Search NASA⌕ Search

Engineering topics

Zhang, Wu

Publications and source records attributed to Zhang, Wu.

Microwave-Assisted Conversion of 1,6-Hexanediol into Polycarbonate

The conversion of carbon dioxide into higher value chemicals is a viable way to support sustainability and net-zero economy goals. Of the different CO2 conversion routes, direct conversion offers a simplified process, lower reaction temperatures, and thus low energy input. Alcohols can be directly combined with CO2 to produce polycarbonates, e.g., DMC (dimethyl carbonate) formation from methanol and CO2. Recently CO2 and 1,6-hexanediol were shown to convert into poly(hexamethylene carbonate)diol using an atmospheric flow based process in single step. For these conversions, CeO2-based catalysts are widely used due to the abundance of oxygen vacancies that are believed to be the active sites for this reaction. Microwave (MW) heating is a unique approach that can provide selective volume-based heating and enhanced reaction rates and/or selectivities. For the current work, CO2 and diol conversion into polymers were investigated on different CeO2 catalysts under microwave heating and the performance was compared against conventional heating. The reaction products were analyzed using infrared spectroscopy (IR) and nuclear magnetic resonance (NMR) spectroscopy. Preliminary results showed microwaves irradiation produced faster rates of polycarbonate production as evidenced by IR data.

Kanitkar, Swarom↗

An Assessment of the Surface Longwave Direct Radiative Effect of Airborne Dust in Zhangye China During the Asian Monsoon Year Field Experiment (2008)

Tiny suspensions of solid particles or liquid droplets, called aerosols, hover in earth's atmosphere and can be found over just about anywhere including oceans, deserts, vegetated areas, and other global regions. Aerosols come in a variety of sizes, shapes, and compositions which depend on such factors as their origin and how long they have been in the atmosphere (i.e., their residence time). Some of the more common types of aerosols include mineral dust and sea salt which get lifted from the desert and ocean surfaces, respectively by mechanical forces such as strong winds. Depending on their size, aerosols will either fall out gravitationally, as in the case of larger particles, or will remain resident in the atmosphere where they can undergo further change through interactions with other aerosols and cloud particles. Not only do aerosols affect air quality where they pose a health risk, they can also perturb the distribution of radiation in the earth-atmosphere system which can inevitably lead to changes in our climate. One aerosol that has been in the forefront of many recent studies, particularly those examining its radiative effects, is mineral dust. The large spatial coverage of desert source regions and the fact that dust can radiatively interact with such a large part of the electromagnetic spectrum due to its range in particle size, makes it an important aerosol to study. Dust can directly scatter and absorb solar and infrared radiation which can subsequently alter the amount of radiation that would otherwise be present in the absence of dust at any level of the atmosphere like the surface. This is known as radiative forcing. At the surface dust can block incoming solar energy, however at infrared wavelengths, dust acts to partially compensate the solar losses. Evaluating the solar radiative effect of dust aerosols is relatively straightforward due in part to the relatively large signal-to-noise ratio in the measurements. At infrared wavelengths, on the other hand, the effect is rather difficult to ascertain since the measured dust signal level is on the same order as the instrumental uncertainties. Although the radiative impact of dust is much smaller in the infrared, it can still have a noticeable influence on the distribution of energy in the Earth-atmosphere system. This is mainly attributed to the strong light-absorptive properties commonly found in many earth minerals.

Hansell, Richard A.↗

Anthropogenic Air Pollution Observed Near Dust Source Regions in Northwestern China During Springtime 2008

Trace gases and aerosols were measured in Zhangye (39.082degN, 100.276degE, 1460 m a.s. 1.), a rural site near the Gobi deserts in northwestern China during spring 2008. Primary trace gases (CO:265 ppb; SO2:3.4 ppb; NO(*y): 4.2 ppb; hereafter results given as means of hourly data) in the area were lower than in eastern China, but still indicative of marked anthropogenic emissions. Sizable aerosol mass concentration (153 micro-g/cu m) and light scattering (159/Mm at 500 nm) were largely attributable to dust emissions, and aerosol light absorption (10.3/Mm at 500 nm) was dominated by anthropogenic pollution. Distinct diurnal variations in meteorology and pollution were induced by the local valley terrain. Strong daytime northwest valley wind cleaned out pollution and was replaced by southeast mountain wind that allowed pollutants to build up overnight. In the afternoon, aerosols had single scattering albedo (SSA, 500 mn) of 0.95 and were mainly of supermicron particles, presumably dust, while at night smaller particles and SSA of 0.89-0.91 were related to Pollution. The diverse local emission sources were characterized: the CO/SO2, CO/NO(y), NO(y)/SO2 (by moles), and BC/CO (by mass) ratios for small point sources such as factories were 24.6-54.2, 25.8-35.9, 0.79-1.31, and 4.1-6.1 x 10(exp -3), respectively, compared to the corresponding inventory ratios of 43.7-71.9, 23.7-25.7, 1.84-2.79, and 3.4-4.0 x 10(exp -3) for the industrial sector in the area. The mixing between dust and pollution can be ubiquitous in this region. During a dust storm shown as an example, pollutants were observed to mix with dust, causing discernible changes in both SSA and aerosol size distribution. Further interaction between dust and pollutants during transport may modify the properties of dust particles that are critical for their large-scale impact on radiation, clouds, and global biogeochemical cycles.

Li, Can↗