Large-eddy simulation of turbulent obstacle flow using a dynamic subgrid-scale model
Explore the source record for details and available documents.
Engineering topics
Publications and source records attributed to Yang, Kyung-Soo.
Explore the source record for details and available documents.
We apply the dynamic subgrid-scale model (DSGSM) to large-eddy simulation (LES) of turbulent channel flow with a square rib mounted on one wall. The Reynolds number (Re) is 3210 based on the mean velocity above the obstacle and the obstacle height. Near-wall structures are resolved with the no-slip boundary condition. The results show better agreement with direct numerical simulation (DNS) than LES with a fixed model constant, verifying the value of the DSGSM for simulating complex turbulent flows.
In this paper, we perform a large eddy simulation (LES) of turbulent flow in a channel containing a two-dimensional obstacle on one wall using a dynamic subgrid-scale model (DSGSM) at Re = 3210, based on bulk velocity above the obstacle and obstacle height; the wall layers are fully resolved. The low Re enables us to perform a DNS (Case 1) against which to validate the LES results. The LES with the DSGSM is designated Case 2. In addition, an LES with the conventional fixed model constant (Case 3) is conducted to allow identification of improvements due to the DSGSM. We also include LES at Re = 82,000 (Case 4) using conventional Smagorinsky subgrid-scale model and a wall-layer model. The results will be compared with the experiment of Dimaczek et al.
The laminar-turbulent transition in a decelerating flat-plate boundary layer is investigated by solving numerically the incompressible time-dependent three-dimensional Navier-Stokes equations. In the early stages of the transition, two-dimensional and slightly oblique waves are found to grow because of an inflexional instability. Their subsequent nonlinear interactions trigger the breakdown and determine the pattern of the Lambda vortices. The tips of the Lambda vortices are rarely aligned in the flow direction and appear in local patches, often near the dislocation in the initial wave pattern. The observed features are accounted for by a simple wave-interference model.
Report describes computer-simulation of instability and transition to turbulence in plane Poisseuille flow in rotating channel. Motions of fluid governed by Navier-Stokes equations of incompressible flow, using periodic boundary conditions in streamwise and spanwise directions. Principal parameters affecting flow are Reynolds and rotation numbers.
Direct numerical simulations with initial small-amplitude random disturbances are used to investigate instability and transition in plane Pouseuille flow with spanwise system rotation, employing a large computational domain to facilitate the selection of the dominant spanwise wavelength of the observed streamwise vortices as well as the streamwise wavelength of the dominant secondary modes due to streamwise vortices. In all cases studied, the unstable primary three-dimensional waves persist in the nonlinear stage. Where there is primary three-dimensional wave decay, the finite-amplitude streamwise vortices can become unstable to two different three-dimensional secondary instability modes, depending on the Reynolds and the rotation numbers.
The early three-dimensional stages of transition in the Blasius boundary layer are studied by numerical solution of the Navier-Stokes equations. A finite-amplitude two-dimensional wave and low-amplitude three-dimensional random disturbances are introduced. Rapid amplification of the three-dimensional components is observed and leads to transition. For intermediate amplitudes of the two-dimensional wave the breakdown is of subharmonic type, and the dominant spanwise wavenumber increases with the amplitude. For high amplitudes the energy of the fundamental mode is comparable to the energy of the subharmonic mode, but never dominates it; the breakdown is of mixed type. Visualizations, energy histories, and spectra are presented. The sensitivity of the results to various physical and numerical parameters is studied. The agreement with experimental and theoretical results is discussed.