Search NASA⌕ Search

Engineering topics

Wykes, J. H.

Publications and source records attributed to Wykes, J. H..

9 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1983

Flight test and analyses of the B-1 structural mode control system at supersonic flight conditions

A practical structural mode control system (SMCS) that could be turned on at takeoff and be left on for the entire flight was demonstrated. The SMCS appears to be more effective in damping the key fuselage bending modes at supersonic speeds than at the design point of Mach 0.85 (for fixed gains). The SMCS has an adverse effect on high frequency symmetric modes; however, this adverse effect did not make the system unstable and does not appear to affect ride quality performance. The vertical ride quality analyses indicate that the basic configuration without active systems is satisfactory for long term exposure. If clear air turbulence were to be encountered, indications are that the SMCS would be very effective in reducing the adverse accelerations. On the other hand, lateral ride quality analyses indicate that the aircraft with the SMCS on does not quite meet the long term exposure criteria, but would be satisfactory for shot term exposure at altitude. Again, the lateral SMCS was shown to be very effective in reducing peak lateral accelerations.

Wykes, J. H.↗
NASA NTRS1980

Analyses and tests of the B-1 aircraft structural mode control system

Analyses and flight tests of the B-1 structural mode control system (SMCS) are presented. Improvements in the total dynamic response of a flexible aircraft and the benefits to ride qualities, handling qualities, crew efficiency, and reduced dynamic loads on the primary structures, were investigated. The effectiveness and the performance of the SMCS, which uses small aerodynamic surfaces at the vehicle nose to provide damping to the structural modes, were evaluated.

Wykes, J. H.↗
NASA NTRS1973

Flight investigation of a structural mode control system for the XB-70 aircraft

A flight investigation of a structural mode control system termed identical location of accelerometer and force (ILAF) was conducted on the XB-70-1 airplane. During the first flight tests, the ILAF system encountered localized structural vibration problems requiring a revision of the compensating network. After modification, successful structural mode control that did not adversely affect the rigid body dynamics was demonstrated. The ILAF system was generally more effective in supersonic than subsonic flight, because the conditions for which the system was designed were more nearly satisfied at supersonic speeds. The results of a turbulence encounter at a Mach number of 1.20 and an altitude of 9754 meters indicated that the ILAF system was effective in reducing the vehicle's response at this flight condition. An analytical study showed that the addition of a small canard to the modal suppression system would greatly improve the automatic control of the higher frequency symmetric modes.

Lock, W. P.↗
NASA NTRS1973

Flight investigation of XB-70 structural response to oscillatory aerodynamic shaker excitation and correlation with analytical results

The low frequency symmetric structural response and damping characteristics of the XB-70 airplane were measured at four flight conditions: heavyweight at a Mach number of 0.87 at an altitude of 7620 meters (25,000 feet); lightweight at a Mach number of 0.86 at an altitude of 7620 meters (25,000 feet); a Mach number of 1.59 at an altitude of 11,918 meters (39.100 feet); and a Mach number of 2.38 and an altitude of 18,898 meters (62,000 feet). The flight data are compared with the response calculated by using early XB-70 design data and with the response calculated with mass, structural, and aerodynamic data updated to reflect as closely as possible the airplane characteristics at three of the flight conditions actually flown.

Mckay, J. M.↗
NASA NTRS1970

XB-70 aerodynamic, geometric, mass, and symmetric structural mode data

XB-70-1 mass, structural, and aerodynamic data were updated to reflect as closely as possible the characteristics of the airplane at three specific flight conditions which were actually flown; a nominal Mach number of 0.90 at an altitude of 25,000 feet (two cases) and a nominal Mach number of 1.6 at an altitude of 40,000 feet (one case). In-flight response characteristics at a number of points on the vehicle were obtained by exciting a pair of shaker vanes on the nose of the airplane. Data were recorded with the basic stability augmentation system (SAS) operating both alone and together with the identical location of accelerometer and force (ILAF) structural mode control system. Detailed total vehicle weight, mass characteristics, structural frequencies, generalized masses, all aerodynamic data used in the present analyses, and a description of the actual mode shapes are tabulated and presented.

Wykes, J. H.↗