Search NASA⌕ Search

Engineering topics

Yu, Jian

Publications and source records attributed to Yu, Jian.

24 records · Page 2

Challenges of nickel silicidation in CMOS technologies

In our paper, we review some of the key challenges associated with the Ni silicidation process in the most recent CMOS technologies. The introduction of new materials (e.g.SiGe), and of non-planar architectures bring some important changes that require fundamental investigation from a material engineering perspective. Following a discussion of the device architecture and silicide evolution through the last CMOS generations, we focus our study on a very peculiar defect, termed NiSi-Fangs. We describe a mechanism for the defect formation, and present a detailed material analysis that supports this mechanism. We highlight some of the possible metal enrichment processes of the nickel monosilicide such as oxidation or various RIE (Reactive Ion Etching) plasma process, leading to a metal source available for defect formation. Furthermore, we investigate the NiSi formation and re-formation silicidation differences between Si and SiGe materials, and between (1 0 0) and (1 1 1) orientations. Finally, we show that the thermal budgets post silicidation can lead to the formation of NiSi-Fangs if the structure and the processes are not optimized. Beyond the understanding of the defect and the discussion on the engineering solutions used to prevent its formation, the interest of this investigation also lies in the fundamental learning within the Ni–Pt–Si–Ge system and some additional perspective on Ni-based contacts to advanced microelectronic devices.

36 MATERIALS SCIENCE↗

Residual tensile stress in robust insulating rhombohedral Bi{sub 1−x}La{sub x}Fe{sub 1−y}Ti{sub y}O{sub 3} multiferroic ceramics and its ability to pin ferroelectric polarization switching

Robust insulating rhombohedral Bi{sub 1−x}La{sub x}Fe{sub 1−y}Ti{sub y}O{sub 3} multiferroic ceramics with 0.02 ≤ x ≤ 0.12 and 0.01 ≤ y ≤ 0.08 are prepared by a refined solid-state reaction electroceramic processing. Residual internal tensile stresses existed in the ceramics according to unit cell volume enlargement observed by X-ray diffraction and frequency redshifts of Raman modes related to Bi motion and oxygen octahedral rotation detected by Raman scattering measurements. Residual internal tensile stresses in the ceramics are believed to originate from structural phase transitions through an intermediate paraelectric rhombohedral phase with a negative thermal expansion coefficient in the transformation from paraelectric cubic to ferroelectric rhombohedral phases. All of the rhombohedral Bi{sub 1−x}La{sub x}Fe{sub 1−y}Ti{sub y}O{sub 3} ceramics exhibited a pinched polarization versus electric field hysteresis loop indicative of ferroelectric subswitching. We argue that the residual internal tensile stresses are responsible for such ferroelectric polarization subswitching behavior in the Bi{sub 1−x}La{sub x}Fe{sub 1−y}Ti{sub y}O{sub 3} ceramics.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

Enhanced thermoelectric performance of (Ba,In) double-filled skutterudites via randomly arranged micropores

Porous (Ba,In) double-filled skutterudite materials with pore diameter about 1–4 μm were prepared by the decomposition of metastable ZnSb inclusions induced by the Zn sublimation. Transport measurements revealed that the Seebeck coefficient was increased due to the electron filtering effect induced by nanostructures in the surfaces of pores, the electrical conductivity was almost unchanged because of the percolation effect of conducted network composed of filled skutterudites, and the lattice thermal conductivity was dramatically suppressed due to the enhanced pore-edge boundary scattering of long-wavelength phonons. As a result, a maximum ZT of 1.36 was obtained, increased by 22.5% as compared to that of the bulk material with same chemical composition. This work demonstrates that by introducing porous structures is thought to be an efficient approach to improve the thermoelectric performance of bulk materials.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

Structural phase transitions of robust insulating Bi{sub 1-x}La{sub x}Fe{sub 1-y}Ti{sub y}O{sub 3} multiferroics

In contrast to leaky BiFeO{sub 3}, of which two structural phase transitions of cycloidal modulated antiferromagnetic-paramagnetic and ferroelectric-paraelectric are observed below 850 °C, chemical co-substitution to form Bi{sub 1−x}La{sub x}Fe{sub 1−y}Ti{sub y}O{sub 3} ternary solid solution makes these multiferroic ceramics become robust insulating low dielectric loss and exhibit rich structural phase transitions. Differential thermal analysis and temperature-dependent X-ray diffraction measurements probe four first-order structural phase transitions, e.g., T{sub H} = 305 °C, T{sub N} = 365 °C, T{sub C} = 810 °C, and T{sub S} = 830 °C observed in the Bi{sub 0.98}La{sub 0.02}Fe{sub 0.99}Ti{sub 0.01}O{sub 3} system, which are reasonably attributed to Brazovskii-type cycloidal modulated antiferromagnetic-helimagnetic (at T{sub H}) and helimagnetic-paramagnetic (at T{sub N}) magnetic phase transitions, ferroelectric-paraelectric (at T{sub C}) and rhombohedral-cubic (at T{sub S}) structural phase transitions, respectively. Magnetic phase transition temperatures change a little but ferroelectric and lattice structural phase transition temperatures decrease gradually with increasing co-substitution up to composition-induced rhombohedral-(pseudo-)cubic structural phase boundary. The first-order nature of magnetic phase transition and emergence of helimagnetic phase were attributed to Ti{sup 3+} d{sup 1} magnetic disorder distribution in the Fe{sup 3+} d{sup 5}-O-Fe{sup 3+} d{sup 5} chains, while the first-order nature becomes weak with increasing co-substitution, owing to decreased ferroelectric rhombohedral lattice distortion. An intermediate rhombohedral paraelectric phase is discovered intervening between ferroelectric rhombohedral and paraelectric cubic phase, of which the temperature range defined by difference between T{sub C} and T{sub S} increases with increasing co-substitution. It was found that T{sub C} and T{sub S} are able to be predicted quantitatively by reduced mass of unit cell. These findings enrich our understanding of ferroic phase transitions and advance designing novel high temperature multiferroic compounds.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

Crystal structure and bonding characteristics of In-doped {beta}-Zn{sub 4}Sb{sub 3}

The effects of indium impurity on the crystal structure and bonding characteristics of In-doped {beta}-Zn{sub 4}Sb{sub 3} were investigated by powder X-ray diffraction (XRD) and X-ray photoelectron spectroscopy (XPS). The XRD Rietveld refinement indicates that the indium impurity preferentially substitutes one of Sb atoms in Sb-Sb dimer at the 12c Sb(2) site and simultaneously leads to the increase of Zn occupancy. The observations of binding energy shift and a new valence state in Sb 3d core-level XPS spectra can be attributed to the charge transfer from In and Zn to Sb. As a result, more electropositive Zn atoms are needed to maintain the charge balance. The reduction of the lattice thermal conductivity is ascribed to the formation of the asymmetric Sb-In bond, resulting in much low lattice thermal conductivity of 0.49 W{sup -1} K{sup -1} of Zn{sub 4}Sb{sub 2.96}In{sub 0.04}. - Graphical abstract: The indium impurity substitutes one of Sb atoms in Sb-Sb dimer, resulting the charge transfer from In to Sb, which leads to the binding energy of Sb 3d core level XPS spectra shift to low value. Highlights: Black-Right-Pointing-Pointer The indium impurity preferentially substitutes one of Sb atoms in Sb-Sb dimer at the 12c Sb(2) site. Black-Right-Pointing-Pointer The occupancy of Zn increases by the In substitution for Sb, whereas that of Sb keeps constant. Black-Right-Pointing-Pointer The binding energy of Sb 3d shifts to low value. Black-Right-Pointing-Pointer The charge transfer occurs from In and Zn to Sb.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

Electron microscopy and computational studies of Ebh, a giant cell-wall-associated protein from Staphylococcus aureus

Ebh, a giant protein found in staphylococci, contains several domains, including a large central region with 52 imperfect repeats of a domain composed of 126 amino acids. We used electron microscopy to observe the rod-like structure of a partial Ebh protein containing 10 repeating units. This is the first report of the direct observation of an Ebh structure containing a large number of repeating units, although structures containing one, two, or four repeating units have been reported. The observed structure of the partial Ebh protein was distorted and had a length of ca. 520 A and a width of ca. 21 A. The observed structures were consistent with those deduced from crystal structure analysis, suggesting that the Ebh domains are connected to form a rod-like structure. The crystal structure data revealed distorted, string-like features in the simulated structure of the whole-length Ebh protein. Superposition of fragments of the simulated whole-length structure of the Ebh protein onto each electron micrograph showed a high level of correlation between the observed and calculated structures. These results suggest that Ebh is composed of highly flexible filate molecules. The highly repetitive structure and the associated unique structural flexibility of Ebh support the proposed function of this protein, i.e. binding to sugars in the cell wall. This binding might result in intra-cell-wall cross-linking that contributes to the rigidity of bacterial cells.

60 APPLIED LIFE SCIENCES↗