Engineering topics

Wukitch, S J

Publications and source records attributed to Wukitch, S J.

7 records

DOE OSTI2012

Measurements of ion cyclotron range of frequencies mode converted wave intensity with phase contrast imaging in Alcator C-Mod and comparison with full-wave simulations

Radio frequency waves in the ion cyclotron range of frequencies (ICRF) are widely used to heat tokamak plasmas. In ICRF heating schemes involving multiple ion species, the launched fast waves convert to ion cyclotron waves or ion Bernstein waves at the two-ion hybrid resonances. Mode converted waves are of interest as actuators to optimise plasma performance through current drive and flow drive. In order to describe these processes accurately in a realistic tokamak geometry, numerical simulations are essential, and it is important that these codes be validated against experiment. In this study, the mode converted waves were measured using a phase contrast imaging technique in D-H and D-{sup 3}He plasmas. The measured mode converted wave intensity in the D-{sup 3}He mode conversion regime was found to be a factor of {approx}50 weaker than the full-wave predictions. The discrepancy was reduced in the hydrogen minority heating regime, where mode conversion is weaker.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2012

Lower hybrid current drive at high density in the multi-pass regime

Assessing the performance of lower hybrid current drive (LHCD) at high density is critical for developing non-inductive current drive systems on future steady-state experiments. Excellent LHCD efficiency has been observed during fully non-inductive operation ({eta}=2.0-2.5 Multiplication-Sign 10{sup 19} AW{sup -1}m{sup -2} at n{sub e}=0.5 Multiplication-Sign 10{sup 20} m{sup -3}) on Alcator C-Mod [I. H. Hutchinson et al., Phys. Plasmas 1, 1511 (1994)] under conditions (n{sub e}, magnetic field and topology, and LHCD frequency) relevant to ITER [S. Shiraiwa et al., Nucl. Fusion 51, 103024 (2011)]. To extend these results to advanced tokamak regimes with higher bootstrap current fractions on C-Mod, it is necessary to increase n{sub e} to 1.0-1.5 Multiplication-Sign 10{sup 20} m{sup -3}. However, the number of current-carrying, non-thermal electrons generated by LHCD drops sharply in diverted configurations at densities that are well below the density limit previously observed on limited tokamaks. In these cases, changes in scrape off layer (SOL) ionization and density profiles are observed during LHCD, indicating that significant power is transferred from the LH waves to the SOL. Fokker-Planck simulations of these discharges utilizing ray tracing and full wave propagation codes indicate that LH waves in the high density, multi-pass absorption regime linger in the plasma edge, and SOL region, where absorption near or outside the LCFS results in the loss of current drive efficiency. Modeling predicts that non-thermal emission increases with stronger single-pass absorption. Experimental data show that increasing T{sub e} in high density LH discharges results in higher non-thermal electron emission, as predicted by the models.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2011

ICRF Mode Conversion Flow Drive Experiments on Alcator C-Mod

We have carried out a detailed study of the dependence of ICRF mode conversion flow drive (MCFD) on plasma and RF parameters. The flow drive efficiency is found to depend strongly on the {sup 3}He concentration in D({sup 3}He) plasmas, a key parameter separating the ICRF minority heating regime and mode conversion regime. At +90 deg. antenna phasing (waves in the co-I{sub p} direction) and dipole phasing, the driven flow is in the co-I{sub p} direction, and the change of the rotation velocity increases with both P{sub RF} and I{sub p}, and scales unfavorably vs. plasma density and antenna frequency. When MCFD is applied to I-mode plasmas, the plasma rotation increases until the onset of MHD modes triggered by large sawtooth crashes. Very high performance I-mode plasmas with H{sub ITER98,y2}{approx}1.4 and T{sub e0}{approx}8 keV have been obtained in these experiments.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

DOE OSTI2011

ICRF Mode Conversion Studies with Phase Contrast Imaging and Comparisons with Full-Wave Simulations

Waves in the ion cyclotron range of frequencies (ICRF) are widely used to heat toka-mak plasmas. In a multi-ion-species plasma, the FW converts to ion cyclotron waves (ICW) and ion Bernstein waves (IBW) around the ion-ion hybrid resonance (mode conversion). The mode converted wave is of interest as an actuator to optimise plasma performance through flow drive and current drive. Numerical simulations are essential to describe these processes accurately, and it is important that these simulation codes be validated. On Alcator C-Mod, direct measurements of the mode converted waves have been performed using Phase Contrast Imaging (PCI), which measures the line-integrated electron density fluctuations. The results were compared to full-wave simulations AORSA and TORIC. AORSA is coupled to a Fokker-Planck code CQL3D for self-consistent simulation of the wave electric field and the minority distribution function. The simulation results are compared to PCI measurements using synthetic diagnostic. The experiments were performed in D-H and D-{sup 3}He plasmas over a wide range of ion species concentrations. The simulations agreed well with the measurements in the strong absorption regime. However, the measured fluctuation intensity was smaller by 1-2 orders of magnitudes in the weakly abosorbing regime, and a realistic description of the plasma edge including dissipation and antenna geometry may be required in these cases.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2011

Fast-ions on Alcator C-Mod: Comparisons between Simulation and Experiment for Equilibrium and Evolving Distributions

Analysis of fast-ion distributions >100 T{sub e} is important for both ITER and a fusion reactor, as both will have a significant population of fusion-born alpha particles. Furthermore, energetic ions may display transport properties that differ from the bulk plasma. It is imperative to benchmark current simulation codes with measurements of highly energetic fast-ions on current devices. Experimental measurements of ICRF heated H-minority plasmas on Alcator C-Mod are performed with an upgraded Compact Neutral Particle Analyzer (CNPA). The CNPA consists of vertically-viewing photodiode detectors with viewing chords from r/a = {approx}0.18 to 0.6 and energies from 150 keV to 1.5 MeV. The CNPA measurements are compared to the output of a synthetic diagnostic that has been added to the Fokker-Planck solver CQL3D. CQL3D is coupled with the full-wave solver AORSA to evolve a self-consistent fast-ion distribution. Good agreement is obtained between simulation and experiment for fast ion distributions that are in steady-state (df/dt = 0). However, there are discrepancies between the experimental and simulated results for the time-dependent evolution of the fast-ion distribution. A possible explanation of the discrepancy is due to violation of certain assumptions of quasi-linear theory.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2011

Minority Ion Measurements During ICRF Experiments in Alcator C-Mod

ICRF is the primary auxiliary heating in C-Mod where both H or {sup 3}He minority and mode conversion regimes are utilized. For transport analysis, the power deposition profile is critical and measuring the resulting fast ion distribution provides a direct means to constrain and validate ICRF simulations used to calculate power deposition. In mode conversion, measurement of the minority ion density, temperature, and velocity profiles is critical for the wave physics and may provide some insight into the fundamental physics of flow drive. Using active charge exchange, the He{sup +1} 4686A or H 6563A line is observed to find whether fast ion and relevant thermal ion measurements are practical. Results of these experiments yield fast ion and thermal ion measurements in D(He). A new analysis technique to extract information from high noise fast ion spectra is developed. A development path for improved D({sup 3}He) and D(H) is indicated.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2011

Lower hybrid current drive in a high density diverted tokamak

Experimental observations of LHCD at high density (n-bar{sub e}>10{sup 20}m{approx}{sup 3}) on the Alcator C-Mod tokamak are presented in this paper. Bremsstrahlung emission from relativistic fast electrons in the core plasma drops sharply in single null discharges well below the density limit previously observed on limited tokamaks ({omega}/{omega}{sub LH}{approx}2). Modeling and experimental evidence suggest that the absence of LH driven fast electrons at high density may be due to collisional absorption in the scrape off layer. Experiments show that the expected current drive density dependence is recovered for inner wall limited discharges across the range of densities scanned (0.5x10{sup 20} m{sup -3}<n-bar{sub e}<1.5x10{sup 20} m{sup -3}). Increasing T{sub e} in the periphery of the plasma (0.8<r/a<1.0) also results in a modest increase in non-thermal electron emission at high n-bar{sub e}. Ray tracing/Fokker-Planck simulations of these discharges predict the observed sensitivity to plasma position when the effects of collisional absorption in the SOL are included in the model.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗