Search NASA⌕ Search

Engineering topics

Zamudio, J. A.

Publications and source records attributed to Zamudio, J. A..

Unmixing AVIRIS data to provide a method for vegetation fraction subtraction

Five flight lines of Airborne Visible/Infrared Imaging Spectrometer (AVIRIS) data were acquired over the Dolly Varden Mountains in northeastern Nevada on 2 June 1989. Signal-to-noise ratio values are given. The empirical line method was used to convert AVIRIS radiance values to reflectance. This method involves calculating gain and offset values for each band. These values are based upon a comparison of the imaging spectrometer data and field reflectance measurements, both taken over the same ground targets. The targets used were a dark andesite flow and a bright playa.

Zamudio, J. A.↗

Removing Atmospheric Effects From AVIRIS Data for Surface Reflectance Retrievals

Analysis of high resolution imaging spectrometer data requires a thorough compensation for atmospheric absorption and scattering. A method for retrieving surface reflectances from spectral data collected by the Airborne Visible/Infrared Imaging Spectrometer (AVIRIS) is being developed. In this method, the integrated water vapor amount on a pixel by pixel basis is derived from the 0.94- and 1.14-micrometer water vapor features. The water vapor, carbon dioxide (CO2), oxygen (O2) and methane (CH4) transmission spectrum in the 0.4-2.5 micrometer region is calculated. The derived water vapor value and the solar and observational geometry are used in the spectral calculation. The AVIRIS spectrum is ratioed against the transmission spectrum to obtain the surface reflectance spectrum. Major mineral absorption features near 2.2 micrometer in retrieved reflectance spectra can be identified. Different vegetation absorption characteristics are observed. At present, the method is most useful for deriving surface reflectances from AVIRIS data measured on clear days with high visibilities. Atmospheric scattering effects will be included in our spectral calculations in the near future.

Gao, Bo-Cai↗

Retrievals of surface reflectances from AVIRIS data

A method for retrieving surface reflectances from spectral data collected by the Airborne Visible/Infrared Imaging Spectrometer (AVIRIS) is being developed. In this method, the integrated water vapor amount on a pixel by pixel basis is derived from the 0.94- and 1.14-micron water vapor features. The water vapor, carbon dioxide (CO2), oxygen (O2) and methane (CH4) transmission spectrum in the 0.4-2.5 micron region is calculated. The derived water vapor value and the solar and observational geometry are used in the calculation. The AVIRIS spectrum is ratioed against the transmission spectrum to obtain the surface reflectance spectrum. Major mineral absorption features near 2.2 microns in retrieved reflectance spectra can be identified. Different vegetation absorption characteristics are observed. At present, the method is most useful for deriving surface reflectances from AVIRIS data measured on clear days with high visibilities.

Gao, Bo-Cai↗