Search NASA⌕ Search

Engineering topics

Yarmolich, D

Publications and source records attributed to Yarmolich, D.

Laser induced fluorescence of the ferroelectric plasma source assisted hollow anode discharge

Parameters of the plasma produced by a ferroelectric plasma source (FPS) assisted high-current ({approx}1 kA), hollow anode (HA), low-pressure (10{sup -4} Torr) Ar gas discharge were studied using a time- and space-resolved laser induced fluorescence (LIF) diagnostic technique. It was shown that the plasma filling of the HA cavity occurs due to the expansion of the plasma flows generated by the FPSs with a gradual time-dependent increase in the plasma density along the length of the HA cavity. These data were verified by the results of one-dimensional modeling of the plasma expansion in vacuum and time-dependent collisional-radiative modeling. Also, LIF diagnostics, which was tested on the saturation effect both experimentally and numerically, showed that the plasma ion temperature gradually increases during the discharge reaching {approx}9 eV at its end. Various phenomena (plasma kinetic instabilities, charge-exchange processes during the plasma ion interaction with the HA walls, and the model of neutral atoms ionization inside the Debay's sphere), which could be responsible for such ion temperature, were considered.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Electron beam and plasma modes of a channel spark discharge operation

Parameters of a modified pulsed channel spark discharge (CSD), operating at a repetition rate up to 100 Hz at Ar gas pressures of 10{sup -3} and 10{sup -4} Torr and of the generated electron beam, were studied using different electrical, optical, and x-ray diagnostics. It was shown that efficient (up to approx74%) transfer of the initially stored energy to the energetic electron beam is realized only at the pressure of 10{sup -4} Torr. Conversely, at the pressure of 10{sup -3} Torr, less than 10% of the stored energy is acquired by the energetic electrons. It was found that the energetic electron beam generation is limited by the expansion of the cathode and anode plasmas and by the formation of plasma inside the gap between the CSD capillary output and the anode. It was also found that the plasma, which acquires the hollow cathode potential, is already formed at the beginning of the CSD operation inside the capillary, and the electron emission occurs from the capillary output plasma boundary. Finally, it was shown that the electron beam energy spectrum differs significantly from the energy spectrum, which one may expect in the case of the planar diode operation.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

Pulsed plasma electron sources

There is a continuous interest in research of electron sources which can be used for generation of uniform electron beams produced at E{<=}10{sup 5} V/cm and duration {<=}10{sup -5} s. In this review, several types of plasma electron sources will be considered, namely, passive (metal ceramic, velvet and carbon fiber with and without CsI coating, and multicapillary and multislot cathodes) and active (ferroelectric and hollow anodes) plasma sources. The operation of passive sources is governed by the formation of flashover plasma whose parameters depend on the amplitude and rise time of the accelerating electric field. In the case of ferroelectric and hollow-anode plasma sources the plasma parameters are controlled by the driving pulse and discharge current, respectively. Using different time- and space-resolved electrical, optical, spectroscopical, Thomson scattering and x-ray diagnostics, the parameters of the plasma and generated electron beam were characterized.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗