Engineering topics

Yorkshire, Antonia S.

Publications and source records attributed to Yorkshire, Antonia S..

3 records

DOE OSTI2023

Spectroscopic identification of Ca-bearing uranyl silicates formed in C–S–H systems

Portland cement-based grouts used for radioactive waste immobilisation contain a Ca- and Si-rich binder phase, known as calcium–silicate–hydrate (C–S–H). Depending on the blend of cement used, the Ca/Si ratio can vary considerably. A range of C–S–H minerals with Ca/Si ratios from 0.6 to 1.6 were synthesised and contacted with aqueous U(VI) at 0.5 mM and 10 mM concentrations. Solid-state 29 Si MAS-NMR spectroscopy was applied to probe the Si coordination environment in U(VI)-contacted C–S–H minerals and, in conjunction with U L III -edge X-ray absorption spectroscopy analysis, inferences of the fate of U(VI) in these systems were made. At moderate or high Ca/Si ratios, uranophane-type uranyl silicates or Ca-uranates dominated, while at the lowest Ca/Si ratios, the formation of a Ca-bearing uranyl silicate mineral, similar to haiweeite (Ca[(UO 2 ) 2 Si 5 O 12 (OH) 2 ]·3H 2 O) or Ca-bearing weeksite (Ca 2 (UO 2 ) 2 Si 6 O 15 ·10H 2 O) was identified. This study highlights the influence of Ca/Si ratio on uranyl sequestration, of interest in the development of post-closure safety models for U-bearing radioactive waste disposal.

12 MANAGEMENT OF RADIOACTIVE AND NON-RADIOACTIVE W↗

DOE OSTI2021

Mechanical and physical properties of inorganic polymer cement made of iron-rich laterite and lateritic clay: A comparative study

In this work, two different laterites (iron contents of 13.07 and 49.34 wt%, respectively, for lateritic clay, LAC, and iron-rich laterite, LAI) were selected and calcined at 600 °C. The obtained calcined laterites, namely LAI600 and LAC600, were separately mixed with an alkaline solution (silicate modulus of 1.35) or an acidic solution (phosphoric acid solution at pH ≤ 2) for the synthesis of inorganic polymer products. The fabricated products were cured at 20 °C (ambient) and 40 °C (oven). The obtained results showed that the compressive strength of each series of alkaline-based inorganic polymer binder increased with ageing time (7 and 28 days) for room temperature curing, while the reverse trend was noted for oven-cured specimens. The best mechanical performance was obtained when using a phosphoric acid solution, 38 and 52 ± 1 MPa; 62 and 65 ± 1 MPa at 28 days for LAC and LAI respectively. It appeared that a higher iron content within the laterite contributed to an increase in the compressive strength under acidic conditions (LAI (59 MPa) > LAC (48 MPa)) compared to the behavior obtained under alkaline conditions (LAI (6 MPa) < LAC (29 MPa)). Accordingly, the acidic products exhibited a dense structure (with lower porosity) and contained amorphous iron/aluminium phosphate phases such as berlinite (FePO{sub 4}), iron hydrogen phosphate hydrate (Fe{sub 3}H{sub 15}(PO{sub 4}){sub 8·}4H{sub 2}O), ferrowyllieite (AlFe{sub 2}Na{sub 2}(PO{sub 4}){sub 3}) and sodium iron phosphate (Na{sub 3}Fe{sub 2}(PO{sub 4}){sub 3}) arising from the alteration of iron minerals in an acidic medium, confirmed by Mössbauer spectroscopy and electron paramagnetic resonance spectroscopy.

36 MATERIALS SCIENCE↗

DOE OSTI2020

Immobilizing Pertechnetate in Ettringite via Sulfate Substitution

Until recently, a nuclear waste form did not exist for the immobilization and long-term storage of the anionic form of radionuclide technetium-99 (99Tc), pertechnetate (TcO 4 - ). Across international nuclear waste sites, the inability to capture TcO 4 - poses a threat to the local environment due to the anion’s long half-life and environmental mobility under environmentally oxic conditions. To combat this challenge, most waste forms would capture 99Tc using materials that reduce TcO 4 - to Tc(IV) species, e.g. 99Tc oxides or 99Tc sulfides. However, this is a short-lived solution unless reducing capacities can be regenerated to last over the long life expectancy of some nuclear waste forms (~10,000 years). In light of recent experimental observations gained from the development of cementitious waste forms and unconfirmed hypotheses from the literature, this work explores how ettringite, a common mineral formed in cementitious materials with demonstrated success in incorporating oxyanions, may be used to immobilize TcO 4 - directly and over the life-time of the waste form. Using batch precipitation experiments, solid phase characterization techniques, and ab initio molecular dynamics simulations, we demonstrate herein successful incorporation of TcO 4 - into ettringite via substitution for SO 4 2- within the ettringite crystal structure. Here, these results are first of their kind and confirm the hypothesis that ettringite acts as an immobilizing mineral within cementitious waste forms for the highly mobile TcO 4 - oxyanion, enhancing the overall performance of these waste forms over time.

36 MATERIALS SCIENCE↗