Growth and Characterization of CdTeSe for Room-Temperature Radiation Detector Applications
N/A
Engineering topics
Publications and source records attributed to Yang, G..
N/A
N/A
We present in this contribution results of two-step annealing, when the CdTe:Cl doped samples are at first annealed under Cd overpressure to remove inclusions and the re-annealed under Te overpressure to restore the high resistivity state. Investigation of samples after Cd rich annealing by infrared microscope has proven, that all inclusions are removed. Also Te nano precipitates were strongly influenced by the annealing process. The resistivity of the samples after Te-rich annealing was restored to values ( ~ 108-109Ωcm). We observed, however, decrease of mobility-lifetime product of electrons from 10-3cm2/Vs to 10-4cm2/Vs. In order to understand the reason of this decrease we performed a study of point defects before and after annealing by thermoelectric effect spectroscopy. It shows a decrease of concentrations of most deep levels after two-step annealing. This behavior is completely different compared to past annealing studies, where concentration of deep levels strongly increased after annealing. The only level with an increased concentration in the current study is the midgap level (E ~ 0.8 eV). At the same time we observed increase of micro-twins in the samples investigated by transmission electron microscopy. The decrease of charge collection efficiency after two-step annealing may be therefore connected with re-arrangement of near midgap levels due to increase of concentrations of structure defects (micro twins, dislocations) that accumulate in their surroundings point defects with energy ~ 0.75 eV.
Semi-insulating Cd0.9Zn0.1Te:Pb crystals were grown by the vertical Bridgman method. Measurements of the current deep level transient spectroscopy (I-DLTS) revealed three trap levels in this material. Unlike other compensating dopants, CdZnTe:Pb samples do not show any Cd-vacancies defects and A-center levels. We subjected them to temperature-gradient annealing in Cd overpressure at 490–717 1C, and recorded an exponential relationship between the annihilation time of Te precipitates and the annealing temperature. The energy resolution of an annealed CdZnTe:Pb detector, tested using a 137Cs radioactive source, gave an energy resolution of 2.5%.
Explore the source record for details and available documents.
We present new CMOS photodiode imager pixel with ultra-low read noise through on-chip suppression of reset noise via column-based feedback circuitry. The noise reduction is achieved without introducing any image lag, and with insignificant reduction in quantum efficiency and full well.
A high-performance computational imager based on integration of CMOS active pixel imager array with on-chip signal processing and control via a new column-parallel architecture is presented.
This paper discusses common approaches to CMOS APS technology, as well as specific results on the five-wire programmable digital camera-on-a-chip developed at JPL. The paper also reports recent research in the design, operation, and performance of APS imagers for several imager applications.
Explore the source record for details and available documents.
Explore the source record for details and available documents.
Design and characterization of a high-performance multi-acuity, multi-window dynamicaly reconfigurable vision (DRV) CMOS imager for real-time staring vision systems is presented.
This paper presents a new technique for implementing a low-power CMOS imager with simultaneous on-chip computation of the difference and summ of two successive frames.