Engineering topics
Zhang, Jianyue
Publications and source records attributed to Zhang, Jianyue.
A New Recycled Al–Si–Mg Alloy for Sustainable Structural Die Casting Applications
The use of secondary aluminum for structural components in the automotive industry is limited by the high Fe contents in recycled alloys which often result in the formation of brittle β-Al 5 FeSi phase which reduces the ductility of aluminum castings. In this study, a new secondary Al-Si-Mg alloy with high Fe content (about 0.44 wt.%) was developed for die casting applications. Based on thermodynamic modeling, manganese was added to obtain a designed Fe-to-Mn ratio of 2 which successfully suppressed the formation of β-Al 5 FeSi phase, by forming α-Al 15 (Fe,Mn) 3 Si 2 phase with rounded or hexagonal morphology. Additionally, a fine needle-like π-Al 8 FeMg 3 Si 2 phase was also formed within the eutectic regions. The new recycled alloy showed comparable mechanical properties in as-cast and heat treated (T5 and T6) conditions to three major primary die cast alloys (≤ 0.2 wt.% Fe) with similar composition. Ductility up to 7.4% from tensile elongation was achieved in as-cast recycled alloy due to the modification and refinement of α-Al 15 (Fe,Mn) 3 Si 2 by Mn and Sr additions. Tensile elongation was further improved to 9.1% after T6 treatment as a result of dissolution of π-Al 8 FeMg 3 Si 2 phase, defragmentation of α-Al 15 (Fe,Mn) 3 Si 2 and the spheroidization of Si phase. This new alloy provides a promising path for increasing usage of recycled aluminum with high Fe content in structural die castings for automotive and other applications.
On the interactions between molten aluminum and high entropy alloy particles during aluminum matrix composite processing
The feasibility of adding AlCrTiV high entropy alloy (HEA) particles to molten aluminum to make metal matrix composites was studied. Equiatomic AlCrTiV HEA particles, produced by a solid state reduction process, were dispersed into pure aluminum and 7075 alloy (Al-5.8Zn-2.3Mg-1.4Cu, all weight %) melt and by a ultrasonic dispenser. It was found that the AlCrTiV particles reacted with molten aluminum, leading to the formation of Al 45 (Cr,V) 7 and Al 3 Ti intermetallic phases in the aluminum matrix composites. Although the AlCrTiV HEA particles did not survive in molten aluminum during composite processing, the final composite materials showed significantly improved mechanical properties, due to grain refinement and dispersion strengthening. Finally, the research suggests that the interactions between matrix aluminum alloys and the particles are key in controlling the final microstructure and properties of the composites.
Increasing melt efficiency and secondary alloy usage in aluminum die casting
In this project, the focus was to develop thermodynamic and kinetic models for the aluminum melting process involving secondary alloys, refractory materials and flux materials. The major research outcome of this study is 1) the refractory composition of CaO (8-12%), microsilica (1-3%), BaSO 4 and/or BaO (no more than 5%), B 2 O 3 (5%) and Al 2 O 3 (balance) effectively reduced the reactions with liquid Al and alloying/impurity elements and heat transfer during melting and holding process. 2) a flux composition of NaCl-KCl-(1-10%)KAlF 4 exhibited an effective covering effect and prevented the dross formation during melting of Al process. 3) A high Fe (0.44%) content recycled Al alloy with compatible mechanical properties was developed based on the impurities control methods, which provides great potential to replace the commercial structural alloys from primary Al and increase the usage of secondary alloys.