Engineering topics

Zebib, A.

Publications and source records attributed to Zebib, A..

10 records

NASA NTRS1995

Thermocapillary convection in a rectangular cavity with a deformable interface

A finite-volume method and a boundary element technique are used to compute two-dimensional (2D) thermocapillary convection in a rectangular cavity. The free surface is deformable and the deviations from a flat interface, h, are assumed small in the finite-volume calculations as appropriate for small Capillary (Ca). Two asymptotic approaches are employed; the first is an expansion valid as Ca tends towards 0 and the second assumes h tends towards 0, retaining Ca explicitly as a parameter. On the other hand, the boundary elements approach can be used with O(1) surface deformations. These three different formulations are used to calculate thermocapillary motions in fluids with small Prandtl numbers of about 0.01, Ca less than 0.05, aspect ratios (width/height) 1, 2 and 4, and various values of the Maragoni number (Ma). The same solutions are calculated with these different approaches and are found in good agreement for values of Ca up to 0.05. All solutions calculated are steady, which is both in agreement and disagreement with recently published results by different authors employing different numerical techniques.

Mundrane, M.↗

NASA NTRS1989

Three-dimensional thermal convection in a spherical shell

Nonlinear convective solutions are presented for a shell with properties characteristic of the earth's whole mantle for Rayleigh numbers up to 70,000. The solutions are validated numerically, and two distinct convective patterns (cubic and tetrahedral) are identified which are closely related to the geometric planforms predicted by the analytical theories of slightly supercritical spherical convection. A quantitative analysis of the horizontal and vertical structures of the velocity and temperature fields of the solutions is presented, and their heat transport properties are examined, including the total heat flow and the spatial distribution of the heat flux at the shell boundaries.

Bercovici, D.↗

NASA NTRS1989

Absolute and convective instability of a cylinder wake

The stability behavior of a circular cross-section cylinder's wake at Reynolds number values of up to 45 is presently investigated by means of local linear stability theory. The steady-wake profiles computed are Navier-Stokes solutions of a uniform, incompressible viscous flow around a cylinder obtained by a spectral method. An absolutely unstable region is found to begin to form at a Reynolds number of about 20, and grows with incresing Reynolds number. The onset of global instability response must be characterized by a critical length of an absolutely unstable region; a critical Reynolds number criterion and preferred frequency are proposed based on linear stability analysis.

Yang, X.↗

NASA NTRS1988

Geoid and topography for infinite Prandtl number convection in a spherical shell

Geoid anomalies and surface and lower-boundary topographies are calculated for numerically generated thermal convection for an infinite Prandtl number, Boussinesq, axisymmetric spherical fluid shell with constant gravity and viscosity, for heating both entirely from below and entirely from within. Convection solutions are obtained for Rayleigh numbers Ra up to 20 times the critical Ra in heating from below and 27 times critical for heating from within. Geoid parallels surface undulations, and boundary deformation generally increases with increasing cell wavelength. Dimensionless geoid and topography in heating from below are about 5 times greater than in heating from within. Values for heating from within correlate more closely with geophysical data than values from heating from below, suggesting a predominance of internal heating in the mantle. The study emphasizes that dynamically induced topography and geoid are sensitive to the mode of heating in the earth's mantle.

Bercovici, D.↗

NASA NTRS1987

Stability of viscous flow past a circular cylinder

A spectral method which employs trigonometric functions and Chebyshev polynomials is used to compute the steady, incompressible laminar flow past a circular cylinder. Linear stability methods are used to formulate a pair of decoupled generalized eigenvalue problems for the growth of symmetric and asymmetric (about the dividing streamline) perturbations. It is shown that, while the symmetric disturbances are stable, the asymmetric perturbations become unstable at a Reynolds number about 40 with a Strouhal number about 0.12. The critical conditions are found to depend on the size of the computational domain in a manner similar to that observed in the laboratory.

Zebib, A.↗

NASA NTRS1985

High Marangoni number convection in a square cavity

Steady thermocapillary flows in a square cavity are computed using a finite difference procedure. Accurate numerical solutions are obtained for as high a Reynolds number as possible, in order to characterize the nature of strongly convective flows of this general class. Only the case of capillary number going to zero is considered, so that the free surface is assumed flat at the leading order. Surface deflections are computed by domain perturbation. Boundary layer formation at different values of the Prandtl number is observed at large values of the Marangoni number and Re. The numerical results are used to infer the relevant scalings of a consistent boundary layer picture of the flow, valid asymptotically as Re goes to infinity.

Zebib, A.↗

NASA NTRS1985

Convective motions in a spherical shell

We compute the axisymmetric convective motions that exist in a spherical shell heated from below with inner to outer radius ratio equal to 0.5. The boundaries are stress-free and gravity is directly proportional to radius. Accurate solutions at large Rayleigh numbers, O(100000), are made feasible by a spectral method that employs diagonal-mode truncation. By examining the stability of axisymmetric motions it is inferred that the preferred form of convection varies dramatically according to the value of the Rayleigh number. While axisymmetric motions with different patterns may exist for modestly nonlinear convection, only a single motion persists at sufficiently large values of the Rayleigh number. This circulation is symmetric about the equator and has two meridional cells with rising motion at the poles. Instability of this single axisymmetric motion determines that the preferred pattern of three-dimensional convection has one azimuthal wave.

Zebib, A.↗

NASA NTRS1983

Character and stability of axisymmetric thermal convection in spheres and spherical shells

The influence of shell size and mode of heating on the behavior and stability of axisymmetric, infinite Prandtl number convection in a spherical geometry is studied. Heating from within and below features convection onset governed by a self-adjoint system of equations and boundary conditions. For heating only from within or from below, linearized equations and boundary conditions are non-self-adjoint. Identification of the parameter which initiates the departure from self-adjointness, together with the properties of the self-adjoint solution, provide a basis for calculating the heat transfer characteristics of the non-self-adjoint situations. The investigations are an effort to develop a model for heat transfer in planetary interiors. Further development of the technique by modifying the Galerkin method by the introduction of diagonal mode truncation is suggested to permit the consideration of higher values of the Rayleigh numbers, i.e., those more commensurate with terrestrial planet mantles.

Zebib, A.↗

NASA NTRS1980

Infinite Prandtl number thermal convection in a spherical shell

A Galerkin technique is used to calculate the steady-state axisymmetric nonlinear convective motions in an infinite-Prandtl-number Boussinesq fluid in a relatively thick spherical shell heated from below. A reasonably complete study of the properties of the even and general axisymmetric steady states is carried out for a range of moderately supercritical Rayleigh numbers. In addition, stability analyses are conducted to determine which form of axisymmetric steady convection is the preferred one and whether the axisymmetric steady flows are unstable to azimuthal perturbations.

Zebib, A.↗

NASA NTRS1980

Thermal convection of an internally heated infinite Prandtl number fluid in a spherical shell

A Galerkin technique is used to study the finite-amplitude axisymmetric steady convective motions of an infinite Prandtl number Boussinesq fluid in a spherical shell. Two types of heating are considered: in one case, convection is driven both by internal heat sources in the fluid and by an externally imposed temperature drop across the shell boundaries; in the other case, only internal heat sources drive convection and the lower boundary of the shell is adiabatic. Two distinct classes of axisymmetric steady states are found to be possible: states characterized by temperature and radial velocity fields that are symmetric about an equatorial plane; and a class of solutions that does not possess any symmetry properties about the equatorial plane.

Schubert, G.↗