Search NASA⌕ Search

Engineering topics

Zhang, Xu

Publications and source records attributed to Zhang, Xu.

11 records
All sourcesNASA NTRSDOE OSTI
DOE OSTI2026

Regulation of Energy and Mass Transport in a Hydrogen-Bonded Framework for Visible-Light-Driven CO2 Reduction in Water

Photoenzymatic reduction of CO2 to formate is a promising strategy for carbon valorization, yet its efficiency is still limited by inefficient energy and mass transport. Here, we design a series of isostructural hydrogen-bonded organic frameworks (HOFs) that establish confinement effects to promote photocatalytic NADH regeneration and the subsequent NADH-dependent enzymatic CO2-to-formate reduction. We demonstrate that spatial confinement within the framework channels localizes exciton migration to nanoscale domains and promotes interfacial dissociation. Additionally, Rh-induced electronic-structure modulation enables ultrafast electron transfer, while the intrinsic hydrogen-bond network furnishes directional proton conduction to NAD+. These synergistic regulations afford a photocatalytic NADH regeneration efficiency of 99.8% with a record apparent quantum efficiency of 32.8%, and drive formate production at a rate of 3020 μmol g-1 h-1 with 100% selectivity─the highest rate reported to date for all light-driven systems in water. The HOF-based catalyst retains 86.3% of its initial activity over five cycles, highlighting its robustness. This work offers mechanistic insight into how microenvironment engineering within HOF architectures regulates energy and mass transport in photoenzymatic catalysis, paving the way for the rational design of advanced hybrid catalytic systems.

Xu, Jiaxing↗
DOE OSTI2025

Dual‐Gradient Construction on Li‐Rich Cathodes for High Stability Lithium Battery

Abstract The practical applications of high‐energy Li‐rich layered oxides (LLOs) have been hindered by the severe performance degradation including voltage decay and capacity fading. The gradient construction toward high‐activity interior and high‐stability exterior, typically realized by gradually changed transition metal (TM) gradient in LLOs, can alleviate the performance degradation to certain degrees. In this study, a gradient design of Al/Mg dopants is demonstrated for the TM‐gradient LLOs to further harmonize the high‐activity interior and high‐stability exterior, thereby forming the dual (TM and doping) gradient. As a result, superior capacity retention of 86% and a minor voltage decay of 0.54 mV cycle −1 are achieved at 1 C after 300 cycles. The improved electrochemical stability of the dual‐gradient LLO is attributed to the enhanced surface stability and suppressed bulk structure degeneration of LLOs upon electrochemical cycling. The dual‐gradient design serves as an important approach to fabricate high‐performance bulk LLOs toward applications.

Wu, Tianhao↗
DOE OSTI2024

Quantitative Identification of Dopant Occupation in Li‐Rich Cathodes

Elemental doping is widely used to improve the performance of cathode materials in lithium‐ion batteries. However, macroscopic/statistical investigation on how doping sites are distributed in the material lattice, despite being a key prerequisite for understanding and manipulating the doping effect, has not been effectively established. Herein, to solve this predicament, a universal strategy is proposed to quantitatively identify the locations of Al and Mg dopants in lithium‐rich layered oxides (LLOs). Solid evidence confirms that Al prefers to occupy the transition metal (TM) layer, while Mg evenly occupies both TM and Li layers. As a result, Mg significantly reduces the thickness of LiO 2 slabs at room temperature, which will increase the energy barrier of oxygen activation and enhance the structure stability of LLOs. The suppressed oxygen activity in Mg‐doped LLO can be kinetically unlocked at 55 °C. The different characteristics of Al and Mg enlighten an Al/Mg co‐doping strategy to optimize LLOs, which significantly improves the cycle performance while lifting the capacity. In conclusion, these insights from the quantitative identification of doping sites shed light on the manipulation of doping effects toward better cathodes.

25 ENERGY STORAGE↗
DOE OSTI2024

Circulating levels of micronutrients and risk of osteomyelitis: a Mendelian randomization study

Background Few observational studies have investigated the effect of micronutrients on osteomyelitis, and these findings are limited by confounding and conflicting results. Therefore, we conducted Mendelian randomization (MR) analyses to evaluate the association between blood levels of eight micronutrients (copper, selenium, zinc, vitamin B12, vitamin C, and vitamin D, vitamin B6, vitamin E) and the risk of osteomyelitis. Methods We performed the two-sample and multivariable Mendelian randomization (MVMR) to investigate causation, where instrument variables for the predictor (micronutrients) were derived from the summary data of micronutrients from independent cohorts of European ancestry. The outcome instrumental variables were used from the summary data of European-ancestry individuals ( n = 486,484). The threshold of statistical significance was set at p < 0.00625. Results We found a significant causal association that elevated zinc heightens the risk of developing osteomyelitis in European ancestry individuals OR = 1.23 [95% confidence interval (CI) [1.07, 1.43]; p = 4.26E-03]. Similarly, vitamin B6 showed a similar significant causal effect on osteomyelitis as a risk factor OR = 2.78 (95% CI [1.34, 5.76]; p = 6.04E-03; in the secondary analysis). Post-hoc analysis suggested this result (vitamin B6). However, the multivariable Mendelian randomization (MVMR) provides evidence against the causal association between zinc and osteomyelitis OR = 0.98(95% CI [−0.11, 0.07]; p = 7.20E-1). After searching in PhenoScanner, no SNP with confounding factors was found in the analysis of vitamin B6. There was no evidence of a reverse causal impact of osteomyelitis on zinc and vitamin B6. Conclusion This study supported a strong causal association between vitamin B6 and osteomyelitis while reporting a dubious causal association between zinc and osteomyelitis.

Zhang, Xu↗
DOE OSTI2024

High–Energy Earth–Abundant Cathodes with Enhanced Cationic/Anionic Redox for Sustainable and Long–Lasting Na–Ion Batteries

Layered iron/manganese-based oxides are a class of promising cathode materials for sustainable batteries due to their high energy densities and earth abundance. However, the stabilization of cationic and anionic redox reactions in these cathodes during cycling at high voltage remain elusive. Here, an electrochemically/thermally stable P2-Na 0.67 Fe 0.3 Mn 0.5 Mg 0.1 Ti 0.1 O 2 cathode material with zero critical elements is designed for sodium-ion batteries (NIBs) to realize a highly reversible capacity of ≈210 mAh g –1 at 20 mA g –1 and good cycling stability with a capacity retention of 74% after 300 cycles at 200 mA g –1 , even when operated with a high charge cut-off voltage of 4.5 V versus sodium metal. Combining a suite of cutting-edge characterizations and computational modeling, it is shown that Mg/Ti co-doping leads to stabilized surface/bulk structure at high voltage and high temperature, and more importantly, enhances cationic/anionic redox reaction reversibility over extended cycles with the suppression of other undesired oxygen activities. This work fundamentally deepens the failure mechanism of Fe/Mn-based layered cathodes and highlights the importance of dopant engineering to achieve high-energy and earth-abundant cathode material for sustainable and long-lasting NIBs.

25 ENERGY STORAGE↗
DOE OSTI2024

Multigap nodeless superconductivity in the topological semimetal PdTe

Recently, PdTe was identified as a spin-orbit-coupled topological Dirac semimetal and was claimed to exhibit both bulk-nodal and surface-nodeless superconducting gaps. Here we report on ultra-low-temperature thermal-conductivity measurements on PdTe single crystals with T c = 4.5 K to investigate its superconducting gap structure. It is found that the residual linear term κ 0 /T is negligible in zero magnetic field. Furthermore, the field dependence of κ 0 ⁡(H)/T exhibits an S-shaped curve. These results suggest that PdTe has multiple nodeless superconducting gaps, which is at odds with the claimed bulk-nodal gap. The reason for the discrepancy is likely that previous angle-resolved photoemission spectroscopy measurements were only performed down to 2 K and cannot observe the smaller nodeless gap. As a result, the fully gapped superconducting state in PdTe is compatible with it being a topological superconductor candidate.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗
DOE OSTI2023

Physically-based control-oriented modeling for turbocharged stoichiometric spark-ignited engine with cooled EGR and flexible VVT systems

Accurate estimation and prediction of engine gas exchange system and in-cylinder conditions are critical for spark-ignited engine control and diagnostic algorithm development. In this paper, a physically-based, control-oriented model for a 2.8 l turbocharged, variable valve timing (VVT) and low pressure (LP) exhaust gas recirculation (EGR)-utilizing SI engine was developed. The model includes the impact of modulation to any combination of 10 actuators, including the throttle valve, compressor bypass valve, fueling rate, waste-gate, LP EGR valve, number of deactivated cylinders, intake valve open (IVO) timing, intake valve close (IVC) timing, exhaust valve open (EVO) timing and exhaust valve close (EVC) timing. The accuracy of the model in capturing engine dynamics was demonstrated by validating it against high-fidelity engine GT-Power simulation results for various drive cycles, particularly emphasizing elevated loads. In comparison to the open literature, novel contributions of the effort described in this paper includes in-cylinder gas composition modeling and turbine-out pressure estimation.

Zhang, Xu↗
DOE OSTI2023

Engineering the fracture resistance of 2H-transition metal dichalcogenides using vacancies: An in-silico investigation based on HRTEM images

Vacancy engineering of 2H-transition metal dichalcogenides (2H-TMDs) has recently attracted great attention due to its potential to fine-tune the phonon and opto-electric properties of these materials. From a mechanical perspective, this symmetry-breaking process typically reduces the overall crack resistance of the material and adversely affects its reliability. However, vacancies can trigger the formation of heterogeneous phases that synergistically improve fracture properties. In this study, using MoSe2 as an example, we characterize the types and density of vacancies that can emerge under electron irradiation and quantify their effect on fracture. Molecular dynamic (MD) simulations, employing a re-parameterized Tersoff potential capable of accurately capturing bond dissociation and structural phase changes, reveal that isolated transition metal monovacancies or chalcogenide divacancies tend to arrest the crack tip and hence enhance the monolayer toughness. In contrast, isolated chalcogenide monovacancies do not significantly affect toughness. The investigation further reveals that selenium vacancy lines, formed by high electron dose rates, alter the crack propagating direction and lead to multiple crack kinking. Using atomic displacements and virial stresses together with a continuum mapping, displacement, strain, and stress fields are computed to extract mechanistic information, e.g., conditions for crack kinking and size effects in fracture events. The study also reveals the potential of specific defect patterns, “vacancy engineering,” to improve the toughness of 2H-TMDs materials.

36 MATERIALS SCIENCE↗
NASA NTRS2017

The PMIP4 Contribution to CMIP6-Part 4: Scientific Objectives and Experimental Design of the PMIP4-CMIP6 Last Glacial Maximum Experiments and PMIP4 Sensitivity Experiments

The Last Glacial Maximum (LGM, 21,000 years ago) is one of the suite of paleoclimate simulations included in the current phase of the Coupled Model Intercomparison Project (CMIP6). It is an interval when insolation was similar to the present, but global ice volume was at a maximum, eustatic sea level was at or close to a minimum, greenhouse gas concentrations were lower, atmospheric aerosol loadings were higher than today, and vegetation and land-surface characteristics were different from today. The LGM has been a focus for the Paleoclimate Modelling Intercomparison Project (PMIP) since its inception, and thus many of the problems that might be associated with simulating such a radically different climate are well documented. The LGM state provides an ideal case study for evaluating climate model performance because the changes in forcing and temperature between the LGM and pre-industrial are of the same order of magnitude as those projected for the end of the 21st century. Thus, the CMIP6 LGM experiment could provide additional information that can be used to constrain estimates of climate sensitivity. The design of the Tier 1 LGM experiment (lgm) includes an assessment of uncertainties in boundary conditions, in particular through the use of different reconstructions of the ice sheets and of the change in dust forcing. Additional (Tier 2) sensitivity experiments have been designed to quantify feedbacks associated with land-surface changes and aerosol loadings, and to isolate the role of individual forcings. Model analysis and evaluation will capitalize on the relative abundance of paleoenvironmental observations and quantitative climate reconstructions already available for the LGM.

Kageyama, Masa↗