Search NASA⌕ Search

Engineering topics

Xiaoli, Tang

Publications and source records attributed to Xiaoli, Tang.

Effects of ruthenium seed layer on the microstructure and spin dynamics of thin permalloy films

The spin dynamics and microstructure properties of a sputtered 12 nm Ni{sub 81}Fe{sub 19} thin film have been enhanced by the use of a ruthenium seed layer. Both the ferromagnetic resonance field and linewidth are enhanced dramatically as the thickness of ruthenium seed layer is increased. The surface anisotropy energy constant can also be largely tailored from 0.06 to 0.96 erg/cm{sup -2} by changing the seed layer thickness. The changes to the dynamics magnetization properties are caused by both ruthenium seed layer induced changes in the Ni{sub 81}Fe{sub 19} structure properties and surface topography properties. Roughness induced inhomogeneous linewidth broadening is also seen. The damping constant is highly tunable via the ruthenium thickness. This approach can be used to tailor both the structure and spin dynamic properties of thin Ni{sub 81}Fe{sub 19} films over a wide range. And it may benefit the applications of spin dynamics and spin current based devices.

36 MATERIALS SCIENCE↗

Tuning the direction of exchange bias in ferromagnetic/antiferromagnetic bilayer by angular-dependent spin-polarized current

The angular dependence of an external magnetic field applied with an in-plane alternating pulse that induces a new direction of exchange bias (EB) is observed in an NiFe/IrMn bilayer. Depending strongly on the direction of the external field, EB field gradually orients along the external field with the increase in current pulse, and the new direction of EB is finally established. Furthermore, the new direction of EB can also be induced along the external field at once when the applied pulse is larger than the critical current. Because the strength and direction of the EB is highly correlated with the micromagnetic state distribution of the antiferromagnet, the observations are explained by the spin torque exerted on the antiferromagnetic moments and provide evidence for the prediction of spin transfer and current-induced switching in antiferromagnets.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

Sintering dense NiZn ferrite by two-step sintering process

A two-step sintering process has been adopted to produce NiZn ferrite with composition of (NiO){sub 0.35}(ZnO){sub 0.57}(CuO){sub 0.08}(Fe{sub 2}O{sub 3}). The densification, microstructure, and magnetic properties of the ferrite have been investigated and compared with those of ferrites produced by the traditional final-stage sintering process. It was found that the sample produced by a two-step sintering process with a high temperature of 1200 deg. C and a lower temperature of 1100 deg. C attained more than 96% of the theoretical density and had a uniform microstructure with a small average grain size. It also exhibited good performances in terms of permeability and Q-factor. Hence, this would seem to be an effective method for producing dense ferrites with a microstructure composed of small and even grains, which is a very effective strategy for improving the magnetic properties of ferrites.

36 MATERIALS SCIENCE↗

Soft magnetic properties of (Ni{sub 80}Fe{sub 20}){sub 1-x}(Ni{sub 0.5}Zn{sub 0.5}Fe{sub 2}O{sub 4}){sub x} films for high frequency applications

A series of (Ni{sub 80}Fe{sub 20}){sub 1-x}(Ni{sub 0.5}Zn{sub 0.5}Fe{sub 2}O{sub 4}){sub x} films were fabricated on Si substrates by means of radio frequency magnetron sputtering and the electrical and magnetic properties were studied. Optimal films with the desired properties of low coercivity H{sub c} {approx} 4 Oe, high saturation magnetization 4{pi}Ms {approx} 14.5 kG, and high electrical resistivity {rho} {approx} 1500 {mu}{Omega} cm were obtained. The permeability spectra measured shows that its natural ferromagnetic resonant frequency was about 3.4 GHz. The tested results shown that the sputtering power had an important effect on the films properties and that it can be convenient to adjust the natural ferromagnetic resonant frequency of the films.

36 MATERIALS SCIENCE↗

Influence of sputtering power on the high frequency properties of nanogranular FeCoHfO thin films

Soft magnetic nanogranular FeCoHfO thin films were fabricated using rf magnetron sputtering in an oxygen/argon ambient. During the deposition process, the partial pressure of oxygen was fixed at 2.5% and sputtering power was used as the control parameter, varying from 50 to 300 W. It was found that the film electrical resistivity ({rho}) decreases steeply with the increase of sputtering power, and the saturation magnetization (4{pi}M{sub s}) and the natural ferromagnetic resonant frequency f{sub r} increase with increasing sputtering power from 50 to 200 W, and then decrease when sputtering power exceeded 200 W. The maximum value of 4{pi}M{sub s} and f{sub r} were 20.5 kG and 3.2GHz, respectively. The coercivity of films had a contrary trend compared with 4{pi}M{sub s} and f{sub r}, and its minimum value was about 1 Oe. The physical origin of the influence was suggested to be related to the structure and composition changes in films.

36 MATERIALS SCIENCE↗