Search NASA⌕ Search

Engineering topics

Yon, Steven

Publications and source records attributed to Yon, Steven.

Impulsive Start of a Symmetric Airfoil at High Angle of Attack

The fluid dynamic phenomena following the impulsive start of a NACA 0015 airfoil were studied by using a time accurate solution of the incompressible laminar Navier-Stokes equations. Angle of attack was set at 10 deg to simulate steady-state poststall conditions at a Reynolds number of 1.2 x 10(exp 4). The calculation revealed that large initial lift values can be obtained, immediately following the impulsive start, when a trapped vortex develops above the airfoil. Before the buildup of this trapped vortex and immediately after the airfoil was set into motion, the fluid is attached to the airfoil's surface and flows around the trailing edge, demonstrating the delay in the buildup of the classical Kutta condition. The transient of this effect is quite short and is followed by an attached How event that leads to the trapped vortex that has a longer duration. The just described initial phenomenon eventually transits into a fully developed separated flow pattern identifiable by an alternating, periodic vortex shedding.

Katz, Joseph↗

Effect of airfoil (trailing-edge) thickness on the numerical solution of panel methods based on the Dirichlet boundary condition

The practical limit of airfoil thickness ratio for which acceptable engineering results are obtainable with the Dirichlet boundary-condition-based numerical methods is investigated. This is done by studying the effect of thickness on the calculated pressure distribution near the trailing edge and by comparing the aerodynamic coefficients with available exact solutions. The first objective of this study, owing to the wide use of such computational methods, is to demonstrate the numerical symptoms that occur when the body or wing thickness approaches zero and to increase the awareness of potential users of these methods. Additionally, an effort is made to obtain the practical limits of the trailing-edge thickness where such problems will appear in the flow solution, and to propose some possible cures for very thin airfoils or those with cusped trailing edges.

Yon, Steven↗

Unsteady fluid dynamic model for propeller induced flow fields

A potential flow based three-dimensional panel method was modified to treat time dependent flow conditions in which the body's geometry may vary with time. The main objective of this effort was the study of a flow field due to a propeller rotating relative to a nonrotating body which is otherwise moving at a constant forward speed. Calculated surface pressure, thrust and torque coefficient data for a four-bladed marine propeller/body compared favorably with previously published experimental results.

Katz, Joseph↗