Search NASA⌕ Search

Engineering topics

Yiwen Zhou

Publications and source records attributed to Yiwen Zhou.

10 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS2024

The Dielectric Constant at P-Band for Salinity from 0 to 150 pss

Measurements have been made at P-band (0.707 GHz) to construct a model for the dielectric constant of sea water and extend the model for the dielectric constant to high salinity (50-150 pss). The measurements are part of research to develop a model for the dielectric constant suitable for future wide-bandwidth remote sensing of salinity and for application to water bodies such as the Great Salt Lake with salinity significantly above that found in the open ocean. Measurements have been made at temperatures from 2 to 30 °C and salinity from 0 to 138 pss. The data have been fit to a Debye model for the dielectric constant with a single resonance as has been employed at L-band (1.413 GHz) where remote sensing of salinity is currently done. Comparison with contemporary models developed from data at L-band indicates that the L-band model and new P-band model do well at both frequencies for salinity less than 50 pss but at higher values of salinity the L-band models diverge from the data. The data has also been used to test at high salinity the mathematical relationship between salinity and conductivity which is the basis for the practical salinity scale (pss).

Dielectric Constant↗
NASA NTRS2023

New Seawater Dielectric Constant Parametrization and Application to SMOS Retrieved Salinity

The accuracy of the Sea Surface Salinity (SSS) retrieved from L-Band radiometer measurements is strongly dependent on the reliability of the dielectric constant model. Two new parametrizations were recently developed based on one hand on the Soil Moisture and Ocean Salinity (SMOS) satellite multi-angular brightness temperature measurements by Boutin et al. (2021) (BV), and on the other hand, on new George Washington University laboratory measurements by Zhou et al. (2021) (GW2020). These two approaches are fully independent. For most SSS and Sea Surface Temperature (SST) conditions commonly observed over the open ocean, the relative variations of brightness temperatures Tb simulated through the BV and GW2020 parametrizations agree particularly well, and better than with earlier parametrizations previously used in the SMOS, Soil Moisture Active Passive (SMAP) and Aquarius SSS retrievals. Nevertheless, uncertainty remains, especially below 10 °C where a ∼ 0.1 K relative difference between the two models is observed. This motivates the development of a revised parameterization, BVZ, based on a methodology similar to that used to derive BV but using GW2020 instead of SMOS measurements. Compared to the GW2020 parameterization, BVZ is derived with a reduced number of degrees of freedom, it relies on the TEOS10 PSS78 conductivity-salinity relationship, and on the previously derived static permittivity of fresh water. One month per season of SMOS data have been reprocessed in 2018 using BV, GW2020, and BVZ. We find the best overall agreement between SMOS SSS and Argo SSS with BVZ parametrization, with noticeable improvement in the 5 °C–15 °C SST range.

sea measurements↗
NASA NTRS2022

Model for Dielectric Constant of Seawater based on L-band Measurements with Conductivity by Definition

This article reports an improvement in the model for the dielectric constant of seawater used to fit laboratory measurements of the dielectric constant at the L-band. The new model (dielectric constant as a function of salinity, temperature, and frequency) is based on the response of a polar molecule proposed by Debye and fits the same measurement as reported in earlier work but uses a functional form for conductivity, σ(S,T) , that is given by the definition of salinity. The new version of this model fits the data well and has the advantages that the relaxation time constant is allowed to be a function of temperature and salinity and is well behaved when extrapolated to high salinities.

L-band↗
NASA NTRS2022

A Cavity System for Seawater Dielectric Measurements at P-Band

This paper describes a new system for measuring the dielectric constant of seawater near 700 MHz. The purpose of this research is to obtain data at P-band for the dielectric constant of seawater that can be combined with previous L-band data for developing a model function valid from 500 MHz to 2000 MHz. A transmission-type cylindrical cavity has been constructed with the TM010 mode resonance occurring near 700 MHz. The seawater is introduced via a capillary quartz tube. The dimensions of the cavity have been determined by electromagnetic modelling. The model takes the cavity wall loss into account and can provide accurate estimation of resonance condition for both the empty cavity and cavity with seawater. The errors between the theory and measurement are about 0.07% for the resonant frequency and 0.4% for the quality factor, Q. The cavity design, experimental setup and measurement schedule will be presented in the paper.

Roger Lang↗
NASA NTRS2022

Status of the Dielectric Constant of Sea Water at L-Band for Remote Sensing of Salinity

The model expressing the dielectric constant of sea water at microwave frequencies as a function of salinity and temperature is an important element in remote sensing of sea surface salinity. It is also important independently as a description of the physical properties of salt water. A major milestone was the development in the late 1970s by Klein and Swift of a model based on laboratory measurements at L- and S-band and a functional form supported by theory for polar molecules and previous work on freshwater. Much of the subsequent work has focused on measurements at higher frequency and determining model parameters tuned to apply for applications, such as remote sensing of sea surface temperature (SST). Interest in the dielectric constant at 1.4 GHz (L-band) increased again with the development of soil moisture ocean salinity (SMOS) and Aquarius to measure salinity from space, but there have been few new measurements at L-band and often confusion regarding the applicability of new models at 1.4 GHz. The objective of this article is to compare available models in the context of how well they represent the dielectric constant of sea water at 1.4 GHz. Among the criteria applied will be the recent measurements at the George Washington University of the dielectric constant at 1.4 GHz

Microwave Remote Sensing↗
NASA NTRS2021

Debye Dielectric Model Function for Seawater Based on Expanded L-Band Measurement Data Set

New seawater dielectric measurements have recently been made over a broad range of salinities and temperatures at the George Washington University (GW). These measurements have been used to refine the existing dielectric model function of seawater for salinity retrieval. The mathematical structure of the new model function has been investigated to: (a) look for a physical basis for the mathematical form; and (b) to optimize the accuracy of data fitting. The Debye model has been chosen to represent the dielectric constant of seawater as a function of salinity (S), temperature (T) and frequency (f). The retrieved salinity using the Debye model has good agreement with the in-situ data collected by Argo floats. The global differences in retrieved salinity and in-situ data will be presented at the meeting.

ocean salinity↗
NASA NTRS2021

Seawater Debye Model Function at L-Band and Its Impact on Salinity Retrieval From Aquarius Satellite Data

A model function of seawater, which specifies the dielectric constant of seawater as a function of salinity, temperature, and frequency, is important for the retrieval of sea surface salinity using satellite data. In 2017, a model function has been developed based on measurement data at 1.4134 GHz using a third-order polynomial expression in salinity ( S ) and temperature ( T ). Although the model showed improvements in salinity retrieval, it had an inconsistent behavior between partitioned salinities. To improve the stability of the model, new dielectric measurements of seawater have been made recently over a broad range of salinities and temperatures to expand the data set used for developing the model function. The structure of the model function has been changed from a polynomial expansion in S and T to a physics-based model consisting of a Debye molecular resonance term plus a conductivity term. Each unknown parameter is expressed in S and T based on the expanded measurement data set. Physical arguments have been used to limit the number of unknown coefficients in these expressions to improve the stability of the model function. The new model function has been employed in the retrieval algorithm of the Aquarius satellite mission to obtain a global salinity map. The retrieved salinity using a different model function is compared with in situ data collected by Argo floats to evaluate the impact and the performance of model functions. The results indicate that the new model function has significant improvements in salinity retrieval compared with other existing models.

Seawater↗
NASA NTRS2020

The Backscattering Contribution of Soybean Pods at L-band

L-band (1.25 GHz) radar measurements of a soybean canopy indicate that the emergence of seed pods is a significant contributor to the backscatter during the late stages of the growing season. In order to validate the measured data, a realistic scattering model of the soybean canopy is developed. The parameters of the soybean canopy and underlying soil used in the model vary over the growing season based on in situ measurements. Scattering amplitudes for soybean leaves are modeled analytically by using a thin disk approximation; stem and pods are jointly modeled using a numerical electromagnetic field solver. These scattering amplitudes are together incorporated into a coherent scattering model to obtain the backscattering coefficient for VV- and HH-polarizations. The modeling results show good agreement with the radar field measurements, having RMSEs of 0.51 dB for VV-pol and 1.1 dB for HH-pol. Both measured data and modeled results show that the change of soil moisture can be accurately monitored by L-band backscatter. It is also found that the difference between HH- and VV-polarized backscatter increases as the size of the soybean pods becomes larger. A method is developed here to estimate the number of pods in a soybean canopy based on polarimetric radar backscatter at L-band.

Radar backscatter↗
NASA NTRSDate not supplied

Active/Passive Remote Sensing of a Mature Soybean Canopy at L-band

This paper reports on development of a scattering model of a soybean canopies at L-band. The scattering model will be used for active and passive remote sensing of soybean plants with an emphasis on mature soybeans where the presence of pods is important to the observed microwave signal. The active problem is treated using the Distorted Born Approximation (DBA) and the passive problem is analyzed using Peake's method. These results are compared with field measurements made in 2012 by the truck-mounted ComRAD system, which is a combined radar and radiometer instrument operating at L-band. Investigation of backscatter from the soybean canopy shows good agreement between the radar measurement data and modeling results. The results also indicate that the L-band radar backscatter can be used to monitor both the soil moisture and the growth of the soybean pods. Past passive modeling efforts have not considered soybeans late in the growing season when pods are important. A new passive radiation model of soybean canopy will be developed based on the backscatter model.

Yiwen Zhou↗