Search NASA⌕ Search

Engineering topics

Xu, Man

Publications and source records attributed to Xu, Man.

11 records
All sourcesNASA NTRSDOE OSTI
DOE OSTI2024

Sound Velocities of Stishovite at Simultaneous High Pressure and High Temperature Suggest an Eclogite‐Rich Layer Beneath the Hawaii Hotspot

Compressional and shear wave velocities of polycrystalline stishovite (SiO 2 ) have been measured at simultaneous high pressures and temperatures up to 14.5 GPa and 800°C. By fitting velocities to the finite strain equations, the elastic moduli and density were determined to be K S0 = 306.6(46) GPa, $K$$^{′}_{S}$ = 4.92(10), ∂K S /∂T = −0.024(1) GPa/K, G 0 = 229.0(34) GPa, G′ = 1.07(10), ∂G/∂T = −0.017(1) GPa/K, ρ 0 = 4.287(2) g/cm 3 . Our modeling suggested that, in the eclogite, coesite-stishovite transition can increase P and S wave velocities by 2.4% and 3.5%, respectively. A comparison between geophysical observations and our model shows that the coesite-stishovite phase transition in the eclogite can potentially be responsible for the occurrence of the X discontinuity beneath Hawaii. In addition, our current results suggest an eclogite-rich layer between 340 and 450 km depth beneath Hawaii. The eclogite concentration at the top and bottom of the layer is 41–55 vol% and >77 vol%, respectively.

36 MATERIALS SCIENCE↗
DOE OSTI2024

Reassessment of Birch's Law on hcp‐Fe From Ultrasonic Sound Velocity Measurement and Implications on the Velocity Profiles of Earth's Inner Core

Here, we performed in situ X-ray diffraction and ultrasonic sound velocity measurements on hcp-Fe up to 15 GPa, 873 K in a multi-anvil apparatus. The elastic moduli and their pressure and temperature derivatives were determined by fitting the velocity and density data to the third-order finite strain equations, yielding K S0 = 169.0(57) GPa, K$^{′}_{S0}$ = 5.4(6), (∂K S /∂T) P = −0.031(3) GPa/K, G 0 = 104.5(27) GPa, G$^{′}_{0}$ = 1.7(2), (∂G/∂T) P = −0.060(2) GPa/K. Within the experimental P-T range, we find significant temperature effect on the density-velocity (ρ − V P or S ) relations and caution the use of the temperature-independent Birch's law for extrapolation to core conditions. Furthermore, temperature-induced velocity decrease is more significant in V S than in V P , offering a possible explanation for the high Poisson's ratio in the core. Extrapolations based on our results together with previous experimental data suggest that V P of hcp-Fe aligns with PREM at Earth's core conditions, while Vs and density are approximately 10% and 2.7% higher than PREM, respectively.

36 MATERIALS SCIENCE↗
DOE OSTI2024

Viscosity Measurements at High Pressures: A Critical Appraisal of Corrections to Stokes' Law

Abstract Fluids and melts in planetary interiors significantly influence geodynamic processes from volcanism to global‐scale differentiation. The roles of these geofluids depend on their viscosities ( η ). Constraining geofluid η at relevant pressures and temperatures relies on laboratory‐based measurements and is most widely done using Stokes' Law viscometry with falling spheres. Yet small sample chambers required by high‐pressure experiments introduce significant drag on the spheres. Several correction schemes are available for Stokes' Law but there is no consensus on the best scheme(s) for high‐pressure experiments. We completed high‐pressure experiments to test the effects of (a) the relative size of the sphere diameter to the chamber diameter and (b) the top and bottom of the chamber, that is, the ends, on the sphere velocities. We examined the influence of current correction schemes on the estimated viscosity using Monte Carlo simulations. We also compared previous viscometry work on various geofluids in different experimental setups/geometries. We find the common schemes for Stokes' Law produce statistically distinct values of η . When inertia of the sphere is negligible, the most appropriate scheme may be the Faxén correction for the chamber walls. Correction for drag due to the chamber ends depends on the precision in the sinking distance and may be ineffective with decreasing sphere size. Combining the wall and end corrections may overcorrect η . We also suggest the uncertainty in η is best captured by the correction rather than propagated errors from experimental parameters. We develop an overlying view of Stokes' Law viscometry at high pressures.

Geochemistry & Geophysics↗
DOE OSTI2022

Sound velocity and compressibility of melts along the hedenbergite (CaFeSi2O6)-diopside (CaMgSi2O6) join at high pressure : Implications for stability and seismic signature of Fe-rich melts in the mantle

Iron-rich silicate melts play an important role in the magmatic history of the Earth and the 16 Moon. However, their elastic properties at high pressures, especially the sound velocity, are poorly 17 understood. Here we determined the ultrasonic sound velocity for the first time of a hedenbergite 18 (Hd, CaFeSi2O6) melt and a melt mixture of 50 mol% hedenbergite + 50 mol% diopside (Hd50Di50) 19 at high pressure and temperature conditions up to 6 GPa and 2329 K, using high-pressure ultrasonic 20 technique combined with synchrotron radiation in a multi-anvil apparatus. Our results show that 21 Fe can significantly reduce the sound velocity while increase the density of silicate melts. 22 Comparing the Di, Hd, and Hd50Di50 melts, we find that the sound velocity does not mix linearly 23 2 for melts in the Hd-Di join, whereas the density for Hd-Di melts at high pressures can be well-24 described by linear mixing. Combined with melt geometry and melt compaction models, we 25 applied our results to study the stability and seismic signature of Fe-rich silicate melts in the Earth’s 26 upper mantle. For the low-velocity zone (LVZ) in mantle asthenosphere, although the degree of 27 seismic velocity reduction can be explained by the presence of a small amount of partial melt 28 distributed in film/band geometry along grain boundaries, Fe-rich melts formed at this depth are 29 unlikely to be gravitationally stable, but may be dynamically unextractable if the melt supply is 30 continuous. For the low-velocity layer (LVL) above the mantle transition zone, the presence of Fe-31 rich melts (with FeO>~10 wt%) distributed in textural equilibrium with the ambient mantle is a 32 plausible explanation.

diopside↗
DOE OSTI2020

High-pressure elastic properties of dolomite melt supporting carbonate-induced melting in deep upper mantle

Deeply subducted carbonates likely cause low-degree melting of the upper mantle and thus play an important role in the deep carbon cycle. However, direct seismic detection of carbonate-induced partial melts in the Earth’s interior is hindered by our poor knowledge on the elastic properties of carbonate melts. Here we report the first experimentally determined sound velocity and density data on dolomite melt up to 5.9 GPa and 2046 K by in-situ ultrasonic and sink-float techniques, respectively, as well as first-principles molecular dynamics simulations of dolomite melt up to 16 GPa and 3000 K. Using our new elasticity data, the calculated V P /V S ratio of the deep upper mantle (~180–330 km) with a small amount of carbonate-rich melt provides a natural explanation for the elevated V P /V S ratio of the upper mantle from global seismic observations, supporting the pervasive presence of a low-degree carbonate-rich partial melt (~0.05%) that is consistent with the volatile-induced or redox-regulated initial melting in the upper mantle as argued by petrologic studies. This carbonate-rich partial melt region implies a global average carbon (C) concentration of 80–140 ppm. by weight in the deep upper mantle source region, consistent with the mantle carbon content determined from geochemical studies.

58 GEOSCIENCES↗
DOE OSTI2020

Density of NaAlSi 2 O 6 Melt at High Pressure and Temperature Measured by In-Situ X-ray Microtomography

In this study, the volumetric compression of jadeite (NaAlSi 2 O 6 ) melt at high pressures was determined by three-dimensional volume imaging using the synchrotron-based X-ray microtomography technique in a rotation-anvil device. Combined with the sample mass, measured using a high-precision analytical balance prior to the high-pressure experiment, the density of jadeite melt was obtained at high pressures and high temperatures up to 4.8 GPa and 1955 K. The density data were fitted to a third-order Birch-Murnaghan equation of state, resulting in a best-fit isothermal bulk modulus K T0 of $10.8$ $^{+1.9}_{–5.3}$ GPa and its pressure derivative K' T0 of $3.4$ $^{+6.6}_{–0.4}$. Comparison with data for silicate melts of various compositions from the literature shows that alkali-rich, polymerized melts are generally more compressible than alkali-poor, depolymerized ones. The high compressibility of jadeite melt at high pressures implies that polymerized sodium aluminosilicate melts, if generated by low-degree partial melting of mantle peridotite at ~250–400 km depth in the deep upper mantle, are likely denser than surrounding mantle materials, and thus gravitationally stable.

36 MATERIALS SCIENCE↗
DOE OSTI2020

High-Pressure Sound Velocity Measurements of Liquids Using In Situ Ultrasonic Techniques in a Multianvil Apparatus

Sound velocity and equation of state of liquids provide important constraints on the generation, presence, and transport of silicate and metallic melts in the Earth’s interior. Unlike their solid counterparts, these properties of liquids pose great technical challenges to high-pressure measurements and are poorly constrained. Here we present the technical developments that have been made at the GSECARS beamline 13-ID-D of the Advanced Photon Source for the past several years for determination of sound velocity of liquids using the ultrasonic techniques in a 1000-ton Kawai-type multianvil apparatus. Temperature of the sound velocity measurements has been extended to ~2400 K at 4 GPa and ~2000 K at 8 GPa to enable studies of liquids with very high melting temperatures, such as the silicate liquids.

58 GEOSCIENCES↗