Search NASA⌕ Search

Engineering topics

Young, J. D.

Publications and source records attributed to Young, J. D..

Active microwave measurement from space of sea-surface winds

Radar backscatter measurements from the ocean were made at 13.9 GHz from Skylab. The radar signal increased rapidly with wind speed over the entire range of winds encountered, and for angles of incidence of 30 deg larger. Signals observed were normalized to a nominal incidence angle and to a nominal upwind observation direction, using a theoretical model that has been verified as approximately true with aircraft experiments. Observations during the summer and winter Skylab missions were treated separately because of possible differences caused by an accident to the antenna between the two sets of observations. The results are in general agreement with the theory in all cases. The objective analysis method used for determining surface-truth winds in the Skylab experiment was tested by comparing results obtained at weather ships with the observations made by the weather ships themselves. In most cases, the variance about the regression line between objective analysis and weather-ship data actually exceeded that about the regression line between objective analysis and backscatter data

Young, J. D.↗

Poor-resolution satellite observations of radar return from North America, Brazil, and the oceans

The 13.9 GHz radar scatterometer on Skylab produced statistics of radar returns from thousands of points in North America and Brazil, as well as from the oceans. The resolution cell of the system varied from about 11 km in diameter at vertical incidence to 20 by 30 km at 50 deg incidence. Although these cells are larger than the preprocessing cells to be expected from spacecraft synthetic-aperture radars, they are at least as comparable with such cells as are the observation cells when aircraft radars are used. Results are presented both in terms of composite statistics for North America, Brazil, and the oceans, and in terms of statistics for particular classes of terrain. Both vertical and horizontal polarization data are presented for the land, and cross-polarized measurements are presented as well as for the sea. Correlations are indicated for the returns at different angles and polarizations.

Moore, R. K.↗

The measurement of the winds near the ocean surface with a radiometer-scatterometer on Skylab

The author has identified the following significant results. There were a total of twenty-six passes in the ZLV mode that yielded useful data. Six were in the in-track noncontiguous mode; all others were in the cross-track noncontiguous mode. The wind speed and direction, as effectively determined in a neutral atmosphere at 19.5 m above the sea surface, were found for each cell scanned by S193. It is shown how the passive microwave measurements were used both to compute the attenuation of the radar beam and to determine those cells where the backscatter measurement was suspect. Given the direction of the wind from some independent source, with the typical accuracy of measurement by available meteorological methods, a backscatter measurement at a nadir angle of 50, 43, or 32 deg can be used to compute the speed of the wind averaged over the illuminated area.

Pierson, W. J.↗

Skylab S-193 Radscat microwave measurements of sea surface winds

The S-193 Radscat made extensive measurements of many sea conditions. Measurements were taken in a tropical hurricane (Ava), a tropical storm (Christine), and in portions of extratropical cyclones. Approximately 200 scans of ocean data at 105 kilometer spacings were taken during the first two Skylab missions and another 200 during the final mission when the characteristics of the measurements changed due to damage of the antenna. Backscatter with four transmit/receive polarization combinations and emissions with horizontal and vertical receive polarizations were measured. Other surface parameters investigated for correlation with the measurements included sea temperature, air/sea temperature difference, and gravity-wave spectrum. Methods were developed to correct the microwave measurements for atmospheric effects. The radiometric data were corrected accurately for clear sky and light cloud conditions only. The radiometer measurements were used to recover the surface scattering characteristics for all atmospheric conditions excluding rain. The radiometer measurements also detected the presence of rain which signaled when the scattering measurement should not be used for surface wind estimation. Regression analysis was used to determine empirically the relation between surface parameters and the microwave measurements, after correction for atmospheric effects. Results indicate a relationship approaching square-law at 50 deg between differential scattering coefficient and wind speed with horizontally polarized scattering data showing slightly more sensitivity to wind speed than vertically polarized data.

Moore, R. K.↗

Preliminary analysis of Skylab RADSCAT results over the ocean

Preliminary observations at 13.9 GHz of the radar backscatter and microwave emission from the sea were analyzed using data obtained by the radiometer scatterometer on Skylab. Results indicate approximately a square-law relationship between differential scattering coefficient and windspeed at angles of 40 deg to 50 deg, after correction for directional effect, over a range from about 4 up to about 25 meters/sec. The brightness temperature response was also observed, and considerable success was achieved in correcting it for atmospheric attenuation and emission. Measurements were made in June, 1973, over Hurricane Ava off the west coast of Mexico and over relatively calm conditions in the Gulf of Mexico and Caribbean Sea.

Moore, R. K.↗

Simultaneous active and passive microwave response of the earth - The Skylab radscat experiment

The Skylab microwave radiometer-scatterometer experiment S-193 was designed to collect simultaneous information on the radiometric emission and the backscatter from the earth from orbital altitude for the first time. A primary driving force was ascertaining the response from the oceans of both active and passive systems to variations in wind, and the ability of the passive system to aid in calibrating the active system. Numerous overland applications were also explored. Preliminary results of backscatter and emission from sea and atmosphere are shown for hurricane Ava and for two flights across the Gulf of Mexico. The results tend to confirm the most recent theoretical prediction of an approximately square-law relation between scattering coefficient for horizontal polarization and windspeed, with a somewhat smaller dependence for vertical polarization. Overland measurements show that scatterometer signals at 30 deg increase and radiometer signals decrease for terrain that has recently experienced rainfall.

Moore, R. K.↗

Preliminary report on Skylab S-193 Radscat measurements of Hurricane Ava

The author has identified the following significant results. The Skylab RADSCAT instrument S-193 was operated on 6 June 1973 while the spacecraft flew past Hurricane Ava in the eastern Pacific Ocean. Scatterometer returns at all polarizations and radiometer measurements were obtained from a section through the storm with winds up to 48 knots at 52 deg incident angle and 35 knots at 45.5 deg incident angle. These first hurricane scatterometer measurements indicate reasonable correlation between wind speed and backscatter, with horizontal response much stronger than the vertical response at 52 deg. Each of the sections through the hurricane contains an as yet unexplained dip in cross section at a point 200 to 300 km prior to passing the eye. The response at a point where the radiometer signal's dramatic increase indicates strong rain is also accompanied by a strong increase in the backscattered signal. No attempt has been made to make a thorough correlation of radiometric response with wind speed, but the atmospheric contribution to the radiometer signal is quite apparent.

Pierson, W. J., Jr.↗

Cubic spline functions for curve fitting

FORTRAN cubic spline routine mathematically fits curve through given ordered set of points so that fitted curve nearly approximates curve generated by passing infinite thin spline through set of points. Generalized formulation includes trigonometric, hyperbolic, and damped cubic spline fits of third order.

Young, J. D.↗