US-Japan nuclear forensics analysis to identify the origins and process history of uranium ore concentrates
Explore the source record for details and available documents.
Engineering topics
Publications and source records attributed to Yamaguchi, T.
Explore the source record for details and available documents.
Explore the source record for details and available documents.
Iron nanoparticles (Fe{sub 2}O{sub 3}) were added to NiO/gadolinium-doped CeO{sub 2} (GDC) anode supported solid oxide fuel cell (SOFC) for the direct methane-water fuel operation. The cell was co-sintered at 1400 C, and the anode porosity is 31.8%. The main size corresponding to peak volume is around 1.5 {mu}m. When steam and methane directly fed to the cell, the power density is about 0.57 W cm{sup -2} at 650 C. It is the familiar performance for H{sub 2} operation (4 times of flow rate) with same fuel utilization. Compare with the testing temperature of 600 and 650 C, there is almost no carbon fiber deposition at 700 C with steam/methane (S/C) of 5. At the same time, fuel operation of high value of S/C (=3.3) resulted in fiber-like deposition and degradation of power performance based on loading test results.
This paper presents an experimental demonstration to determine electron temperature (T{sub e}) with unknown spectral sensitivity (transmissivity) in a Thomson scattering system. In this method, a double-pass scattering configuration is used and the scattered lights from each pass (with different scattering angles) are measured separately. T{sub e} can be determined from the ratio of the signal intensities without knowing a real chromatic dependence in the sensitivity. Note that the wavelength range for each spectral channel must be known. This method was applied to the TST-2 Thomson scattering system. As a result, T{sub e} measured from the ratio (T{sub e,r}) and T{sub e} measured from a standard method (T{sub e,s}) showed a good agreement with <|T{sub e,r}-T{sub e,s}|/T{sub e,s}>= 7.3%.
Three-dimensionally ordered macroporous cathode was fabricated for a zirconia based micro-tubular solid oxide fuel cells (SOFCs). Three different cathodes (cathode A, no pore former; cathode B, with pore former (1.5 {micro}m in diameter); cathode C, with pore former (0.8 {micro}m in diameter)) were compared to investigate how the microstructure of it affected the cell performance at various operating temperatures. Micro-sized pores were well distributed within cathode B and C. The total porosity of cathode A is 35%, while it respectively reached 42 and 50% for cathodes B and C. At the same time, the specific surface area of them was 28.8 and 52.0% larger than that of the cathode A. As a result, the peak power density of the zirconia based cell, with cathode C, was 0.25 and 0.56 W cm{sup -2} at 550 and 600 C, while the respective value was just 0.11 and 0.30 W cm{sup -2} for the cell with cathode A. Thus, optimizing microstructure of cathode should be one of the best approaches for lowering the operating temperature for SOFCs.
Noninductive plasma current (I{sub p}) start-up experiments using RF power in the lower hybrid frequency range are being conducted on the TST-2 spherical tokamak. The lower hybrid wave (LHW) has demonstrated efficient current drive in conventional tokamaks. However, in spherical tokamak (ST) plasmas with very high dielectric constants (;{epsilon}{approx}{omega}{sub pe}{sup 2}/{Omega}{sub e}{sup 2}>>1), accessibility of the LHW to the plasma core is severely limited. Our approach is to keep the plasma density low (such that {epsilon}{approx}1) during I{sub p} ramp-up. Once I{sub p} reaches a level sufficiently high for neutral beam current drive, plasma can be densified and transformed into an advanced tokamak plasma dominated by the self-driven bootstrap current. Initial plasma start-up experiments were performed on TST-2 using a combline antenna which excites a traveling fast wave. After formation of toroidal flux surfaces, RF power and vertical field were ramped up to increase I{sub p}. Up to 12 kA of Ip has been obtained by this method. Soft X-ray measurements indicate that the electron temperature increases as I{sub p} increases, and hard X-ray spectroscopy indicates that energetic electrons build up as I{sub p} is ramped up.
NiO-Fe{sub 2}O{sub 3}/Gadolinium-doped CeO{sub 2} (GDC), NiO/GDC anode-supported fuel cells were compared at intermediate temperature to investigate the effect of ferrum (Fe) on anode microstructure and the cell performance. The porosity of Fe{sub 2}O{sub 3}-containing anode tubes are 36.3% (those sintered at 1350 C) and 31.8% (those sintered at 1400 C), which are respectively 1.1% and 5.9% higher than that of the tubes without Fe{sub 2}O{sub 3}. The effect of Fe on microstructure of anode has also been indicated by analyzing the volume fraction of the different-size pores. At the operating temperature of 600 C, the maximum power density increased nearly 100% using Fe-Ni (after reducing) bimetal anode. From the impedance spectra, it is deduced that the improvement in power density is due to the decrease of overpotential resistance (low frequency part) related to gas transportation.
The {beta}-ray angular correlations for the spin alignments of {sup 8}Li and {sup 8}B have been observed in order to test the conserved vector current (CVC) hypothesis. The alignment correlation terms were combined with the known {beta}-{alpha} angular correlation terms to determine all the matrix elements contributing to the correlation terms. The weak magnetism term, 7.5{+-}0.2, deduced from the {beta}-ray correlation terms was consistent with the CVC prediction 7.3{+-}0.2, deduced from the analog-{gamma} decay measurement based on the CVC hypothesis. However, there was no consistent CVC prediction for the second-forbidden term associated with the weak vector current. The experimental value for the second-forbidden term was 1.0{+-}0.3, while the CVC prediction was 0.1{+-}0.4 or 2.1{+-}0.5.
We report a systematic investigation on Mg doped InN epilayers grown by radio-frequency plasma-assisted molecular beam epitaxy. Electrolyte capacitance voltage (ECV) combined with thermopower measurements find p-type conduction over an Mg concentration range. For InN:Mg in this p-type 'window' the Seebeck coefficients dramatically change their signs from negative to positive when the thickness of undoped InN interlayer decreases to zero. This notable sign change of Seebeck coefficient explains the previous inconsistency between ECV and thermopower results and confirms the existence of mobile holes in the InN:Mg. Taking into account the undoped InN interlayer, the hole density and mobility are extracted.
NiO-GDC, NiO-YSZ, NiO-Fe2O3-GDC, NiO-Fe2O3-YSZ anode tube supported tubular fuel cells was fabricated at the co-sintering temperature from 1250 C to 1400 C to investigate how the co-sintering temperature affect the open-circuit voltage. To focus on the changing of anode tube, all the tubular fuel cells support a ScSZ electrolyte layer and a LSCF cathode layer. The microstructure of the electrolyte layer sintered under 1300 C included pores inside it, and the densification of the electrolyte completed at the sintering temperatures above 1300 C. Furthermore, the shrinkage both in length and in diameter of a tubular fuel cell reaches as much as 20% at co-sintering temperature of 1400 C. The densification of ScSZ electrolyte layer and shrinkage of anode tube will result in the changing of open-circuit voltage of fuel cell from 1.0 V to 1.1 V.
We present a detailed study of the structural characteristics of molecular beam epitaxy grown nonpolar InN films with a- and m-plane surface orientations on r-plane sapphire and (100) {gamma}-LiAlO{sub 2}, respectively, and semipolar (1011) InN grown on r-plane sapphire. The on-axis rocking curve (RC) widths were found to exhibit anisotropic dependence on the azimuth angle with minima at InN [0001] for the a-plane films, and maxima at InN [0001] for the m-plane and semipolar films. The different contributions to the RC broadening are analyzed and discussed. The finite size of the crystallites and extended defects are suggested to be the dominant factors determining the RC anisotropy in a-plane InN, while surface roughness and curvature could not play a major role. Furthermore, strategy to reduce the anisotropy and magnitude of the tilt and minimize defect densities in a-plane InN films is suggested. In contrast to the nonpolar films, the semipolar InN was found to contain two domains nucleating on zinc-blende InN(111)A and InN(111)B faces. These two wurtzite domains develop with different growth rates, which was suggested to be a consequence of their different polarity. Both, a- and m-plane InN films have basal stacking fault densities similar or even lower compared to nonpolar InN grown on free-standing GaN substrates, indicating good prospects of heteroepitaxy on foreign substrates for the growth of InN-based devices.
Reaction cross sections ({sigma}{sub R}) for the proton drip-line nucleus {sup 17}Ne have been measured on {sup 9}Be, {sup 12}C, and {sup 27}Al targets at 64 and 42 MeV/nucleon by the transmission method. From the energy dependence of the {sigma}{sub R} including the high energy data, the density distribution of {sup 17}Ne was deduced through a modified Glauber-type calculation. It is indicated that {sup 17}Ne has a long tail in the density, consistent with a (2s{sub 1/2}){sup 2}-dominant configuration of two valence protons.
The charge-changing cross sections (sigma{sub cc}) of {sup 28}Si on a carbon target were measured with high precision at intermediate energies from 100 to 600 MeV/nucleon. The measured sigma{sub cc} decreases rapidly from low energies up to 200 MeV/nucleon, whereas at higher energies it appears almost constant. The energy dependence of sigma{sub cc} is compared with a Glauber-type model calculation where only the proton distribution of {sup 28}Si is taken into account. A phenomenological correction factor deduced from the present data satisfactorily reproduces the experimental sigma{sub cc} for other stable nuclei, whose charge distributions were determined by electron scattering and muon capture experiments.
Reaction cross sections for stable nuclei at intermediate energies have been measured precisely and systematically. The data have been found to be reproduced nicely by the optical-limit approximation of Glauber theory modified to include the nucleon multiple scattering effect and the Fermi-motion effect. Applying this prescription, the nucleon density distribution of {sup 17}Ne has been studied. The surface structure of {sup 8}B and {sup 11}Be has been also studied using this prescription and hydrogen targets. Using the RIBF that has just started application to studies of exotic nuclei, neutron-rich Ne isotopes around the Island of Inversion have been investigated through measurements of their interaction cross sections.
We have searched for a time-modulated decay in a standard electron capture experiment for {sup 140}Pr, in order to confirm a report from GSI, where an oscillatory decay has been observed for hydrogen-like {sup 140}Pr and {sup 142}Pm ions in the cooler storage ring. {sup 140}Pr has been produced with the {sup 140}Ce(p, n) reaction by a pulsed proton beam accelerated from the Van de Graaff accelerator at Osaka University. Resultant time dependence of the K{sub a}lpha and K{sub b}eta X-ray intensities from the daughter shows no oscillatory behavior.
We study the unintentional H impurities in relation to the free electron properties of state-of-the-art InN films grown by molecular beam epitaxy (MBE). Enhanced concentrations of H are revealed in the near surface regions of the films, indicating postgrowth surface contamination by H. The near surface hydrogen could not be removed upon thermal annealing and may have significant implications for the surface and bulk free electron properties of InN. The bulk free electron concentrations were found to scale with the bulk H concentrations while no distinct correlation with dislocation density could be inferred, indicating a major role of hydrogen for the unintentional conductivity in MBE InN.
Reaction cross sections ({sigma}{sub R}) for {sup 19}C, {sup 20}C and the drip-line nucleus {sup 22}C on a liquid hydrogen target have been measured at around 40A MeV by a transmission method. A large enhancement of {sigma}{sub R} for {sup 22}C compared to those for neighboring C isotopes was observed. Using a finite-range Glauber calculation under an optical-limit approximation the rms matter radius of {sup 22}C was deduced to be 5.4+-0.9 fm. It does not follow the systematic behavior of radii in carbon isotopes with N<=14, suggesting a neutron halo. It was found by an analysis based on a few-body Glauber calculation that the two-valence neutrons in {sup 22}C preferentially occupy the 1s{sub 1/2} orbital.
HHFW experiments on TST-2 and UTST were performed. In the TST-2 HHFW experiment, the pickup probe mounted on the inboard wall detected the same PDI lower sideband peak as probes on the outboard side. Since the frequency difference from the pump wave corresponds to the ion cyclotron frequency on the low field side, the lower sideband wave is believed to be generated at the plasma edge on the low field side, and propagated to the high field side. This component may be the FW. In the UTST HHFW experiment, direct measurements of the RF fields in the plasma were made successfully.