Search NASA⌕ Search

Engineering topics

You, Kehua

Publications and source records attributed to You, Kehua.

At least 19 records

Dating submarine landslides using the transient response of gas hydrate stability

Abstract Submarine landslides are prevalent on the modern-day seafloor, yet an elusive problem is constraining the timing of past slope failure. We present a novel age-dating technique based on perturbations to underlying gas hydrate stability caused by slide-impacted seafloor changes. Using three-dimensional (3-D) seismic data, we mapped an irregular bottom simulating reflection (BSR) underneath a submarine landslide in the Orca Basin, Gulf of Mexico. The irregular BSR mimics the pre-slide seafloor geometry rather than the modern bathymetry. Therefore, we suggest that the gas hydrate stability zone (GHSZ) is still adjusting to the post-slide sediment temperature. We applied transient conductive heat-flow modeling to constrain the response of the GHSZ to the slope failure, which yielded a most likely age of ca. 8 ka, demonstrating that gas hydrate can respond to landslides even on multimillennial time scales. We further provide a generalized analytical solution that can be used to remotely date submarine slides in the absence of traditional dating techniques.

Geology↗

Three-Dimensional Free Gas Flow Focuses Basin-Wide Microbial Methane to Concentrated Methane Hydrate Reservoirs in Geological System

Here, we present a systematic model that links the generation, migration, phase partitioning, and accumulation of methane into a closed loop as the sediment is deposited from the seafloor and buried through the base of hydrate stability zone (BHSZ). In our model, methane is generated by biodegradation of organic carbon in muds. Hydrate does not form and methane is not trapped until a coarse-grained layer is deposited, because the small pores prevent hydrate formation in muds. Instead, methane diffuses into sands/silts where methane solidifies into hydrate. As hydrate-bearing sands/silts pass through the BHSZ during sediment burial, methane hydrate dissociates, and releases free gas. The released and the newly generated free gas below the BHSZ concentrates into a vertical/dipping zone with low capillary entry pressure and high permeability and flows upward driven its buoyancy. When free gas reaches the hydrate stability zone (HSZ), capillary forces drive free gas to flow laterally, preferentially enter sands/silts, feed hydrate growth, and elevate hydrate saturation. With three-dimensional focused free gas flow, microbial methane that is generated from a much larger fetch area of the entire basin, both above and below the BHSZ, is concentrated into coarse-grained layers at structural closures for hydrate formation. Our model illustrates how geological evolution, microbial methane generation, and gas flow by buoyancy couple to generate concentrated hydrate deposits in geological system. These insights can be used to explore for high-concentration methane hydrate and are important for understanding the methane budget and carbon cycle under the seafloor.

58 GEOSCIENCES↗

UT-GOM2-2 Prospectus: Science and Sample Distribution Plan

The University of Texas (UT), Genesis of Methane Hydrate in Coarse-Grained Systems: Northern Gulf of Mexico Slope Project (GOM2), will perform the UT-GOM2-2 drilling and coring expedition in the Terrebonne Basin, Gulf of Mexico outer continental shelf. This is the scientific plan for the acquisition, storage, analysis, and distribution of core and other collected samples for UT-GOM2-2.

03 NATURAL GAS↗

UT-GOM2-2 Drilling Fluid (Technical Note)

It is proposed that a salt-saturated, water-based mud might improve borehole stability for UT-GOM2-2 relative to a fresh-water-based mud. However, the primary objective for UT-GOM2-2 is to safely and successfully acquire uncompromised hydrate-bearing sediment cores. This can only be done if conditions stay within the hydrate stability zone, and well away from the hydrate stability boundary. The addition of salt to the drilling mud, shifts the hydrate stability boundary closer to estimated conditions. This shift, by some estimates of pressure and temperature, where conditions now fall outside of the hydrate stability zone, may result in borehole enlargement and the release of free gas into the borehole. This shift by all estimates, even when coring conditions stay inside the hydrate stability zone, shrinks the window between the estimated conditions and the hydrate stability boundary. This shift is likely to compromise the hydrate-bearing cores while they are being recovered from the bottom-hole to the rig floor. In this report we present two examples: 1) Assuming temperature and pressure from in-situ estimates: Hydrate within the target reservoirs (Orange and Blue) at Walker Ridge Block 313 (WR 313) will be outside the hydrate stability zone in the presence of a drilling mud with 9.5 wt.% salinity (the salinity of the proposed 10.5 ppg salt-based mud) at in situ pressure and temperature. Thus, the hydrate will be unstable. A 10.5 ppg salt-based mud may result in dissociation of the hydrate into its components: water and gas. 10.5 ppg salt-based mud may enlarge the borehole, release free gas into the borehole, and compromise the cores. 2) Assuming temperatures equal to the measured LWD borehole temperatures at this location: Hydrate within the target reservoirs will be stable with a salinity of 9.5 wt.% (the salinity of the proposed 10.5 ppg salt-based mud), but possibly unstable (just at the methane hydrate stability boundary) for a salinity of 17.2 wt.% (the salinity of the proposed 13.5 ppg salt-based kill mud). if the borehole has the same temperature as recorded during previous LWD drilling at this location. A 13.5 ppg salt-based kill mud may destabilize the borehole. More importantly, a 10.5 ppg salt-based mud does not provide a large enough window between the estimated conditions and the hydrate stability boundary. Core temperatures and pressures fluctuate from the bottom-hole conditions as the core is brought up from the bottom-hole to the rig floor. These fluctuations are likely to cause the hydrate in the cores to touch or cross the stability boundary. Therefore, cores captured using a 10.5 ppg salt-based mud are likely to be compromised during core recovery to the rig floor.

03 NATURAL GAS↗

Factors Controlling Short-Range Methane Migration of Gas Hydrate Accumulations in Thin Coarse-Grained Layers

Natural gas hydrate is often found in marine sediment in heterogeneous distributions in different sediment types. Diffusion may be a dominant mechanism for methane migration and affect hydrate distribution. We use a 1–D advection–diffusion–reaction model to understand hydrate distribution in and surrounding thin coarse–grained layers to examine the sensitivity of four controlling factors in a diffusion–dominant gas hydrate system. These factors are the particulate organic carbon content at seafloor, the microbial reaction rate constant, the sediment grading pattern, and the cementation factor of the coarse–grained layer. We use available data at Walker Ridge 313 in the northern Gulf of Mexico where two ~3–m–thick hydrate–bearing coarse–grained layers were observed at different depths. The results show that the hydrate volume and the total amount of methane within thin, coarse–grained layers are most sensitive to the particulate organic carbon of fine–grained sediments when deposited at the seafloor. The thickness of fine–grained hydrate free zones surrounding the coarse–grained layers is most sensitive to the microbial reaction rate constant. Furthermore, it may be possible to estimate microbial reaction rate constants at other locations by studying the thickness of the hydrate free zones using the Damköhler number. In addition, we note that sediment grading patterns have a strong influence on gas hydrate occurrence within coarse–grained layers.

54 ENVIRONMENTAL SCIENCES↗

Experimental Investigation of Gas Flow and Hydrate Formation Within the Hydrate Stability Zone

Here, we form methane hydrate by injecting methane gas into a brine-saturated, coarse-grained sample under hydrate-stable thermodynamic conditions. Hydrate forms to a saturation of 11%, which is much lower than that predicted assuming three-phase (gas-hydrate-brine) thermodynamic equilibrium (67%). During hydrate formation, there are temporary flow blockages. We interpret that a hydrate skin forms a physical barrier at the gas-brine interface. The skin fails periodically when the pressure differential exceeds the skin strength. Once the skin is present, further hydrate formation is limited by the rate that methane can diffuse through the solid skin. This process produces distinct thermodynamic states on either side of the skin that allows gas to flow through the sample. This study illuminates how gas can be transported through the hydrate stability zone and thus provides a mechanism for the formation of concentrated hydrate deposits in sand reservoirs. It also illustrates that models that assume local equilibrium at the core-scale and larger may not capture the fundamental behaviors of these gas flow and hydrate formation processes.

58 GEOSCIENCES↗

Methane Hydrate Formation in Thick Sandstones by Free Gas Flow

We show with a two-dimensional multiphase flow and multicomponent transport model that free gas flow is a viable mechanism to form concentrated methane hydrate in meter-scale, dipping sandstones far above the base of the hydrate stability zone (BHSZ). In this model, gas preferentially flows updip along the top of sandstone due to buoyancy. This drives hydrate formation, increasing the local salinity to the stability limit and developing three-phase (gas, liquid, and hydrate) equilibrium above the BHSZ. With time, the gas and the hydrate solidification front (HSF) advance together updip. Behind the HSF, hydrate continues to form as the elevated salinity diffuses away. High hydrate saturations reduce the sediment permeability significantly. As a result, as the gas and HSF move updip, they are also pushed perpendicularly from the top to the base of the sandstone. The hydrate system ultimately self-seals itself due to reduced permeability across the entire thickness of the sandstone. Gas starts to retreat downdip and accumulates below the BHSZ. With this model high hydrate saturations form far above the BHSZ at high methane supply rates while hydrate is concentrated at the BHSZ or no hydrate forms at low methane supply rates. This study provides further insights into hydrate formation by free gas flow, which can be used to design the best strategies for economic and environmental production of methane from hydrate reservoirs.

58 GEOSCIENCES↗

GOM2: Prospecting, Drilling and Sampling Coarse-Grained Hydrate Reservoirs in the Deepwater Gulf of Mexico

The UT-GOM2-1 Hydrate Pressure Coring Expedition will drill two holes in Green Canyon Block 955 in the deepwater Gulf of Mexico to pressure core and wireline log a coarse-grained methane hydrate reservoir. We will take ten, 10 ft, pressure cores in each well. The cores will be imaged and logged under pressure. Samples will be degassed to interpret hydrate concentration. Microbiological and porewater analyses will be performed. 20 3 ft pressure cores will be returned to shore for analysis. The log and core data will provide a foundation for scientific exploration by the greater hydrate research community.

Flemings, Peter↗

UT-GOM2-1 Hydrate Pressure Coring Expedition Prospectus

The UT-GOM2-1 Hydrate Pressure Coring Expedition will drill two holes in Green Canyon Block 955 in the deepwater Gulf of Mexico to pressure core and wireline log a coarse-grained methane hydrate reservoir. We will take ten, 10 ft, pressure cores in each well. The cores will be imaged and logged under pressure. Samples will be degassed to interpret hydrate concentration. Microbiological and pore water analyses will be performed. 20 3 ft pressure cores will be returned to shore for analysis. The log and core data will provide a foundation for scientific exploration by the greater hydrate research community

03 NATURAL GAS↗

Impact of gravity on hydrate saturation in gas‐rich environments

Abstract We extend a one‐dimensional analytical solution by including buoyancy‐driven flow to explore the impact of gravity on hydrate formation from gas injection into brine‐saturated sediments within the hydrate stability zone. This solution includes the fully coupled gas and liquid phase flow and the associated advective transport in a homogeneous system. We obtain the saturations assuming Darcy flow under combined pressure and gravity gradients; capillary forces are neglected. At a high gas supply rate, the overpressure gradient (gradient of water pressure deviation from the hydrostatic pressure) dominates the gas flow, and the hydrate saturation is independent of the flow rate and flow direction. At a low gas supply rate, the buoyancy (the drive for gas flow induced by the density difference between gas and liquid) dominates the gas flow, and the hydrate saturation depends on the flow rate and flow direction. Hydrate saturation is highest for upward flow, and lowest for downward flow. Hydrate saturation decreases with flow rate for upward flow, and increases with flow rate for downward flow. In all cases, hydrate saturation is constant behind the hydrate solidification front. Gas saturation is homogeneous and close to the residual value for upward flow at a low rate; gas flows at the rate it is supplied. Gas saturation is much greater than the residual value, and decreases from the gas inlet to the hydrate solidification front for downward flow at a very low rate. The effect of gravity is usually negligible in laboratory experiments, yet is significant in natural hydrate systems.

You, Kehua↗