eva↗
NASA NTRS2000

Reliability of Fault Tolerant Control Systems

This paper reports Part II of a two part effort that is intended to delineate the relationship between reliability and fault tolerant control in a quantitative manner. Reliability properties peculiar to fault-tolerant control systems are emphasized, such as the presence of analytic redundancy in high proportion, the dependence of failures on control performance, and high risks associated with decisions in redundancy management due to multiple sources of uncertainties and sometimes large processing requirements. As a consequence, coverage of failures through redundancy management can be severely limited. The paper proposes to formulate the fault tolerant control problem as an optimization problem that maximizes coverage of failures through redundancy management. Coverage modeling is attempted in a way that captures its dependence on the control performance and on the diagnostic resolution. Under the proposed redundancy management policy, it is shown that an enhanced overall system reliability can be achieved with a control law of a superior robustness, with an estimator of a higher resolution, and with a control performance requirement of a lesser stringency.

Wu, N. Eva↗
NASA NTRS2000

A Decentralized Adaptive Approach to Fault Tolerant Flight Control

This paper briefly reports some results of our study on the application of a decentralized adaptive control approach to a 6 DOF nonlinear aircraft model. The simulation results showed the potential of using this approach to achieve fault tolerant control. Based on this observation and some analysis, the paper proposes a multiple channel adaptive control scheme that makes use of the functionally redundant actuating and sensing capabilities in the model, and explains how to implement the scheme to tolerate actuator and sensor failures. The conditions, under which the scheme is applicable, are stated in the paper.

Wu, N. Eva↗
NASA NTRS2000

Optimal Management of Redundant Control Authority for Fault Tolerance

This paper is intended to demonstrate the feasibility of a solution to a fault tolerant control problem. It explains, through a numerical example, the design and the operation of a novel scheme for fault tolerant control. The fundamental principle of the scheme was formalized in [5] based on the notion of normalized nonspecificity. The novelty lies with the use of a reliability criterion for redundancy management, and therefore leads to a high overall system reliability.

Wu, N. Eva↗
NASA NTRS2000

A Pulse-Compression Method for Process Monitoring

This paper describes, from a deterministic view point, an on-line process monitoring method for small signal behavior of time invariant stable systems at a given operating point. The monitoring is accomplished by using an consequence modulated low-pass wavelet as the probing signal, and a cyclic reference signal as the correlator. This method allows to achieve high resolution, high signal to noise ratio monitoring, and the acquired data can be used for on-line diagnosis.

Wu, N. Eva↗
NASA NTRS2000

Parametric Modeling and Fault Tolerant Control

Fault tolerant control is considered for a nonlinear aircraft model expressed as a linear parameter-varying system. By proper parameterization of foreseeable faults, the linear parameter-varying system can include fault effects as additional varying parameters. A recently developed technique in fault effect parameter estimation allows us to assume that estimates of the fault effect parameters are available on-line. Reconfigurability is calculated for this model with respect to the loss of control effectiveness to assess the potentiality of the model to tolerate such losses prior to control design. The control design is carried out by applying a polytopic method to the aircraft model. An error bound on fault effect parameter estimation is provided, within which the Lyapunov stability of the closed-loop system is robust. Our simulation results show that as long as the fault parameter estimates are sufficiently accurate, the polytopic controller can provide satisfactory fault-tolerance.

Wu, N. Eva↗