Search NASA⌕ Search

Engineering topics

Zhang, Dongzhou (ORCID:000000026679892X)

Publications and source records attributed to Zhang, Dongzhou (ORCID:000000026679892X).

Structure of ice VII with Hirshfeld atom refinement

In the refinement of the crystal structures of ice, the best results obtained so far have been with neutron diffraction because the most troublemaking aspects are the hydrogen atoms. In nine out of twenty ice structures, the hydrogen atoms are disordered, which makes proper refinement more difficult. In our previous paper describing the structure of ice VI we proved that, using Hirshfeld atom refinement (HAR) based on synchrotron X-ray data, it is possible to obtain results comparable with those from neutron experiments. In this work, we investigate another structure of high-pressure disordered ice, cubo-ice (ice VII). Single crystals of cubo-ice were grown under pressure in diamond anvil cells. X-ray diffraction measurements were conducted at a synchrotron source facility (APS, University of Chicago, USA) as well as on our regular in-house laboratory diffractometer with Ag radiation. The data collected were further refined with HAR. Comparison of the structural parameters obtained with those derived from neutron diffraction showed very good agreement in terms of bond lengths and fairly good agreement in terms of hydrogen atom ADPs. We were also able to perform unconstrained refinements with various split-atom models.

Chemistry↗

Pressure-induced phase transitions in Ni-bearing ferrosilite (Ni-En31Fs65)

Abstract Orthopyroxene is an abundant mineral in subducting slabs. Studying its phase transitions at high pressure is important to the understanding of mineralogy of subducting slabs in the deep Earth. Synchrotron-based single-crystal X-ray diffraction experiments were conducted on a synthetic Ni-bearing ferrosilite (Ni-En31Fs65) at pressures up to 33.8 GPa. Three phase transitions were observed at 12.1(6), 15.6(6), and 31.3(25) GPa. The first two phase transitions in Ni-En31Fs65 resemble the previously described phase transitions in Ni-free Fe-rich orthopyroxenes, i.e., the initial α-opx (Pbca) transforms to β-opx (P21/c), then the latter transforms to γ-opx (Pbca). This indicates that the incorporation of a few mol% NiSiO3 does not influence the phase transition path of Fe-rich orthopyroxene. After the third phase transition, the structure (P21ca) of Ni-En31Fs65 resembles the previously reported β-popx observed in En90 at high pressure, although the onset pressure of the phase transition in Ni-En31Fs65 is ~7 GPa lower than that in En90. β-popx has a post-pyroxene structure that contains fivefold- and sixfold-coordinated Si cations. Our results indicate that the post-pyroxene structure is β-popx (P21ca) for either Fe-poor or Fe-rich orthopyroxenes, although the phase transition path before the pyroxene → post-pyroxene is compositionally dependent. Additionally, unlike the second and third transitions, whose onset pressures are monotonously decreased by increasing Fe content, the Fe effect on shifting the first transition is much more significant for orthopyroxenes within En <50 mol% than that within En >50 mol%.

Geochemistry & Geophysics↗

Equation of state and structural evolution of manganese dolomite (kutnohorite) under high pressures

Abstract Understanding the structural evolution of carbonate minerals with increasing pressure is essential to decoding the role of Earth’s mantle in the global carbon cycle and long-term climate change. Here, we carried out synchrotron single-crystal X-ray diffraction measurements on a natural sample of manganese dolomite [kutnohorite, Ca1.11Mn0.89(CO3)2] in a diamond-anvil cell up to 51.2 GPa at room temperature with neon as the pressure-transmitting medium. The manganese dolomite sample remains stable in the rhombohedral structure from 1 bar to ~13.3 GPa. The equation of state of Ca1.11Mn0.89(CO3)2 was determined: V0 = 334.06 ± 0.29 Å3, K0 = 99.9 ± 4.7 GPa, and K0′ = 4.3 ± 0.9; when K0′ is fixed at 4.0, V0 = 334.04 ± 0.24 Å3, and K0 = 101.4 ± 1.5 GPa. Upon further compression at room temperature, the split and disappearance of diffraction spots were observed. That is, the rhombohedral structure of manganese dolomite becomes highly distorted to lose its long-range order at 13.3–51.2 GPa at room temperature. Moreover, our single-crystal X-ray diffraction results reveal the mechanisms of the reported lattice and internal Raman mode splits of the same manganese dolomite sample approximately at 13 and 24 GPa, respectively. These results suggest manganese-bearing carbonates may play a distinct role in the deep carbon cycle.

Geochemistry & Geophysics↗

High P‐T Sound Velocities of Amphiboles: Implications for Low‐Velocity Anomalies in Metasomatized Upper Mantle

Abstract Metasomatized mantle xenoliths containing hydrous minerals, such as amphiboles, serpentine, and phlogopite, likely represent the potential mineralogical compositions of the metasomatized upper mantle, where low seismic velocities are commonly observed. This study presents the first experimentally determined single‐crystal elasticity model of an Fe‐free near Ca, Mg‐endmember amphibole tremolite at high pressure and/or temperature conditions (maximum pressure 7.3(1) GPa, maximum temperature 700 K) using Brillouin spectroscopy. We found that sound velocities of amphiboles strongly depend on the Fe content. We then calculated the sound velocities of 441 hydrous‐mineral‐bearing mantle xenoliths collected around the globe, and quantitatively evaluated the roles that amphiboles, phlogopite and serpentine played in producing the low velocity anomalies in the metasomatized upper mantle.

Geology↗

Detection of thin film phase transformations at high-pressure and high-temperature in a diamond anvil cell

Abstract Quantifying how grain size and/or deviatoric stress impact (Mg,Fe) 2 SiO 4 phase stability is critical for advancing our understanding of subduction processes and deep-focus earthquakes. Here, we demonstrate that well-resolved X-ray diffraction patterns can be obtained on nano-grained thin films within laser-heated diamond anvil cells (DACs) at hydrostatic pressures up to 24 GPa and temperatures up to 2300 K. Combined with well-established literature processes for tuning thin film grain size, biaxial stress, and substrate identity, these results suggest that DAC-loaded thin films can be useful for determining how grain size, deviatoric stress, and/or the coexistence of other phases influence high-pressure phase stability. As such, this novel DAC-loaded thin film approach may find use in a variety of earth science, planetary science, solid-state physics, and materials science applications.

Environmental Sciences & Ecology↗

Crystal structure of calcium-ferrite type NaAlSiO4 up to 45 GPa

Abstract Alkali-rich aluminous high-pressure phases including calcium-ferrite (CF) type NaAlSiO4 are thought to constitute ~20% by volume of subducted mid-ocean ridge basalt (MORB) under lower mantle conditions. As a potentially significant host for incompatible elements in the deep mantle, knowledge of the crystal structure and physical properties of CF-type phases is therefore important to understanding the crystal chemistry of alkali storage and recycling in the Earth’s mantle. We determined the evolution of the crystal structure of pure CF-NaAlSiO4 and Fe-bearing CF-NaAlSiO4 at pressures up to ~45 GPa using synchrotron-based, single-crystal X-ray diffraction. Using the high-pressure lattice parameters, we also determined a third-order Birch-Murnaghan equation of state, with V0 = 241.6(1) Å3, KT0 = 220(4) GPa, and KT0′ = 2.6(3) for Fe-free CF, and V0 = 244.2(2) Å3, KT0 = 211(6) GPa, and KT0′ = 2.6(3) for Fe-bearing CF. The addition of Fe into CF-NaAlSiO4 resulted in a 10 ± 5% decrease in the stiffest direction of linear compressibility along the c-axis, leading to stronger elastic anisotropy compared with the Fe-free CF phase. The NaO8 polyhedra volume is 2.6 times larger and about 60% more compressible than the octahedral (Al,Si)O6 sites, with K0NaO8 = 127 GPa and K0(Al,Si)O6 ~304 GPa. Raman spectra of the pure CF-type NaAlSiO4 sample shows that the pressure coefficient of the mean vibrational mode, 1.60(7) cm–1/GPa, is slightly higher than 1.36(6) cm−1/GPa obtained for the Fe-bearing CF-NaAlSiO4 sample. The ability of CF-type phases to contain incompatible elements such as Na beyond the stability field of jadeite requires larger and less-compressible NaO8 polyhedra. Detailed high-pressure crystallographic information for the CF phases provides knowledge on how large alkali metals are hosted in alumina framework structures with stability well into the lowermost mantle.

Geochemistry & Geophysics↗

Amorphous Mn2SiO4: A potential manganese phase in the stagnant slab

Abstract Tephroite (Mn2SiO4), together with some manganese (Mn)-rich mineral inclusions, has been found in ophiolite-hosted diamonds, possibly originating from Mn-nodules and sediments that were once deposited on the oceanic floor and later subducted into the deep mantle, which provides evidence for oceanic crustal recycling. However, the state and behavior of tephroite under high-pressure and high-temperature conditions remain poorly understood. In this study, we conducted in situ synchrotron single-crystal X-ray diffraction (XRD) and Raman spectroscopy of synthetic tephroite up to ~30 GPa and ~900 K. The XRD and Raman spectroscopy experiments in this study first show that tephroite undergoes a pressure-induced, irreversible, amorphous transformation above ~20 GPa. Temperature (<900 K) is found to be an insignificant factor governing the process of amorphous transformation. Amorphous tephroite may be a potential phase in a rapidly cooling oceanic lithospheric subduction slab stagnating at the bottom of the mantle transition zone.

Geochemistry & Geophysics↗

Pressure-induced ferroelectric-like transition creates a polar metal in defect antiperovskites Hg3Te2X2 (X = Cl, Br)

Abstract Ferroelectricity is typically suppressed under hydrostatic compression because the short-range repulsions, which favor the nonpolar phase, increase more rapidly than the long-range interactions, which prefer the ferroelectric phase. Here, based on single-crystal X-ray diffraction and density-functional theory, we provide evidence of a ferroelectric-like transition from phase I 2 1 3 to R 3 induced by pressure in two isostructural defect antiperovskites Hg 3 Te 2 Cl 2 (15.5 GPa) and Hg 3 Te 2 Br 2 (17.5 GPa). First-principles calculations show that this transition is attributed to pressure-induced softening of the infrared phonon mode Γ 4 , similar to the archetypal ferroelectric material BaTiO 3 at ambient pressure. Additionally, we observe a gradual band-gap closing from ~2.5 eV to metallic-like state of Hg 3 Te 2 Br 2 with an unexpectedly stable R 3 phase even after semiconductor-to-metal transition. This study demonstrates the possibility of emergence of polar metal under pressure in this class of materials and establishes the possibility of pressure-induced ferroelectric-like transition in perovskite-related systems.

36 MATERIALS SCIENCE↗