Search NASA⌕ Search

Engineering topics

Yoon, Tae Jun

Publications and source records attributed to Yoon, Tae Jun.

8 records
All sourcesNASA NTRSDOE OSTI
DOE OSTI2022

A novel approach for produced water treatment: Supercritical water oxidation and desalination

Produced water generated from oil and gas operations contains significant quantities of environmentally hazardous hydrocarbons, organic chemicals, and inorganic salts. Environmental regulations with impaired water disposal mandates produced water treatment and desalination. Industry standard desalination technologies are energy-intensive and mandate extensive produced water pre-treatment including removal of hydrocarbons constituents for efficient operations. Herein this study investigates a novel process intensification approach integrating supercritical water oxidation (SCWO) unit operation with a supercritical water desalination (SCWD) process for energy efficient produced water treatment and desalination. The coupled SCWD-SCWO process is found to be very energy-efficient and cost effective than existing industry standard desalination technologies. For energy efficient operation, the heat generated from the SCWO of hydrocarbons present in the produced water is used for power generation using a high efficiency and low-cost re-heat Rankine cycle process. The cost of treating produced water with proposed SCWO-SCWD process is independent of the salt concentration. The proposed process has the potential to offer step-change improvements over conventional processes in both the efficiency and cost of produced water treatment: for example, a cost and energy saving of 70% and 100% is calculated for the treatment of produced water containing 250 g/l salt and 10.6 g/l hydrocarbon.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
DOE OSTI2022

Electrical Conductivities and Association Constants in Dilute Aqueous NdCl 3 Solutions from 298 to 523 K along an Isobar of 25 MPa

Here, electrical measurements were performed in dilute aqueous NdCl 3 solutions from 298 to 523 K along the 25 MPa isobar to obtain limiting conductivities and association constants. The specific conductivity data were estimated using a continuous flow cell and a Markov Chain Monte Carlo (MCMC) correction algorithm. The limiting conductivities for the salts in water were derived by regressing the mean spherical approximation model and speciation analyses based on the MCMC algorithm and the deep earth water model. The limiting conductivities derived from the experimental data were correlated using the Zimmerman-Arcis-Tremaine correlation and agreed well with a predictive correlation proposed by Smolyakov, Anderko, and Lencka. Only the first association constant between neodymium and chloride could be derived at low temperatures (<373 K) due to the apparent large statistical uncertainty of the second association constant. Above 373 K, both association constants could be derived and show a reasonable agreement with Migdisov and Williams-Jones and Gammons et al.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
DOE OSTI2022

An in-situ conductometric apparatus for physicochemical characterization of solutions and in-line monitoring of separation processes at elevated temperatures and pressures

Specific conductance and frequency-dependent resistance (impedance) data are widely utilized for understanding the physicochemical characteristics of aqueous and non-aqueous fluids and for evaluating the performance of chemical processes. However, the implementation of such an in-situ probe in high-temperature and high-pressure environments is not trivial. This work provides a description of both the hardware and software associated with implementing a parallel-type in-situ electrochemical sensor. The sensor can be used for in-line monitoring of thermal desalination processes and for impedance measurements in fluids at high temperature and pressure. Further, a comparison between the experimental measurements on the specific conductance in aqueous sodium chloride solutions and the conductance model demonstrate that the methodology yields reasonable agreement with both the model and literature data. A combination of hardware components, a software-based correction for experimental artifacts, and computational fluid dynamics (CFD) calculations used in this work provide a sound basis for implementing such in-situ electrochemical sensors to measure frequency-dependent resistance spectra.

47 OTHER INSTRUMENTATION↗
DOE OSTI2021

Energy efficient supercritical water desalination using a high-temperature heat pump: A zero liquid discharge desalination

Supercritical water desalination (SCWD) is zero liquid discharge technology that can potentially control the solubility of different electrolytes. However, SCWD is an energy-intensive process and requires high-quality thermal heat (> 450 °C). This study proposes the integration of a high-temperature heat pump to reduce the SCWD energy requirement. The integrated system energy consumption improves by 36% for 3.5% feed concentration and 14% for 20% feed, and the distillate cost reduces by 15% and 10%. Another benefit of the proposed integration is the system can be operated using only electricity as a heat source, as is the case with commonly used high-recovery thermal desalination technology. The integrated SCWD-heat pump system shows superior performance compared to the commercially used brine concentrator and crystallizer system. It is approximately 20% more energy-efficient for 25% feed concentration and 8% cheaper. Hence, the integrated SCWD-heat pump has the potential to outperform the pre-existing high-recovery desalination technology.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
DOE OSTI2021

NaCl aggregation in water at elevated temperatures and pressures: Comparison of classical force fields

The properties of water vary dramatically with temperature and density. This can be exploited to control its effectiveness as a solvent. Thus, supercritical water is of keen interest as solvent in many extraction processes. The low solubility of salts in lower density supercritical water has even been suggested as a means of desalination. The high temperatures and pressures required to reach supercritical conditions can present experimental challenges during collection of required physical property and phase equilibria data, especially in salt-containing systems. Molecular simulations have the potential to be a valuable tool for examining the behavior of solvated ions at these high temperatures and pressures. However, the accuracy of classical force fields under these conditions is unclear. We have, therefore, undertaken a parametric study of NaCl in water, comparing several salt and water models at 200 bar–600 bar and 450 K–750 K for a range of salt concentrations. We report a comparison of structural properties including ion aggregation, hydrogen bonding, density, and static dielectric constants. All of the force fields qualitatively reproduce the trends in the liquid phase density. An increase in ion aggregation with decreasing density holds true for all of the force fields. The propensity to aggregate is primarily determined by the salt force field rather than the water force field. This coincides with a decrease in the water static dielectric constant and reduced charge screening. While a decrease in the static dielectric constant with increasing NaCl concentration is consistent across all model combinations, the salt force fields that exhibit more ionic aggregation yield a slightly smaller dielectric decrement.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
DOE OSTI2020

Thermodynamics, dynamics, and structure of supercritical water at extreme conditions

Molecular dynamics (MD) simulations to understand the thermodynamic, dynamic, and structural changes in supercritical water across the Frenkel line and the melting line have been performed. The two-phase thermodynamic model [J. Phys. Chem. B(2010), 114(24), 8191-8198] and the velocity autocorrelation functions are used to locate the Frenkel line and to calculate the thermodynamic and dynamic properties. The Frenkel lines obtained from the two-phase thermodynamic model and the velocity autocorrelation criterion do not agree with each other. Structural characteristics and the translational diffusion dynamics of water suggest that this inconsistency could arise from the two oscillatory modes in water, which are associated with the bending of hydrogen bonds and intermolecular collisions inside the first coordination shell. Finally, the overall results lead us to conclude that the universality of the Frenkel line as a dynamic crossover line from rigid to nonrigid fluids is preserved in water.

74 ATOMIC AND MOLECULAR PHYSICS↗
DOE OSTI2019

Electrical conductivity, ion pairing, and ion self-diffusion in aqueous NaCl solutions at elevated temperatures and pressures

We have performed classical molecular dynamics (MD) simulations of aqueous sodium chloride (NaCl) solutions from 298 to 674 K at 200 bars to understand the influence of ion pairing and ion self-diffusion on electrical conductivity in high-temperature/high-pressure salt solutions. Conductivity data obtained from the MD simulation highlight an apparent anomaly, namely, a conductivity maximum as temperature increases along an isobar, which has been also observed in experimental studies. By examining both velocity autocorrelation and cross-correlation terms of the Green-Kubo integral, we quantitatively demonstrate that the conductivity anomaly arises mainly from a competition between the single-ion self-diffusion and the contact ion pair formation. The velocity autocorrelation function in conjunction with structural analysis suggests that diffusive motion of ions is suppressed at high temperatures due to the persistence of an inner hydration shell. Here, the contribution of velocity cross-correlation functions between oppositely charged ions becomes significant at the onset of the conductivity decrease. Structural analysis based on Voronoi tessellation and pair correlation functions indicates that the fraction of contact ion pairs increases as temperature increases. Spatial decomposition of the electrical conductivity also indicates that the formation of contact ion pairs significantly decreases the electrical conductivity compared to Nernst-Einstein conductivity, but the contribution of distant opposite charges cannot be ignored except at the highest temperature due to unscreened long-range interactions.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗