Engineering topics

Yanta, William J.

Publications and source records attributed to Yanta, William J..

6 records

NASA NTRS1992

Boundary layer study on nozzle wall at hypersonic velocities

The boundary layer on the wall of the Hypervelocity Tunnel 9 was investigated with pitot pressure and total temperature measurements. Experimental results are presented for standard and supercooled Mach 14 runs. The boundary layer data at supercooled conditions are compared to numerical predictions made with a Navier-Stokes algorithm including vibrational nonequilibrium and intermolecular force effects. For standard tunnel conditions, the numerical solutions agree well with experimental data. For the supercooled cases, the numerical code predicts the total temperature but overpredicts the pitot pressure.

Jones, Kenneth M.↗

NASA NTRS1991

Quantification of vapor screen analysis

The traditionally qualitative method of vapor screening is applied to the task of gathering quantitative density measurements in supersonic flows. Quantitative density information for flow around a two-dimensional biconvex airfoil at Mach 2.8 is extracted from digitized images of vapor screens by assuming a linear relation between particle density and scattering intensity. Intensity readings are calibrated through known conditions in the free stream and at the airfoil bow shock. The experimental results are compared to densities generated by a Euler code and determined to have errors of less than ten percent.

Benedict, Lance H.↗

NASA NTRS1991

A fine-wire thermocouple probe for measurement of stagnation temperatures in real gas hypersonic flows of nitrogen

A fine-wire thermocouple probe was used to determine freestream stagnation temperatures in hypersonic flows. Data were gathered in a N2 blowdown wind tunnel with runtimes of 1-5 s. Tests were made at supply pressures between 30 and 1400 atm and supply temperatures between 700 and 1900 K, with Mach numbers of 14 to 16. An iterative procedure requiring thermocouple data, pilot pressure measurements, and supply conditions was used to determine test cell stagnation temperatures. Probe conduction and radiation losses, as well as real gas behavior of N2, were accounted for during analysis. Temperature measurement error was found to be 5 to 10 percent. A correlation was drawn between thermocouple diameter Reynolds number and temperature recovery ratio. Transient probe behavior was studied and was found to be adequate in temperature gradients up to 1000 K/s.

Hollis, Brian R.↗

NASA NTRS1990

Condensation in hypersonic nitrogen wind tunnels

Experimental observations and a theoretical model for the onset and disappearance of condensation are given for hypersonic flows of pure nitrogen at M = 10, 14 and 18. Measurements include Pitot pressures, static pressures and laser light scattering experiments. These measurements coupled with a theoretical model indicate a substantial non-equilibrium supercooling of the vapor phase beyond the saturation line. Typical results are presented with implications for the design of hypersonic wind tunnel nozzles.

Lederer, Melissa A.↗

NASA NTRS1990

Condensation shocks in hypersonic nitrogen tunnels

Experimental observations and a theoretical model for the onset and disappearance of condensation are provided for hypersonic flows of pure nitrogen at M = 10, 14, and 18. A method for analyzing the thermodynamic and flow properties of a partially condensed mixture from known supply conditions and measured Pitot pressure yields the local static pressure and temperature, mass fraction of the nitrogen condensed, and the Mach number of the partially condensed flow based on frozen sound speed. The transition between partially condensed-supercooled flow is found to occur at 22-25 K isobaric supercooling with the corresponding mass fraction condensed being 12-14 percent over a range of two orders of magnitude in local static pressure. The heat released and vapor mass removed during condensation ultimately raise the local pressure and temperature and reduce the flow Mach number.

Hudson, Susan T.↗

NASA NTRS1989

Laser holographic interferometric measurements of the flow in a scramjet inlet at Mach 4

The need for quantitative data is addressed by laser holographic interferometry (LHI) by efficiently recording and reducing high resolution density data. This paper investigates the potential to get quantitative data from an interferogram created from two separate holographic plates. THe LHI measurements were made on a scramjet inlet at Mach 4. LHI successfully generated results for both internal and external flows, and demonstrated its ability to map entire flow fields. Of the three data reduction techniques used, the four-bucket method gave better results than the three-bucket or three-by-three methods. This technique requires high quality holograms as well as a good resolution in the digital images to produce good data.

Mcarthur, J. Craig↗