Search NASA⌕ Search

Engineering topics

Yan, Tsun-Yee

Publications and source records attributed to Yan, Tsun-Yee.

At least 19 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS2010

ELDRS Characterization for a Very High Dose Mission

Evaluation of bipolar linear parts which may have Enhanced Low Dose Rate Sensitivity (ELDRS) is problematic for missions that have very high dose radiation requirements. The accepted standards for evaluating parts that display ELDRS require testing at a very low dose rate which could be prohibitively long for very high dose missions. In this work, a methodology for ELDRS characterization of bipolar parts for mission doses up to 1 Mrad(Si) is evaluated. The procedure employs an initial dose rate of 0.01 rad(Si)/s to a total dose of 50 krad(Si) and then changes to 0.04 rad(Si)/s to a total dose of 1 Mrad(Si). This procedure appears to work well. No change in rate of degradation with dose has been observed when the dose rate is changed from 0.01 to 0.04 rad(Si)/s. This is taken as an indication that the degradation due to the higher dose rate is equivalent to that at the lower dose rate at the higher dose levels, at least for the parts studied to date. In several cases, significant parameter degradation or functional failure not observed at HDR was observed at fairly high total doses (50 to 250 krad(Si)) at LDR. This behavior calls into question the use of dose rate trend data and enhancement factors to predict LDR performance.

Radiation Damage↗
NASA NTRS2006

FQPSK-B viterbi receiver

An FQPSK-B receiver uses a simplified trellis system which uses combinations of FQPSK-B waveforms to correlate against an input signal. This enables reduction of the number of correlators that are used and the number of comparisons that are made by the correlators.

Lee, Dennis K.↗
NASA NTRS2005

System for Processing Coded OFDM Under Doppler and Fading

An advanced communication system has been proposed for transmitting and receiving coded digital data conveyed as a form of quadrature amplitude modulation (QAM) on orthogonal frequency-division multiplexing (OFDM) signals in the presence of such adverse propagation-channel effects as large dynamic Doppler shifts and frequency-selective multipath fading. Such adverse channel effects are typical of data communications between mobile units or between mobile and stationary units (e.g., telemetric transmissions from aircraft to ground stations). The proposed system incorporates novel signal processing techniques intended to reduce the losses associated with adverse channel effects while maintaining compatibility with the high-speed physical layer specifications defined for wireless local area networks (LANs) as the standard 802.11a of the Institute of Electrical and Electronics Engineers (IEEE 802.11a). OFDM is a multi-carrier modulation technique that is widely used for wireless transmission of data in LANs and in metropolitan area networks (MANs). OFDM has been adopted in IEEE 802.11a and some other industry standards because it affords robust performance under frequency-selective fading. However, its intrinsic frequency-diversity feature is highly sensitive to synchronization errors; this sensitivity poses a challenge to preserve coherence between the component subcarriers of an OFDM system in order to avoid intercarrier interference in the presence of large dynamic Doppler shifts as well as frequency-selective fading. As a result, heretofore, the use of OFDM has been limited primarily to applications involving small or zero Doppler shifts. The proposed system includes a digital coherent OFDM communication system that would utilize enhanced 802.1la-compatible signal-processing algorithms to overcome effects of frequency-selective fading and large dynamic Doppler shifts. The overall transceiver design would implement a two-frequency-channel architecture (see figure) that would afford frequency diversity for reducing the adverse effects of multipath fading. By using parallel concatenated convolutional codes (also known as Turbo codes) across the dual-channel and advanced OFDM signal processing within each channel, the proposed system is intended to achieve at least an order of magnitude improvement in received signal-to-noise ratio under adverse channel effects while preserving spectral efficiency.

Tsou, Haiping↗
NASA NTRS2005

Adaptive Thresholding and Parameter Estimation for PPM

A method of adaptive setting of a threshold level for the detection of pulses in a pulse-position modulation (PPM) free-space optical communication system has been developed. In simplified terms, it is desirable to set a threshold value high enough to greatly reduce the probability (PFA as defined below) of erroneously detecting noise as signal pulses but not so high as to greatly reduce the probability (PD as defined below) of detecting any signal pulses that may be present along with noise. In the present method, the threshold level is varied with time, in response to changing conditions in the optical-communication channel, in an effort to maintain a balance between the aforesaid competing requirements. An integral part of this adaptation scheme is a scheme for estimating key parameters of the optical-communication channel in particular, parameters that describe the fading and total attenuation in the channel, and parameters that characterize spreading of pulses by atmospheric and other effects. The method can be implemented by software processing of digitized optoelectronic-detector output, and has been tested by computational simulation. In the first stage of processing by this method, the digitized values of the detector output during noise-only time slots of received PPM symbols are averaged to obtain a background level. This background level is subtracted from the detector output in the hope of reducing or eliminating the noise component in the remaining signal. (This background level should not be confused with the detection threshold, which is computed in the last stage of processing.) Next, the remaining signal - in effect, a vector of pulse samples - is normalized by dividing it by its L1 norm (in general, the L1 norm of a vector is defined as the sum of absolute magnitudes of its orthogonal components).

Arabshahi, Payman↗
NASA NTRS2004

Scalable Architecture for Multihop Wireless ad Hoc Networks

A scalable architecture for wireless digital data and voice communications via ad hoc networks has been proposed. Although the details of the architecture and of its implementation in hardware and software have yet to be developed, the broad outlines of the architecture are fairly clear: This architecture departs from current commercial wireless communication architectures, which are characterized by low effective bandwidth per user and are not well suited to low-cost, rapid scaling in large metropolitan areas. This architecture is inspired by a vision more akin to that of more than two dozen noncommercial community wireless networking organizations established by volunteers in North America and several European countries.

Arabshahi, Payman↗
NASA NTRS2003

Simpler Alternative to an Optimum FQPSK-B Viterbi Receiver

A reduced-complexity alternative to an optimum FQPSK-B Viterbi receiver has been invented. As described, the reduction in complexity is achieved at the cost of only a small reduction in power performance [performance expressed in terms of a bit-energy-to-noise-energy ratio (Eb/N0) for a given bit-error rate (BER)]. The term "FQPSK-B" denotes a baseband-filtered version of Feher quadrature-phase-shift keying, which is a patented, bandwidth-efficient phase-modulation scheme named after its inventor. Heretofore, commercial FQPSK-B receivers have performed symbol-by-symbol detection, in each case using a detection filter (either the proprietary FQPSK-B filter for better BER performance, or a simple integrate-and-dump filter with degraded performance) and a sample-and-hold circuit.

Lee, Dennis↗
NASA NTRS2001

Advanced Communication and Networking Technologies for Mars Exploration

Next-generation Mars communications networks will provide communications and navigation services to a wide variety of Mars science vehicles including: spacecraft that are arriving at Mars, spacecraft that are entering and descending in the Mars atmosphere, scientific orbiter spacecraft, spacecraft that return Mars samples to Earth, landers, rovers, aerobots, airplanes, and sensing pods. In the current architecture plans, the communication services will be provided using capabilities deployed on the science vehicles as well as dedicated communication satellites that will together make up the Mars network. This network will evolve as additional vehicles arrive, depart or end their useful missions. Cost savings and increased reliability will result from the ability to share communication services between missions. This paper discusses the basic architecture that is needed to support the Mars Communications Network part of NASA's Space Science Enterprise (SSE) communications architecture. The network may use various networking technologies such as those employed in the terrestrial Internet, as well as special purpose deep-space protocols to move data and commands autonomously between vehicles, at disparate Mars vicinity sites (on the surface or in near-Mars space) and between Mars vehicles and earthbound users. The architecture of the spacecraft on-board local communications is being reconsidered in light of these new networking requirements. The trend towards increasingly autonomous operation of the spacecraft is aimed at reducing the dependence on resource scheduling provided by Earth-based operators and increasing system fault tolerance. However, these benefits will result in increased communication and software development requirements. As a result, the envisioned Mars communications infrastructure requires both hardware and protocol technology advancements. This paper will describe a number of the critical technology needs and some of the ongoing research activities.

Bhasin, Kul↗
NASA NTRS2000

The Extended-Image Tracking Technique Based on the Maximum Likelihood Estimation

This paper describes an extended-image tracking technique based on the maximum likelihood estimation. The target image is assume to have a known profile covering more than one element of a focal plane detector array. It is assumed that the relative position between the imager and the target is changing with time and the received target image has each of its pixels disturbed by an independent additive white Gaussian noise. When a rotation-invariant movement between imager and target is considered, the maximum likelihood based image tracking technique described in this paper is a closed-loop structure capable of providing iterative update of the movement estimate by calculating the loop feedback signals from a weighted correlation between the currently received target image and the previously estimated reference image in the transform domain. The movement estimate is then used to direct the imager to closely follow the moving target. This image tracking technique has many potential applications, including free-space optical communications and astronomy where accurate and stabilized optical pointing is essential.

Tsou, Haiping↗
NASA NTRS2000

Flexible All-Digital Receiver for Bandwidth Efficient Modulations

An all-digital high data rate parallel receiver architecture developed jointly by Goddard Space Flight Center and the Jet Propulsion Laboratory is presented. This receiver utilizes only a small number of high speed components along with a majority of lower speed components operating in a parallel frequency domain structure implementable in CMOS, and can currently process up to 600 Mbps with standard QPSK modulation. Performance results for this receiver for bandwidth efficient QPSK modulation schemes such as square-root raised cosine pulse shaped QPSK and Feher's patented QPSK are presented, demonstrating the flexibility of the receiver architecture.

Gray, Andrew↗
NASA NTRS1994

(abstract) Atmospheric Transmission Model Through Autonomous Visibility Measurement

Performance of deep space optical communications is impacted by atmospheric outages. By monitoring known stellar objects with calibrated telescopes, atmospheric attenuation statistics can be recorded. This paper describes a program to develop an atmospheric transmission model for optical communications by making automous visibility measurements of known stellar objects from three locations in the southwestern US. The data will be correlated and infused with weather data to establish the atmospheric transmission model. This model will be sent in link margin analysis for optical communications channels. The statistics will be updated on a quarterly basis and calibrated using data taken over a long period of time. This calibration is expected to allow extrapolation to other ground-based locations through use of global weather databases.

attenuation model↗
NASA NTRS1993

Land-mobile satellite communication system

A satellite communications system includes an orbiting communications satellite for relaying communications to and from a plurality of ground stations, and a network management center for making connections via the satellite between the ground stations in response to connection requests received via the satellite from the ground stations, the network management center being configured to provide both open-end service and closed-end service. The network management center of one embodiment is configured to provides both types of service according to a predefined channel access protocol that enables the ground stations to request the type of service desired. The channel access protocol may be configured to adaptively allocate channels to open-end service and closed-end service according to changes in the traffic pattern and include a free-access tree algorithm that coordinates collision resolution among the ground stations.

Yan, Tsun-Yee↗
NASA NTRS1992

Definition Of The MSAT-X Network

Report describes state of development of Mobile Satellite Experiment (MSAT-X) network at end of 1989. Network includes mobile stations and base stations communicating by microwave radio relay via geostationary satellite. Provides three types of service: mobile telephone, mobile dispatch and digital data. Summarizes findings which serve as background for discussion of tentative specifications for design of network.

Wang, Charles C.↗
NASA NTRS1992

Sharing Resources In Mobile/Satellite Communications

Report presents preliminary theoretical analysis of several alternative schemes for allocation of satellite resource among terrestrial subscribers of landmobile/satellite communication system. Demand-access and random-access approaches under code-division and frequency-division concepts compared.

Yan, Tsun-Yee↗
NASA NTRS1992

FD/DAMA Scheme For Mobile/Satellite Communications

Integrated-Adaptive Mobile Access Protocol (I-AMAP) proposed to allocate communication channels to subscribers in first-generation MSAT-X mobile/satellite communication network. Based on concept of frequency-division/demand-assigned multiple access (FD/DAMA) where partition of available spectrum adapted to subscribers' demands for service. Requests processed, and competing requests resolved according to channel-access protocol, or free-access tree algorithm described in "Connection Protocol for Mobile/Satellite Communications" (NPO-17735). Assigned spectrum utilized efficiently.

Yan, Tsun-Yee↗
NASA NTRS1992

An extended-source spatial acquisition process based on maximum likelihood criterion for planetary optical communications

This paper describes an extended-source spatial acquisition process based on the maximum likelihood criterion for interplanetary optical communications. The objective is to use the sun-lit Earth image as a receiver beacon and point the transmitter laser to the Earth-based receiver to establish a communication path. The process assumes the existence of a reference image. The uncertainties between the reference image and the received image are modeled as additive white Gaussian disturbances. It has been shown that the optimal spatial acquisition requires solving two nonlinear equations to estimate the coordinates of the transceiver from the received camera image in the transformed domain. The optimal solution can be obtained iteratively by solving two linear equations. Numerical results using a sample sun-lit Earth as a reference image demonstrate that sub-pixel resolutions can be achieved in a high disturbance environment. Spatial resolution is quantified by Cramer-Rao lower bounds.

Yan, Tsun-Yee↗
NASA NTRS1990

A Mobile Satellite Experiment (MSAT-X) network definition

The network architecture development of the Mobile Satellite Experiment (MSAT-X) project for the past few years is described. The results and findings of the network research activities carried out under the MSAT-X project are summarized. A framework is presented upon which the Mobile Satellite Systems (MSSs) operator can design a commercial network. A sample network configuration and its capability are also included under the projected scenario. The Communication Interconnection aspect of the MSAT-X network is discussed. In the MSAT-X network structure two basic protocols are presented: the channel access protocol, and the link connection protocol. The error-control techniques used in the MSAT-X project and the packet structure are also discussed. A description of two testbeds developed for experimentally simulating the channel access protocol and link control protocol, respectively, is presented. A sample network configuration and some future network activities of the MSAT-X project are also presented.

Wang, Charles C.↗
NASA NTRS1990

Connection Protocol For Mobile/Satellite Communications

Throughput increased by better resolution of competing simultaneous requests for connections. Improved protocol sorts out simultaneous competing requests by message-originating stations for connection to satellite transmission link of land-mobile/satellite digital communication system. Applies to multiple-channel packet-message system with synchronous timeslots on all channels. Communication system has Q channels. Transmissions of packets allowed to begin only at beginnings of timeslots. Provides, to all users, binary feedback information on state of channel - namely, whether or not there is collision - during each timeslot.

Tan, Harry H.↗