Search NASA⌕ Search

Engineering topics

Zhang, Biao

Publications and source records attributed to Zhang, Biao.

Cyber-Physical Simulation of an Innovative Solid Oxide Electrolysis Cell - Gas Turbine (SOEC-GT) Hybrid Energy System

To produce green hydrogen at scale and at low cost, the solid oxide electrolysis cell (SOEC) systems would be tied to renewable power sources (mainly solar and wind), leveraging zero-carbon electricity at low prices and even nearly free during overgeneration scenarios. However, due to the intermittency of renewable power generation, the SOEC system is subjected to rapid load transitions that occur not only in diurnal cycles but also in short timeframes (e.g., sub-minute). This can result in fast degradation and thus greatly reduce the SOEC’s lifetime. Our team at the National Energy Technology Laboratory has demonstrated that the anode air flow can have a crucial role in SOEC thermal management. Typically, a higher air flow rate can help to mitigate the local temperature gradient distortion during rapid load transitions. To move a large amount of air, the gas turbine (GT; i.e., compressor-turbine-generator set) has been regarded as the most mature and efficient technology. In this presentation, we show the configuration and preliminary results of an innovative SOEC-GT hybrid energy system in a cyber-physical simulation (CPS) approach.

Zhang, Biao↗

Cyber-Physical System: Design for Sustainability and Resilience

When considering the design tools needed in the transition from numeric models to pilot plant, cyber-physical systems (CPS) come to the forefront as a method to model complex integrated energy systems. CPS approach has proven to be valuable to identify opportunities for economically viable early adoption of integrated energy technologies. This tutorial will introduce the concepts and the roles of CPS in co-design to minimize risks for pilot plant and technology deployment. This tutorial will also layout basic requirements for the CPS development, which requires a highly interdisciplinary effort with expertise in sensors, hardware testing, real-time modeling, controls, and system integration.

Harun, Nor Farida↗

Cyber-Physical Simulation of the Cold Startup of Solid Oxide Fuel Cell – Gas Turbine (SOFC-GT) Hybrid Systems

This work introduces experimental studies for the cold startup process (CPS) of the SOFC-GT hybrid system using the cyber-physical simulation approach. The physical gas turbine is coupled with a cyber-physical SOFC stack, which is represented using the integration of a real time dynamic SOFC model with physical components (e.g., pressure chamber, natural gas burner, etc.). Different ramp rates of the turbine speed were tested out during the startup processes. Bypass valves were also used to manipulate the airflow during SOFC-GT hybrid system start-up process. Different ramp rates enable the rapid start-up of the turbine to avoid surge and stall, meanwhile enable acceptable warm rate of the fuel cell stack without damaging the cell material. CPS can enable dynamic characterizations of highly integrated systems at lower cost.

Zhou, Nana↗

Integrated Energy Systems

Leveraging the synergies among different energy technologies, Integrated Energy Systems (IES) can achieve greater efficiency, higher flexibility, and better CO2 removal concurrently. However, system integration in reality faces various challenges and difficulties. To integrate with other components, off-the-shelf equipment needs case-by-case modifications and redesigns. This presentation will use two integrated systems as examples to reveal the challenges in system integration.

Zhou, Nana↗

Operation and Dynamic Control of Hybrid Power Systems

Poster describing the planned startup process of a solid oxide gas turbine hybrid power system to be constructed at a 20 kW scale. The work is part of the ARPA-E project award to NETL under the INTEGRATE program.

Harun, Nor Farida↗

A real-time multiphysics model of a pressurized solid oxide electrolysis cell (SOEC) for cyber-physical simulation

Solid oxide electrolysis cells (SOEC) can play important roles in integrated energy systems (IES) as the hydrogen production hub and the resilience energy hub. When tied to a microgrid with high renewable penetration, the SOEC is subjected to rapid load transitions in response to the intermittent renewable generations that occur not only in diurnal cycles but also in short timeframes (e.g., sub-minute). The cyber-physical simulation approach can derisk operability research but requires a real-time dynamic SOEC model. In the present work, a real-time multiphysics model for pressurized SOEC is developed and validated in the pressure range from 1.4 to 8bar. Further, the accuracy of the single repeating unit (SRU) assumption in SOEC stack simulation is quantified. A guidance of more than 45 cells in one SOEC stack is recommended to safely apply the SRU assumption. Modeling results suggest that at a given current density, more power is consumed by SOEC at elevated operating pressures. The anode air and cathode stream have major impacts on thermal management, highlighting the potential benefit of integrating SOEC with other thermal processes in IES. To achieve high hydrogen production efficiency, the SOEC could operate at the maximum endothermic point to maximize the use of thermal energy. The real-time execution of the developed SOEC model is also demonstrated, which only takes 0.1% of the fixed time step of 5ms. The developed model establishes the basis for cyber-physical simulation of SOEC hybrid systems.

25 ENERGY STORAGE↗

Rapid Load Transition for Integrated Solid Oxide Fuel Cell - Gas Turbine (SOFC-GT) Energy Systems: A Demonstration of the Potential for Grid Response

Rapid load transition is an essential requirement for integrated energy systems to maintain grid resilience as more renewable resources are added to the grid. Integrated solid oxide fuel cell - gas turbine (SOFC-GT) systems can provide high efficiency and low carbon emissions over a broad range of turndown. These hybrids also have the potential to enable rapid grid response. The challenge has been to demonstrate effective control strategies to manage load transitions. In the present study, a load transition of ~50% was achieved in 10 s using a novel but simple strategy. Power demand on the SOFC and the GT were ramped down concurrently. During this transition, the SOFC anode fuel was manipulated to maintain SOFC fuel utilization while the cathode inlet air flow and temperature were also manipulated to thermally protect the SOFC. This study was conducted using the Hybrid Performance (Hyper) facility at the National Energy Technology Laboratory (NETL) in a co-simulation environment with the Idaho National Laboratory (INL)'s grid-simulation. The load ramping strategy was tested using a hardware-based cyber-physical simulation methodology. The results demonstrate a high-fidelity representation of SOFC-GT hybrid dynamics and validation of the control strategy. Thermal and electrochemical transients indicated that the SOFC was well protected during rapid load turndown without violating operability constraints. This demonstration revealed the non-linear nature of tightly coupled SOFC-GT system components, especially the non-linear response of SOFC cathode air flow and inlet temperature controls. These results highlight the needs and challenges in developing adaptive automatic controls for autonomous rapid load transitions. This work demonstrates that SOFC-GT hybrids are a viable option to provide the fast-ramping characteristics essential to accommodate high levels of variable renewable power while maintaining grid resilience, reliability, and environmental performance. The results also demonstrate the utility of co-simulation in advancing the tightly-coupled integrated energy systems needed to meet goals for zero-carbon power generation.

DIRECT ENERGY CONVERSION,POWER TRANSMISSION AND DI↗

Analyzing Gas Turbine-Generator Performance of the Hybrid Power System

We report kinetic energy available from the turbomachinery may boost short-term ramp rates during load shifting between generator and fuel cell that may be exploited to optimize the performance of turbine-fuel cell hybrid systems during load following. The paper starts with modeling a gas turbine, gearbox, and generator sitting on the rigid shafts as a two-mass model primarily for estimating the rotational inertia available from the turbogenerator. The gas turbine and its environment impose constraints of available space allowances, measurements from high-speed rotating parts, lack of accessibility to the shaft of measure, making replacements and/or required installation adjustments of the torque transducer difficult. It is demonstrated that in the absence of torque measurement, the data containing only a slow excursion of the rotor motion in response to a slight load change is sufficient to determine inertia and damping coefficients from the model. Furthermore, the generator’s reactive power capability was investigated because it serves as an asset in integrated hybrid systems to meet dynamic reactive power demands, reducing the burden on the fuel cell’s power electronics control in generating reactive power.

24 POWER TRANSMISSION AND DISTRIBUTION↗

Effect of Y{sub 2}O{sub 3} Addition on the Microstructure, Wear Resistance, and Corrosion Behavior of W-4.9Ni-2.1Fe Heavy Alloy

Binding and particle phases are the two important parameters influencing materials properties. In this study, a series of novel W-4.9Ni-2.1Fe-xY{sub 2}O{sub 3} (in weight%) alloys with different Y{sub 2}O{sub 3} contents are prepared by secondary ball milling and spark plasma sintering (SPS) techniques to obtain uniformly distributed γ-(Ni, Fe) binding phases and finer grains. The microstructure, mechanical, wear resistance, and corrosion behavior of the sintered bodies with different Y{sub 2}O{sub 3} were obtained by x-ray diffraction, scanning electron microscopy, Rockwell hardness tester, friction wear tester, and three-dimensional profile instruments. The results showed that a certain addition of Y{sub 2}O{sub 3} led to refined grains and uniformed microstructures; but, if excessive, a weak grain refinement would be appeared. Moreover, the grain size tends to be stable with enhancing of the Y{sub 2}O{sub 3} content. Considering properties such as density, hardness, compression yield strength, grain size, and uniform distribution of tungsten hard phase and γ-(Ni, Fe) binding phase, the comprehensive optimal amount of 0.7 wt.% of Y{sub 2}O{sub 3} was attained for the alloy. Meanwhile, the SPS sintered body also exhibited the best friction, wear behavior, and corrosion resistance in 3.5% of NaCl solution.

36 MATERIALS SCIENCE↗

Role of Bioreactors in Microbial Biomass and Energy Conversion

Bioenergy is the world’s largest contributor to the renewable and sustainable energy sector, and it plays a significant role in various energy industries. A large amount of research has contributed to the rapidly evolving field of bioenergy and one of the most important topics is the use of the bioreactor. Bioreactors play a critical role in the successful development of technologies for microbial biomass cultivation and energy conversion. In this chapter, after a brief introduction to bioreactors (basic concepts, configurations, functions, and influencing factors), the applications of the bioreactor in microbial biomass, microbial biofuel conversion, and microbial electrochemical systems are described. Importantly, the role and significance of the bioreactor in the bioenergy process are discussed to provide a better understanding of the use of bioreactors in managing microbial biomass and energy conversion.

Zhang, Liang↗

The EMT-related transcription factor snail up-regulates FAPα in malignant melanoma cells

Highlights: • The study finds a different regulation mechanism on FAPα expression. • Snail up-regulates expression of FAPα in malignant melanoma cells. • Snail binds to E-box in FAPα promoter to regulate FAPα expression. • Snail expression is positively correlated to FAPα expression in human cutaneous malignant melanoma. FAPα is a cell surface serine protease, mainly expressed in tumor stromal fibroblasts in more than 90% of human epithelial carcinomas. Due to its almost no expression in normal tissues and its tumor-promoting effects, FAPα has been studied as a novel potential target for antitumor therapy. However, the regulation mechanism on FAPα expression is poorly understood. In this study, we found that overexpression of snail significantly increased the mRNA and protein expression levels of FAPα in malignant melanoma B16 and SK-MEL-28 cells. Overexpression of snail increased FAPα promoter activity remarkably. Snail could directly bind to FAPα promoter to regulate FAPα expression. Moreover, snail expression was positively correlated to FAPα expression in human cutaneous malignant melanoma. Furthermore, knockdown of FAPα markedly reduced snail-induced cell migration. Overall, our findings provide a novel regulation mechanism on FAPα expression and highlight the role of snail/FAPα axis as a novel target for melanoma treatment.

60 APPLIED LIFE SCIENCES↗

Rain footprints on C-band synthetic aperture radar images of the ocean - Revisited

It is well known that rain leaves footprints on the sea surface that sometimes become visible on synthetic aperture radar (SAR) images. Rain cells can easily be detected on SAR images at all radar frequencies when they are associated with a downdraft pattern. But rain cells are not always associated with downdraft and rain can also occur in other forms, as stratified rain, rain bands, and squall lines. It turns out that radar signatures of rain at C-band are much more complex than at L- or X-band radar and that it is particularly difficult to identify unambiguously rain events on C-band SAR images acquired over the ocean. This is because C-band lies in the transition region where raindrops impinging onto the sea surface can increase (usually) or decrease the backscattered radar power and where volume scattering and attenuation by rain drops in the atmosphere are not always negligible (at very high rain rates). In order to get an insight into the physical mechanisms causing the C-band radar signatures of rain, we first revisit results obtained from historic laboratory and field experiments and multi-frequency/multi-polarization SAR data acquired during the SIR-C/X-SAR spaceshuttle mission in 1994. Then we analyze several C-band SAR images acquired by the European satellites Envisat and Sentinel-1A, and the Canadian satellite Radarsat-2 and compare them, whenever possible, with quasi-coincident and collocated weather radar images. The observational data show that, at low to medium rain rates, the main physical mechanism causing C-band radar signatures of rain is Bragg scattering at ring waves generated by the rain drops impinging onto the sea surface, which increase the radar backscatter. However, areas of increased radar backscatter are often accompanied by adjacent areas of decreased radar backscatter, which is due to attenuation of the Bragg waves by turbulence also generated by the impinging rain drops. Furthermore, we present a full-polarimetric Radarsat-2 SAR image of a rain cell together with a polarimetric decomposition analysis, which shows that the C-band radar signature of a rain cell is caused by surface scattering. The observation show that radar signatures of rain cells often contain segments, where the co-polarized as well the cross-polarized radar backscatter are strongly enhanced, which indicates non-Bragg scattering contributions to the scattering process. Furthermore, the polarimetric decomposition analysis shows that the C-band radar signature of a rain cell is dominated by surface scattering. Possible mechanisms, like scattering at splash products, are discussed. Whether the normalized radar cross section (NRCS) due to rain is increased or decreased depends on rain rate, wind speed, incidence angle, and history of the rain event. At low to moderate wind speeds (< 10 ms - 1 ) and low to medium high rain rates (< 50 mm h - 1 ), the NRCS is usually increased by up to 8 dB, and at high wind speeds (> 10 m s - 1 ) and low to high rain rates (but < 50 mm h - 1 ), the NRCS is usually decreased by up to 3 dB.

54 ENVIRONMENTAL SCIENCES↗