Search NASA⌕ Search

Engineering topics

Xu, C.

Publications and source records attributed to Xu, C..

At least 73 records · Page 4

Formation and characterization of microstructure of as-cast Mg–6Gd–4Y–xZn–0.5Zr (x = 0.3, 0.5 and 0.7 wt.%) alloys

Mg–6Gd–4Y–xZn–0.5Zr (x = 0.3, 0.5 and 0.7 wt.%) alloys were prepared via conventional ingot metallurgy (I/M) in this study. The as-cast microstructures of these alloys were established by X-ray diffraction (XRD) analyses, optical microscope (OM), scanning electron microscope (SEM) and transmission electron microscope (TEM) observations. Lamellar stacking order (SF) and 14H-type long period stacking order (LPSO) structure within α-Mg matrix are formed in the three as-cast alloys. The eutectic secondary phase is (Mg,Zn){sub 24}(Gd,Y){sub 5} for the alloy containing 0.3 wt.% Zn, while, it is (Mg,Zn){sub 3}(Gd,Y) for the alloys containing 0.5 wt.% Zn and 0.7 wt.% Zn. Moreover, X phase-(Mg,Zn){sub 12}(Gd,Y) is formed in the latter two as-cast alloys. - Highlights: • LPSO structure has first been found in as-cast Mg–6Gd–4Y–xZn–0.5Zr. • X-phase exists in as-cast Mg–6Gd–4Y–0.3(0.5)Zn–0.5Zr. • Zn content results in different β-phase in the studied alloys.

36 MATERIALS SCIENCE↗

Coherent femtosecond low-energy single-electron pulses for time-resolved diffraction and imaging: A numerical study

We numerically investigate the properties of coherent femtosecond single electron wave packets photoemitted from nanotips in view of their application in ultrafast electron diffraction and non-destructive imaging with low-energy electrons. For two different geometries, we analyze the temporal and spatial broadening during propagation from the needle emitter to an anode, identifying the experimental parameters and challenges for realizing femtosecond time resolution. The simple tip-anode geometry is most versatile and allows for electron pulses of several ten of femtosecond duration using a very compact experimental design, however, providing very limited control over the electron beam collimation. A more sophisticated geometry comprising a suppressor-extractor electrostatic unit and a lens, similar to typical field emission electron microscope optics, is also investigated, allowing full control over the beam parameters. Using such a design, we find {approx}230 fs pulses feasible in a focused electron beam. The main limitation to achieve sub-hundred femtosecond time resolution is the typical size of such a device, and we suggest the implementation of more compact electron optics for optimal performance.

46 INSTRUMENTATION RELATED TO NUCLEAR SCIENCE AND ↗

Biogeochemical Considerations Related To The Remediation Of 129 I Plumes

The objectives of this report were to: provide a current state of the science of radioiodine biogeochemistry relevant to its fate and transport at the Hanford Site; conduct a review of Hanford Site data dealing with groundwater 129 I; and identify critical knowledge gaps necessary for successful selection, implementation, and technical defensibility in support of remediation decisions.

12 MANAGEMENT OF RADIOACTIVE AND NON-RADIOACTIVE W↗

Laboratory report on iodine ( 129 I and 127 I) speciation, transformation and mobility in Handford groundwater, suspended particles and sediments

The Hanford Site in eastern Washington produced plutonium for several decades and in the process generated billions of gallons of radioactive waste. Included in this complex mixture of waste was 50 Ci of iodine-129 ( 129 I). Iodine-129’s high abundance, due to its high fission yield, and extreme toxicity result in iodine-129 becoming a key risk driver at many Department of Energy (DOE) sites. The mobility of radioiodine in arid environments, such as the Hanford Site, depends largely on its chemical speciation and is also greatly affected by many other environmental factors, especially natural sediment organic matter (SOM). Groundwater radioiodine speciation has not been measured in arid regions with major plumes or large disposed 129 I inventories, including the Hanford Site, Idaho National Laboratory, and Nevada Test Site. In this study, stable iodine-127 and radioiodine-129 speciation, pH, and dissolved organic carbon (DOC) of groundwater samples collected from seven wells located in the 200-West Area of the Hanford site were investigated. The most striking finding was that iodate (IO 3 - ) was the most abundant species. Unexpectedly, iodide (I - ), which was likely the form of iodine in the source materials and the expected dominant groundwater species based on thermodynamic considerations, only accounted for 1-2% of the total iodine concentration. It is likely that the relatively high pH and the low abundance of sedimentary organic matter (SOM) that is present at the site slowed down or even inhibited the reduction of iodate, as SOM abiotically reduce iodate into iodide. Moreover, a study on the kinetics of iodide and iodate uptake and aqueous speciation transformation by three representative subsurface Hanford sediments was performed over a period of about one month. This study was carried out by using iodide-125 or iodate-125 at the ambient iodine-127concentration found at the site. Iodate K d values were on average 89% greater than iodide K d values, and the K d values for both species tended to increase with the amount of organic carbon (OC) present in the sediment. It is especially noteworthy that this trend existed at the very low OC concentrations that naturally exist in the Hanford sediments. Iodine and OC can form essentially irreversible covalent bonds, thereby providing a yet unstudied 129 I retardation reaction at the Hanford Site. In addition to the transformation of iodine species, the sediment collected from the vadose zone also released stable iodide into the aqueous phase. It was found that the three sediments all took up the ambient iodate from the groundwater and slowly transformed it into iodide under the laboratory conditions, likely dependent on the abundance of reducing agents such as organic matter and Fe 2+ . Therefore two competitive iodine processes were identified, the tendency for the sediment to reduce iodate to iodide, and the groundwater chemistry to maintain the iodine as iodate, presumably it is largely the result of natural pH and dissolved O 2 /Eh levels. Suspended carbonate (and silica) particles collected from Hanford groundwater contained elevated amounts of iodine (142 ± 8 μg/g iodine), consisting mainly of iodate (>99%). Iodate was likely incorporated into the carbonate structure during calcite precipitation upon degasing of CO 2 as the groundwater samples were removed from the subsurface. This concentration of groundwater iodate in precipitated carbonate has implication to long-term fate and transport of 129 I and on active in-situ 129 I groundwater remediation. This study provides some of the first groundwater radioiodine speciation studies conducted in arid environments and provides much needed mechanistic descriptions to permit making informed decisions about low-cost/high intellectual input remediation options, such as monitored natural attenuation, or long-term stewardship of nuclear waste disposal sites.

12 MANAGEMENT OF RADIOACTIVE AND NON-RADIOACTIVE W↗

A Novel Approach for the Simultaneous Determination of Iodide, Iodate and Organo-Iodide for 127 I and 129 I in Environmental Samples Using Gas Chromatography-Mass Spectrometry

In aquatic environments, iodine mainly exists as iodide, iodate, and organic iodine. The high mobility of iodine in aquatic systems has led to 129 I contamination problems at sites where nuclear fuel has been reprocessed, such as the F-area of Savannah River Site. In order to assess the distribution of 129 I and stable 127 I in environmental systems, a sensitive and rapid method was developed which enables determination of isotopic ratios of speciated iodine. Iodide concentrations were quantified using gas chromatography-mass spectrometry (GC-MS) after derivatization to 4-iodo-N,N-dimethylaniline. Iodate concentrations were quantified by measuring the difference of iodide concentrations in the solution before and after reduction by Na 2 S 2 O 5 . Total iodine, including inorganic and organic iodine, was determined after conversion to iodate by combustion at 900 °C. Organo-iodine was calculated as the difference between the total iodine and total inorganic iodine (iodide and iodate). The detection limits of iodide-127 and iodate-127 were 0.34 nM and 1.11 nM, respectively, whereas the detection limits for both iodide-129 and iodate-129 was 0.08 nM (i.e., 2pCi 129 I/L). This method was successfully applied to water samples from the contaminated Savannah River Site, South Carolina, and more pristine Galveston Bay, Texas.

Zhang, S.↗

Electroproduction of {eta} mesons in the S{sub 11}(1535) resonance region at high momentum transfer

The differential cross section for the process p(e,e{sup '}p){eta} has been measured at Q{sup 2}{approx}5.7 and 7.0(GeV/c){sup 2} for center-of-mass energies from threshold to 1.8 GeV, encompassing the S{sub 11}(1535) resonance, which dominates the channel. This is the highest momentum-transfer measurement of this exclusive process to date. The helicity-conserving transition amplitude A{sub 1/2}, for the production of the S{sub 11}(1535) resonance, is extracted from the data. Within the limited Q{sup 2} now measured, this quantity appears to begin scaling as Q{sup -3}--a predicted, but not definitive, signal of the dominance of perturbative QCD at Q{sup 2}{approx}5 (GeV/c){sup 2}.

72 PHYSICS OF ELEMENTARY PARTICLES AND FIELDS↗

Charged pion form factor between Q{sup 2}=0.60 and 2.45 GeV{sup 2}. I. Measurements of the cross section for the {sup 1}H(e,e{sup '}{pi}{sup +})n reaction

Cross sections for the reaction {sup 1}H(e,e{sup '}{pi}{sup +})n were measured in Hall C at Thomas Jefferson National Accelerator Facility (JLab) using the high-intensity Continuous Electron Beam Accelerator Facility (CEBAF) to determine the charged pion form factor. Data were taken for central four-momentum transfers ranging from Q{sup 2}=0.60 to 2.45 GeV{sup 2} at an invariant mass of the virtual photon-nucleon system of W=1.95 and 2.22 GeV. The measured cross sections were separated into the four structure functions {sigma}{sub L},{sigma}{sub T},{sigma}{sub LT}, and {sigma}{sub TT}. The various parts of the experimental setup and the analysis steps are described in detail, including the calibrations and systematic studies, which were needed to obtain high-precision results. The different types of systematic uncertainties are also discussed. The results for the separated cross sections as a function of the Mandelstam variable t at the different values of Q{sup 2} are presented. Some global features of the data are discussed, and the data are compared with the results of some model calculations for the reaction {sup 1}H(e,e{sup '}{pi}{sup +})n.

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗

Charged pion form factor between Q{sup 2}=0.60 and 2.45 GeV{sup 2}. II. Determination of, and results for, the pion form factor

The charged pion form factor, F{sub {pi}}(Q{sup 2}), is an important quantity that can be used to advance our knowledge of hadronic structure. However, the extraction of F{sub {pi}} from data requires a model of the {sup 1}H(e,e{sup '}{pi}{sup +})n reaction and thus is inherently model dependent. Therefore, a detailed description of the extraction of the charged pion form factor from electroproduction data obtained recently at Jefferson Lab is presented, with particular focus given to the dominant uncertainties in this procedure. Results for F{sub {pi}} are presented for Q{sup 2}=0.60-2.45 GeV{sup 2}. Above Q{sup 2}=1.5 GeV{sup 2}, the F{sub {pi}} values are systematically below the monopole parametrization that describes the low Q{sup 2} data used to determine the pion charge radius. The pion form factor can be calculated in a wide variety of theoretical approaches, and the experimental results are compared to a number of calculations. This comparison is helpful in understanding the role of soft versus hard contributions to hadronic structure in the intermediate Q{sup 2} regime.

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗

Black Hole Demographics in and Nuclear Properties of Nearby Low Luminosity Radio Galaxies; Connections to Radio Activity?

We combine the results of an HST STIS and WFPC study of a complete sample of 21 nearby UGC low luminosity radio galaxies with the results of a radio VLA and VLBA study of the same sample. We examine the relationship between the stellar and gaseous properties of the galaxies on tens to hundreds of parsec scale with the properties of the radio jets on the same scale. From the VLA and VLBA data we constrain the physics of the outflowing radio plasma from the tens of parsecs to hundreds of kiloparsec scales. From the WFPC2 H alpha and dust images and the STIS kinematics of the near nuclear gas we obtain constraints on the orientation of near nuclear disks of gas and measures of the nuclear stellar, continuum point source, and line emission fluxes. Under the statistically supported assumption that the radio jet issues perpendicular to the disk, we use the orientation of the optical (large scale accretion?) disks to constrain the three-dimensional orientation of the radio ejection. From HST/STIS spectroscopy of the near-nuclear emission line gas we obtain measures/limits on the black hole masses. We examine correlations between the VLBA and VLA-scale radio emission, the nuclear line emission, and the nuclear optical and radio continuum emission. Though our sample is relatively small, it is uniquely well defined, spans a narrow range in redshift and we have a consistent set of high resolution data with which to carefully examine these relationships. We use the combined radio and optical data to: 1) Constrain the orientation, physics, and bulk outflow speed of the radio plasma; 2) Put limits on the mass accretion rate and study the relationship between black hole mass, radio luminosity, and near nuclear gaseous content; 3) Provide insight into the relationship between BL Lac objects and low luminosity radio galaxies.

Baum, S. A.↗