Search NASA⌕ Search

Engineering topics

Young, J. C.

Publications and source records attributed to Young, J. C..

At least 19 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1992

Time-lapse analysis of gravitropism in Ceratodon protonemata

The tip cell of the protonema of the moss Ceratodon purpureus (Hedw.) Brid. is negatively gravitropic when grown in the dark on supplemented agar. Gravitropism, plastid distribution, and plastid movement were studied in living cells using time-lapse video microscopy and infrared light. A wrong-way (downward) curvature preceded upward curvature and was detected as early as 2 minutes after reorientation. Upward curvature began 30-45 minutes after reorientation to the horizontal. Cell division temporarily reversed upward curvature, but did not inhibit wrong-way curvature. Since significant amyloplast sedimentation always occurred before the start of upward curvature, it is possible that these amyloplasts function as statoliths for upward curvature. However, no significant amyloplast sedimentation occurred before wrong-way curvature. Thus, this early phase of gravitropism cannot require plastid sedimentation for gravity sensing. Most plastids moved within and between zones, and plastid zonation was highly dynamic. Plastids moved toward the apex and toward the base of the cell at rates much slower than cytoplasmic streaming. Despite the dynamic nature of plastid movement and zonation, during upward curvature the distance between sedimented plastids and the apex stayed constant. Time-lapse analysis has revealed intriguing events not readily seen previously using destructive sampling.

NASA Discipline Number 40-50↗
NASA NTRS1992

Genetic separation of phototropism and blue light inhibition of stem elongation

Blue light-induced regulation of cell elongation is a component of the signal response pathway for both phototropic curvature and inhibition of stem elongation in higher plants. To determine if blue light regulates cell elongation in these responses through shared or discrete pathways, phototropism and hypocotyl elongation were investigated in several blue light response mutants in Arabidopsis thaliana. Specifically, the blu mutants that lack blue light-dependent inhibition of hypocotyl elongation were found to exhibit a normal phototropic response. In contrast, a phototropic null mutant (JK218) and a mutant that has a 20- to 30-fold shift in the fluence dependence for first positive phototropism (JK224) showed normal inhibition of hypocotyl elongation in blue light. F1 progeny of crosses between the blu mutants and JK218 showed normal phototropism and inhibition of hypocotyl elongation, and approximately 1 in 16 F2 progeny were double mutants lacking both responses. Thus, blue light-dependent inhibition of hypocotyl elongation and phototropism operate through at least some genetically distinct components.

Non-NASA Center↗
NASA NTRS1985

An analysis of the Space Shuttle hypersonic entry trim anomaly

This paper reviews a parameter identification methodology developed to investigate the hypersonic longitudinal trim misprediction apparent in the NASA Space Shuttle Orbiter entry flights. The method combines an analysis using a measured versus predicted technique in conjunction with a multilinear regression analysis to identify prediction deficiencies using quasi-static longitudinal data in the hypersonic flight regime (Mach 6 through 26). In general, the results of this extraction confirm results previously obtained by other Shuttle investigators with the exception of elevon effectiveness. Further analysis and/or flight data will be required to resolve the conflicting elevon results. A combination of this analytical tool and other flight data will enable flight data interpretation with the potential for identifying the sources of the Shuttle's hypersonic trim misprediction to an accuracy consistent with updating preflight prediction methodology for future spacecraft.

Young, J. C.↗
NASA NTRS1985

Study of several factors affecting crew escape trajectories from the Space Shuttle Orbiter at low-subsonic speeds

Factors affecting the bailout characteristics from the space shuttle orbiter at low-subsonic speeds were investigated. In the 12-foot low-speed tunnel and the 4 by 7-meter tunnel with 0.03-scale models. The effect of crew-model exit velocity, body position, and body weight were studied with egress from the main side hatch with the orbiter upright and from the upper cabin hatch with the orbiter inverted. Crew model drag and flow field measurements around the orbiter were estimated. The high-angle-of-attack trim characteristics of the orbiter was determined by force tests in an attempt to improve bailout conditions. A computer simulation was made to evaluate the maneuver necessary to attain the high-angle-of-attack trim.

Scallion, W. I.↗
NASA NTRS1985

The space shuttle ascent vehicle aerodynamic challenges configuration design and data base development

The phase B Space Shuttle systems definition studies resulted in a generic configuration consisting of a delta wing orbiter, and two solid rocket boosters (SRB) attached to an external fuel tank (ET). The initial challenge facing the aerodynamic community was aerodynamically optimizing, within limits, this configuration. As the Shuttle program developed and the sensitivities of the vehicle to aerodynamics were better understood the requirements of the aerodynamic data base grew. Adequately characterizing the vehicle to support the various design studies exploded the size of the data base to proportions that created a data modeling/management challenge for the aerodynamicist. The ascent aerodynamic data base originated primarily from wind tunnel test results. The complexity of the configuration rendered conventional analytic methods of little use. Initial wind tunnel tests provided results which included undesirable effects from model support tructure, inadequate element proximity, and inadequate plume simulation. The challenge to improve the quality of test results by determining the extent of these undesirable effects and subsequently develop testing techniques to eliminate them was imposed on the aerodynamic community. The challenges to the ascent aerodynamics community documented are unique due to the aerodynamic complexity of the Shuttle launch. Never before was such a complex vehicle aerodynamically characterized. The challenges were met with innovative engineering analyses/methodology development and wind tunnel testing techniques.

Dill, C. C.↗
NASA NTRS1985

The aerodynamic challenges of the design and development of the space shuttle orbiter

The major aerodynamic design challenge at the beginning of the United States Space Transportation System (STS) research and development phase was to design a vehicle that would fly as a spacecraft during early entry and as an aircraft during the final phase of entry. The design was further complicated because the envisioned vehicle was statically unstable during a portion of the aircraft mode of operation. The second challenge was the development of preflight aerodynamic predictions with an accuracy consistent with conducting a manned flight on the initial orbital flight. A brief history of the early contractual studies is presented highlighting the technical results and management decisions influencing the aerodynamic challenges. The configuration evolution and the development of preflight aerodynamic predictions will be reviewed. The results from the first four test flights shows excellent agreement with the preflight aerodynamic predictions over the majority of the flight regimes. The only regimes showing significant disagreement is confined primarily to early entry, where prediction of the basic vehicle trim and the influence of the reaction control system jets on the flow field were found to be deficient. Postflight results are analyzed to explain these prediction deficiencies.

Young, J. C.↗
NASA NTRS1983

The development of aerodynamic uncertainties for the space shuttle orbiter

The Shuttle Program development schedule and the management decision to perform an orbital, manned mission on the first launch resulted in a requirement to develop realistic aerodynamic uncertainties for the preflight aerodynamic predictions. This paper addresses the methodology in developing two types of aerodynamic uncertainties. One involves the ability to reproduce aerodynamic results between various wind tunnel tests. The second addresses the difference between preflight aerodynamic predictions and flight results derived from analysis of past aircraft programs. Both types of uncertainties for pitching moment, lateral-directional stability, rudder power, and aileron power are presented. In addition, the application of uncertainties to flight control design and fight test planning is briefly reviewed.

Young, J. C.↗
NASA NTRS1983

Results from tests, with van-mounted sensor, of magnetic leader cable for aircraft guidance during roll-out and turnoff

Tests were conducted with a van mounted experimental magnetic leader cable sensor to evaluate its potential for measuring aircraft displacement and heading with respect to the leader cable during roll out and turnoff. Test results show that the system may be usable in measuring displacement but the heading measurement contains errors introduced by distortion of the magnetic field by the metal van or aircraft.

Young, J. C.↗
NASA NTRS1982

The development and application of aerodynamic uncertainties in the design of the entry trajectory and flight control system of the Space Shuttle Orbiter

In connection with the decision to conduct with the Shuttle an orbital, manned mission on its first launch, certain problems arose related to mission safety, which had to be provided without the benefit of either a graduated flight test program or an initial unmanned flight concept. In an attempt to overcome these problems, the philosophy was adopted to provide a reasonable estimate of maximum possible errors in the preflight predicted aerodynamics. The flight control system (FCS) was to be certified on the basis of the estimated errors prior to STS-1. A set of 'worst case' aerodynamic uncertainties, defined as variations, was developed. As part of the first flight certification, variations, combined with other system uncertainties, were used to 'stress' the FCS through a multitude of simulations. Attention is given to an Orbiter description, the entry mission, the correlation of aerodynamic uncertainties, the application of aerodynamic variation in FCS and trajectory design, and the flight test results.

Gamble, J. D.↗
NASA NTRS1982

Aerodynamic comparisons of STS-1 Space Shuttle entry vehicle

A conventional flight-test program, which slowly and cautiously approaches more severe flight conditions, was not possible with the Orbiter. On the first flight, the Orbiter entered the atmosphere at Mach 28 and decelerated through the Mach range. (The subsonic portion of flight was also flown by another orbiter vehicle during the Approach and Landing Test Program.) Certification for the first flight was achieved by an extensive wind-tunnel test and analysis program and by restricting the flight maneuvers severely. The initial flights of the orbiter were heavily instrumented for the purpose of obtaining accurate aerodynamic data. Even without maneuvers to excite the system, the first flight provided comparisons between flight and wind-tunnel-derived predicted data in the areas of aerodynamic performance, longitudinal trim, and reaction-control jet interaction. The aerodynamic performance comparisons are presented.

Young, J. C.↗
NASA NTRS1982

The development of aerodynamic uncertainties for the Space Shuttle Orbiter

The methodology involved in developing the ability to reproduce aerodynamic results between various wind tunnel tests and to determine uncertainties due to differences between preflight aerodynamic predictions and flight results derived from analysis of past aircraft programs is presented. The uncertainties were developed for pitching moment, lateral-directional stability, rudder power, and aileron power, and were formulated to yield aerodynamic uncertainties for an orbital, manned first flight. The compressed development schedule required the aerodynamics results from wind tunnel tests be equipped with tolerances, which accounted for reasonable changes in the vehicle configuration. A worst case scenario was decided on, with the results that every prediction included the widest possible aerodynamic margins. Repeatibility was emphasized between wind tunnel model tests, and was achieved with an accuracy of 0.006 with inclusion of Reynolds effects.

Young, J. C.↗
NASA NTRS1982

Space Shuttle entry longitudinal aerodynamic comparisons of flight 2 with preflight predictions

An overview of the aerodynamic performance, longitudinal trim, and control surface effectiveness as developed from the second Shuttle flight is presented, along with comparisons with preflight predictions. The Orbiter enters the atmosphere at Mach 29 and descends through all the Mach speeds until touchdown. Control mechanisms for the Orbiter are outlined, noting the lessening of angle of attack as the terminal configuration is reached. Methods of developing the wind tunnel predictions are reviewed, including performance in different altitudes and speed regimes, and the impetus to decouple the flight control system from aerodynamics with respect to uncertainties. Preflight predictions agreed well with the lift/drag ratio above Mach 1, but higher L/D was exhibited than predicted below Mach 1. A deficiency in the wind tunnel environment was concluded for the inaccuracies in the predictions for hypersonic trim characteristics.

Romere, P. O.↗
NASA NTRS1981

Space Shuttle entry aerodynamic comparisons of flight 1 with preflight predictions

Results of comparisons of predictions of aerodynamic performance, longitudinal trim, and reaction control jet interaction with data from the initial Shuttle flight are presented. The Shuttle's control surfaces are described, and it is noted that the flight plan contained no provisions for maneuvering capability tests. Wind tunnel testing totaling 35,000 hr were used to replace graduated flight testing, and calculations were made to allow for nonsimulated structural deformation, flowfield parameters, and profile drag. The goal was to desensitize the flight control system with respect to the aerodynamics by adding variations to the predictions. Lift/drag agreed well above Mach 1, while lower drag was encountered below Mach 1. Trim characteristics were predicted accurately between Mach 2-10, and less than satisfactorily outside that range. Discrepancies were also observed for jet interaction effects for the aft yaw jets at Mach numbers greater than 10.

Young, J. C.↗
NASA NTRS1981

Guidance and control system research for improved terminal area operations

Several guidance and control system research and development activities aimed at improving the operational capabilities of commercial aircraft in the terminal area are described. The guidance and control systems were designed to improve the capacity and efficiency of terminal area operations, enhance the approach and landing capability of aircraft in adverse weather conditions, and reduce the impact of aircraft noise perceived on the ground. Specific performance features include the ability to capture and track steep glideslopes, use short final approaches, perform flares with reduced longitudinal touchdown dispersion and execute high speed runway rollout and turnoff. Results obtained from simulation studies or flight tests are shown for each of the algorithms.

Hueschen, R. M.↗
NASA NTRS1972

Surface temperature effect on subsonic stall.

Results of an analytical and experimental study of boundary layer flow over an aerodynamic surface rejecting heat to a cool environment. This occurs following reentry of a Space Shuttle vehicle. Analytical studies revealed that a surface to freestream temperature ratio, greater than unity tended to destabilize the boundary layer, hastening transition and separation. Therefore, heat transfer accentuated the effect of an adverse pressure gradient. Wind tunnel tests of a 0012-64 NACA airfoil showed that the stall angle was significantly reduced while drag tended to increase for freestream temperature ratios up to 2.2.

Macha, J. M.↗