Search NASA⌕ Search

Engineering topics

Yue, Fengxia

Publications and source records attributed to Yue, Fengxia.

4 records
All sourcesNASA NTRSDOE OSTI
DOE OSTI2022

Nanolignin-based high internal phase emulsions for efficient protection of curcumin against UV degradation

As an emulsifier, lignin exhibits excellent UV resistance on drug-loaded emulsion systems for drug delivery. However, due to the structural variation and complexity of lignins from various origins, their UV shielding performance varies with the techniques for lignin extraction, which impacts properties and the protection efficiency of lignin-based HIPEs (high internal phase emulsions). In this work, lignin nanoparticles, prepared from three lignin preparations of Eucalyptus, were used in HIPEs delivery systems to protect curcumin from degradation by UV radiation. Structures of the lignin preparations were characterized using 2D HSQC (heteronuclear single-quantum coherence) NMR (nuclear magnetic resonance), 31 P NMR, and GPC (gel permeation chromatography). The residual curcumin level after 36h UV exposure in the nanolignin-based HIPEs was over 72%, much higher than that (< 10% after 24 h UV exposure) in the oil phase without lignin, indicating that the nanolignin-based HIPEs with enhanced UV shielding ability protect curcumin better. Of the three lignin preparations, AL (alkali lignin), with the lowest molecular weight, highest contents of phenolic hydroxyl and carboxyl groups, and highest S/G ratio, displayed the best anti-UV radiation ability and the most uniform nanoparticle size.

59 BASIC BIOLOGICAL SCIENCES↗
DOE OSTI2022

A tailored fast thioacidolysis method incorporating multi-reaction monitoring mode of GC-MS for higher sensitivity on lignin monomer quantification

Abstract Thioacidolysis is widely used for lignin structural characterization by cleaving β-aryl ethers to release syringyl (S), guaiacyl (G), and p -hydroxyphenyl (H) monomers followed by GC analysis. However, the traditional thioacidolysis method requires tedious extraction steps with chlorinated solvent underlying harmful to health, limiting its efficiency and application. Herein, an improved thioacidolysis method with high sensitivity for the quantitation of lignin-derived monomers was developed. The improved protocol used a quick, streamlined procedure to recover the monomeric products using ethyl acetate as extracting solvent and MS detector in multi-reaction monitoring mode to enhance its ability to detect extremely low concentration (0.1 ppb with signal-to-noise higher than 2) of monomeric products. Additionally, a fast GC program was established to speed up the GC quantitation. Several representative lignocellulose samples, including gymnosperm, angiosperm, and poaceae, were used to test this tailored method. The results demonstrated that the ratios of lignin monomer compositions determined by this method were consistent with that of traditional procedure despite the slightly higher monomer yields measured. More importantly, this method uses non-chlorinated solvent for microscale extraction and requires no evaporation step for workup, which is a green and efficient way for the quantification of lignin monomer compositions.

Forestry↗
DOE OSTI2022

Isolation, Characterization, and Depolymerization of L -Cysteine Substituted Eucalyptus Lignin

Lignin condensation reactions are hard to avoid or control during separation, which is a deterrent to lignin isolation and post-conversation, especially for the full utilization of lignocelluloses. Selective protection of β-aryl ether linkages in the isolation process is crucial to lignin valorization. Herein, a two-step acid/alkali separation method assisted with l-cysteine for eucalyptus lignin separation is developed, and the isolated L -cysteine lignins (LCLs) are comprehensively characterized by 2D NMR, 31 P NMR, thioacidolysis, etc. Compared to the two-step control treatment, a much higher β-O-4 content is preserved without reducing the separation efficiency assisted by L -cysteine, which is also significantly higher than alkali lignin and kraft lignin. The results of hydrogenolysis show that LCLs generate a much higher monomer yield than that of control sample. Structural analysis of LCLs suggests that lignin condensation reaction, to some extent, is suppressed by adding L -cysteine during the two-step acid/alkali separation. Further, mechanistic studies using dimeric model compound reveals that L -cysteine may be the α-carbon protective agent in the two-step separation. The role of L -cysteine in the two-step lignin isolation method provides novel insights to the selective fractionation of lignin from biomass, especially for the full valorization of lignocellulosic biomass.

09 BIOMASS FUELS↗