Search NASA⌕ Search

Engineering topics

Yatom, Shurik

Publications and source records attributed to Yatom, Shurik.

12 records
All sourcesNASA NTRSDOE OSTI
DOE OSTI2024

Report on laser-induced fluorescence transitions relevant for the microelectronics industry and sustainability applications

A wide variety of feed gases are used to generate low-temperature plasmas for the microelectronics and sustainability applications. These plasmas often have a complex combination of reactive and nonreactive species which may have spatial and temporal variations in density, temperature, and energy. Accurate knowledge of these parameters and their variations is critically important for understanding and advancing these applications through validated and predictive modeling and the design of relevant devices. Laser-induced fluorescence (LIF) provides both spatial and temporally resolved information about the plasma-produced radicals, ions, and metastables. However, the use of this powerful diagnostic tool requires the knowledge of optical transitions including excitation and fluorescence wavelengths which may not be available or scattered through a huge literature domain. In this paper, we collected, analyzed, and compiled the available transitions for laser-induced fluorescence for more than 160 chemical species relevant to the microelectronics industry and the sustainability applications. A list of species with overlapping LIF excitations and fluorescence wavelengths have been identified. Finally, this summary is intended to serve as a data reference for LIF transitions and should be updated in the future.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗
DOE OSTI2024

Importance of gas heating in capacitively coupled radiofrequency plasma-assisted synthesis of carbon nanomaterials

In pursuit of diamond nanoparticles, a capacitively-coupled radio frequency flow-through plasma reactor was operated with methane-argon gas mixtures. Signatures of the final product obtained microscopically and spectroscopically indicated that the product was an amorphous form of graphite. This result was consistent irrespective of combinations of the macroscopic reactor settings. To explain the observed synthesis output, measurements of C 2 and gas properties were carried out by laser-induced fluorescence and optical emission spectroscopy. Strikingly, the results indicated a strong gas temperature gradient of 100 K per mm from the center of the reactor to the wall. Based on additional plasma imaging, a model of hot constricted region (filamentation region) was then formulated. It illustrated that, while the hot constricted region was present, the bulk of the gas was not hot enough to facilitate diamond sp 3 formation: characterized by much lower reaction rates, when compared to sp 2 , sp 3 formation kinetics are expected to become exponentially slow. This result was further confirmed by experiments under identical conditions but with a H 2 /CH 4 mixture, where no output material was detected: if graphitic sp 2 formation was expected as the main output material from the methane feedstock, atomic hydrogen would then be expected to etch it away in situ, such that the net production of that sp 2 -hybridized solid material is nearly a zero. Finally, the crucial importance of gas heating was corroborated by replacing RF with microwave source whereby facile sp 3 production was attained with H 2 /CH 4 gas mixture.

36 MATERIALS SCIENCE↗
DOE OSTI2024

Effects of Halides on Organic Compound Degradation during Plasma Treatment of Brines

Plasma has been proposed as an alternative strategy to treat organic contaminants in brines. Chemical degradation in these systems is expected to be partially driven by halogen oxidants, which have been detected in halide-containing solutions exposed to plasma. In this study, we characterized specific mechanisms involving the formation and reactions of halogen oxidants during plasma treatment. Here, we first demonstrated that addition of halides accelerated the degradation of a probe compound known to react quickly with halogen oxidants (i.e., para -hydroxybenzoate) but did not affect the degradation of a less reactive probe compound (i.e., benzoate). This effect was attributed to the degradation of para-hydroxybenzoate by hypohalous acids, which were produced via a mechanism involving halogen radicals as intermediates. We applied this mechanistic insight to investigate the impact of constituents in brines on reactions driven by halogen oxidants during plasma treatment. Bromide, which is expected to occur alongside chloride in brines, was required to enable halogen oxidant formation, consistent with the generation of halogen radicals from the oxidation of halides by hydroxyl radical. Other constituents typically present in brines (i.e., carbonates, organic matter) slowed the degradation of organic compounds, consistent with their ability to scavenge species involved during plasma treatment.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
DOE OSTI2023

Schottky effect on the wavelength threshold for the photo-detachment from charged metallic nanoparticles

Abstract Laser-stimulated electron photo-detachment (LSPD) from nanoscale dust particles is predicted to strongly depend on the particle size. A theory of the electron photo-detachment from charged spherical metallic nanoparticles is presented. This theory is relevant to laser-stimulated photo-detachment applied to measurements of charge of nanoparticles in plasmas. Our theory predicts that the charging of nanoparticles in plasma leads to the appearance of an additional electric field, causing a change in the potential barrier at the particle boundary and consequently, a change in the effective work function, due to the Schottky effect. In this case, the critical wavelength of the laser depends not only on the work function, but also on the charge of the nanoparticles and their size.

42 ENGINEERING↗
DOE OSTI2023

Diagnostics of plasma–liquids systems: Challenges and their mitigation

This article will review two popular methods of laser diagnostics in a plasma–liquid system and generally in low-temperature plasmas. These are Thomson scattering and laser-induced fluorescence. Setting up the plasma–liquid interaction experiment will be described while stressing the important points for laser diagnostics and maintaining conditions for correct and repeatable measurements. In this work, I will discuss the caveats that are encountered when measuring an inherently unstable and collisional system, such as plasma interacting with the liquid and how these challenges impact that data analysis and calibration efforts for these two-diagnostic approaches.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗
DOE OSTI2022

Measurements of OH radical concentrations in uniform and non-uniform nanosecond-pulsed dielectric barrier discharge plasma

In this work we studied OH radical generation in nanosecond dielectric barrier discharge in humid He/air gas. The measurements were carried out by means of laser-induced fluorescence (LIF) method at the PPPL Low Temperature Plasma Research Facility, directed by Dr. Shurik Yatom. Application of LIF towards OH density measurements is a widely used approach in plasmas generated in humid gas, particularly when temporal evolution of OH density is of interest. Here we examined the OH densities generated in the discharge ignited by application of nanosecond high-voltage pulses with amplitudes varying between 10 to 20 kV and interelectrode gap length varying between 0.5-3 mm. The peak voltage and the gap length determine the mode in which discharge is generated: homogenous or filamentary. The measurements of OH in the gas phase were accompanied by the measurements of hydrogen peroxide (H 2 O 2 ) in liquid water, downstream of the plasma and the relationship between these two were examined.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗
DOE OSTI2022

Examination of OH and H 2 O 2 production by uniform and non-uniform modes of dielectric barrier discharge in He/air mixture

In this work we have carried out a parametrical study of hydroxyl radical (OH) generation in nanosecond dielectric barrier discharge (DBD) in He/air mixture using a laser-induced fluorescence approach. Specifically, the foci of the study are the investigation of differences between uniform and non-uniform modes of the discharges and the difference in production of OH and H 2 O 2 Nanosecond-time scale imaging of the discharge shows transition from streamer to diffuse mode when applied electric field to the discharge gap approaches ~90 kV cm –1 . The results show that both OH production in the gas phase and downstream H 2 O 2 delivery rates to liquid depend on the discharge mode operation and are respectively 30% and 3 times higher for the non-uniform DBD compared to the diffuse discharge.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗
DOE OSTI2022

Effects of frequency and pulse width on electron density, hydrogen peroxide generation, and perfluorooctanoic acid mineralization in a nanosecond pulsed discharge gas-liquid plasma reactor

Plasma electron density and temperature were characterized in a continuous flowing gas-liquid film reactor with argon carrier gas by time-resolved optical emission spectroscopy. The plasma parameters were studied as a function of time for varying pulse widths and frequencies. Pulse frequency was varied between 1 and 10 kHz at 16 kV (input voltage) and 40 ns (pulse width) using an Eagle Harbor Technologies, Inc. (EHT) power supply and 5–100 kHz using an Airity Technologies, LLC (AT) power supply. The pulse width was varied between 40 and 200 ns at 16 kV, 2 kHz with the EHT power supply. Optimal frequencies of 5 and 20 kHz were observed for peak electron density with EHT and AT power supplies, respectively. The peak electron density increased with increasing pulse width between 40 and 200 ns using the EHT power supply. Hydrogen peroxide exiting the reactor in the liquid phase increased with discharge power irrespective of the power supply or pulse parameters. Mineralization of 12.5, 50, and 200 ppm perfluorooctanoic acid (PFOA) dissolved in DI water to fluoride (F - ) correlated to the peak electron density. Glycerol, a liquid-phase hydroxyl radical scavenger, depleted hydrogen peroxide but did not affect PFOA mineralization. CO, a gas-phase hydroxyl radical scavenger, led to a reduction in the formation of F - production, suggesting hydroxyl radicals in the gas-liquid film play a necessary, but not singular, role in mineralization of PFOA.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗
DOE OSTI2022

Plasma parameters and the reduction potential at a plasma-liquid interface

We report nonthermal plasmas in contact with liquids have been shown to generate a variety of reactive species capable of initiating reduction–oxidation (redox) reactions at the electrochemically active plasma–liquid interface. In conventional electrochemical cells, selective redox chemistry is achieved by controlling the reduction potential at the solid electrode–electrolyte interface by applying a bias via an external circuit. In the case of plasma–liquid systems, an analogous means of tuning the reduction potential near the interface has not clearly been identified. When treated as a floating surface, the liquid is expected to adopt a net negative charge to balance the flux of hot electrons and relatively cold positive ions. The reduction potential near the plasma–liquid interface is hypothesized to be proportional to the floating potential, which can be approximated using an analytical model provided the plasma parameters are known. Herein, we present a framework for correlating the electron density and electron temperature of a noble gas plasma jet to the reduction potential near the plasma–liquid interface. The plasma parameters were acquired for an argon atmospheric plasma jet in contact with an aqueous solution by means of laser Thomson scattering. The reduction potential was determined using identical reference electrodes to measure the potential difference between the plasma–liquid interface and bulk solution. Interestingly, the measured reduction potentials near the plasma–liquid interface were found to be in good agreement with the model-predicted values determined using the plasma parameters obtained from the Thomson scattering experiments.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗
DOE OSTI2022

Characterization of plasma in RF jet interacting with water: Thomson scattering versus spectral line broadening

Here, we carry out a detailed characterization of an Ar radiofrequency plasma jet interacting with liquid. The focus of the paper is measurement of the electron density by examining the Stark broadening of hydrogen Balmer α line and Thomson scattering (TS). Supporting diagnostics are done to investigate the channel evolution and movement, and gas temperature. The comparison of the two approaches shows the caveats and the advantages that should gain attention in future applications. In particular, the plasma channel dynamics have a significant impact on the TS signal and may result in physical phenomena being missed due to channel dislocations. The conclusions of the work elucidate the pitfalls for interpreting the results of TS when the discharge is a dynamic filamentary plasma. This work establishes the temporal evolution of the plasma and the gas parameters in a plasma–liquid system employed for investigation of plasma-induced electrodeless electrochemistry.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗