Zachary R. Putnam | Search NASA

NASA NTRSDate not supplied

Numerical Predictor-Corrector Based Guidance Scheme For Aero-Gravity Assist at Titan For Enceladus Missions

Aero-gravity assist is a spacecraft maneuver than can enable a vehicle to insert into an orbit of one planetary body using the atmosphere and gravity field of a secondary body, reducing the required propellant mass relative to a fully-propulsive orbit insertion. The Fully Numerical Predictor-Corrector Aerocapture Guidance algorithm was modified to work with a direct force control blunt body vehicle, executing an aero-gravity assist at Titan to enter a Saturnian orbit and conduct fly-by at Enceladus. Additionally, a proportional-integral-derivative controller was implemented to command sideslip angles for control of the orbital inclination. Numerical simulation showed the developed guidance scheme was capable of minimizing the energy and inclination error at atmospheric exit, allowing Saturnian moon tour trajectories and Enceladus exploration at a small delta-V cost, on the order of 100 m/s, in the nominal case.

Daniel L. Engel↗

NASA NTRSDate not supplied

Demonstration of Linear Covariance Analysis Techniques to Evaluate Entry Descent and Landing Guidance Algorithms, Vehicle Configurations, Analysis Techniques, and Trajectory Profiles

Linear covariance analysis techniques have been previously developed to analyze closed-loop entry, descent, and landing (EDL) scenarios and the initial validation efforts are under-way confirming the generated GN&C system performance results. Given both the theoretical foundation and previous conceptual demonstration, this work begins to flex the potential of linear covariance analysis for atmospheric flight and highlight its versatility and reliability by evaluating multiple entry guidance algorithms, vehicle configurations, trajectory profiles, environment conditions, and analysis techniques for a variety of trade studies. To demonstrate the benefit linear covariance analysis can provide in producing rapid yet accurate performance data, two entry profiles are adopted including the NASA Mars Science Laboratory (MSL) and Exploration Flight Test-1 (EFT-1) while utilizing two different guidance algorithms, the Apollo Final Phase (AFP) and the Fully Numeric Predictor-Corrector Entry Guidance (FNPEG) with different navigation sensor suites in a 6 degree-of-freedom (6-DOF) simulation environment. Results are shown using both linear covariance and Monte Carlo analysis techniques to high-light the consistency between the two methodologies and continue the validation maturation of linear covariance analysis for entry, descent, and landing.

EDL↗

NASA NTRSDate not supplied

Aerocapture at Saturn

The feasibility and benefits of using aerocapture for orbit insertion in the Saturn atmosphere are assessed in the context of existing technologies and likely science mission architectures in the Saturn system. We model aerocapture in-atmosphere flight performance in the presence of expected day-of-flight uncertainties, including those driven by limited knowledge of Saturn, to determine aerocapture flight system needs. We assess the impact of aerocapture on overall mission design for future science missions by including aerocapture in an end-to-end mission design and optimization scheme. Results indicate that aerocapture may feasible and beneficial with limited-to-no technology investment for missions designed to address near-term science priorities in the Saturn system.

Aerocapture↗

NASA NTRSDate not supplied

Dragonfly Preparation for Powered Flight: Lander Separation State Control to Ensure Successful Landing

NASA’s Dragonfly mission, led by The Johns Hopkins University Applied Physics Laboratory, is a relocatable octocopter lander to study Saturn’s largest moon Titan. The scientific goals of the mission include studying Titan’s prebiotic chemistry, geology, and atmosphere. Upon Titan arrival, the lander will enter the atmosphere, descend on a parachute to a ground-relative altitude of about 1000 m before being released, and then fly on internal power down to the surface. To guarantee desirable initial conditions for the lander release, the lander must meet certain angular rate conditions. These conditions include reducing the spin rate about the vertical axis to 4.9 deg/sec, using the rotors as actuators; and releasing with a negative pitch rate (rotating nose down) to ensure a successful transition to powered flight. This is achieved using a release trigger. Achieving these desired rates for lander release is part of the mission phase known as ‘preparation for powered flight’ (PPF). This paper proposes controls and logic to achieve the desired conditions for releasing the lander from the parachute.

Flight Mechanics↗

NASA NTRSDate not supplied

Dragonfly Preparation for Powered Flight: Lander Separation State Control to Ensure Successful Landing

NASA’s Dragonfly mission, led by The Johns Hopkins University Applied Physics Laboratory, is a relocatable octocopter lander to study Saturn’s largest moon Titan. The scientific goals of the mission include studying Titan’s prebiotic chemistry, geology, and atmosphere. Upon Titan arrival, the lander will enter the atmosphere, descend on a parachute to a ground-relative altitude of about 1000 m before being released, and then fly on internal power down to the surface. To guarantee desirable initial conditions for the lander release, the lander must meet certain angular rate conditions. These conditions include reducing the spin rate about the vertical axis to 4.9 deg/sec, using the rotors as actuators; and releasing with a negative pitch rate (rotating nose down) to ensure a successful transition to powered flight. This is achieved using a release trigger. Achieving these desired rates for lander release is part of the mission phase known as ‘preparation for powered flight’ (PPF). This paper proposes controls and logic to achieve the desired conditions for releasing the lander from the parachute.

Flight Mechanics↗