Search NASA⌕ Search

Engineering topics

Zhao, Yuji

Publications and source records attributed to Zhao, Yuji.

At least 55 records · Page 3

Lateral and vertical growth of Mg-doped GaN on trench-patterned GaN films

Growth of Mg-doped GaN on trench-patterned GaN films consists of competing lateral and vertical growth fronts that result in regions with different electronic properties. Under typical growth conditions, lateral growth from the trench sidewall occurs at a faster rate than vertical growth from the trench base. When the trench width is sufficiently narrow, the growth fronts from opposite sidewalls coalesce and lead to eventual planarization of the top surface. Secondary electron imaging and cathodoluminescence mapping are used to correlate the morphology and the optical properties of regions resulting from lateral and vertical growth. For our growth conditions, the lateral-to-vertical growth rate ratio is found to be about 2.

Su, Po-Yi (ORCID:000000018339783X)↗

X-ray topography characterization of gallium nitride substrates for power device development

Gallium nitride substrates grown by the hydride vapor phase epitaxy (HVPE) method using a patterned growth process have been characterized by synchrotron monochromatic beam X-ray topography in the grazing incidence geometry. Images reveal a starkly heterogeneous distribution of dislocations with areas as large as 0 3 mm 2 containing threading dislocation densities below 10 3 cm -2 in between a grid of strain centers with higher threading dislocation densities (> 10 4 cm -2 ). Basal plane dislocation densities in these areas are as low as 104 cm -2 . By comparing the recorded images of dislocations with ray tracing simulations of expected dislocations in GaN, the Burgers vectors of the dislocations have been determined. The distribution of threading screw/mixed dislocations (TSDs/TMDs), threading edge dislocations (TEDs) and basal plane dislocations (BPDs) is discussed with implications for fabrication of power devices.

36 MATERIALS SCIENCE↗

Determination of electronic band structure by electron holography of etched-and-regrown interfaces in GaN p-i-n diodes

The electrostatic potential variation across etched-and-regrown GaN p-i-n diodes for power electronics has been studied using electron holography in a transmission electron microscope. The potential profiles have been correlated with the composition profiles of Mg, Si, and O obtained by secondary ion mass spectroscopy. Electronic charges obtained from the potential profiles correlate well with the presence of Si and O impurities at regrown interfaces. The overlap of Mg and Si when Mg doped GaN is grown directly over an etched undoped GaN surface results in the formation of a highly doped p-n junction. The introduction of a thin undoped layer over the etched GaN surface prevents the formation of such a junction as the regrowth interface is moved away from the Mg-doped GaN, and results in diodes with improved reverse leakage currents, close to the best values of continuously grown p-i-n diodes. Potential profiles of continuously grown (not etched) p-i-n diodes are compared to those of etched-and-regrown diodes.

Alugubelli, Shanthan R. (ORCID:000000020202727X)↗

Steep-slope field-effect transistors with AlGaN/GaN HEMT and oxide-based threshold switching device

We report the demonstration of a steep-slope field-effect transistor with AlGaN/GaN MIS-HEMTs employing SiO 2 -based threshold switching devices in series with the source. The SiO 2 -based threshold switching devices exhibited steep slope when changing resistance states. The integrated steep-slope transistor showed a low subthreshold swing of sub-5 mV/dec with a transition range of over 10 5 in the transfer characteristics in both sweep directions at room temperature, as well as the low leakage current (10 -5 μA μm -1 ) and a high I ON /I OFF ratio (>10 7 ). Moreover, with the SiO 2 -based threshold switching devices we also observed a positive shift of threshold voltages of the integrated device. Results from more than 50 transfer characteristics measurements also indicate the good repeatability and practicability of such a steep-switching device, where the average steep slopes are below 10 mV/decade. In conclusion, this steep-slope transistor with oxide-based threshold switching devices can be further extended to various transistor platforms like Si and III–V and are of potential interest for the development of power switching and high frequency devices.

36 MATERIALS SCIENCE↗

Non-uniform Mg distribution in GaN epilayers grown on mesa structures for applications in GaN power electronics

A strong variation in the luminescence characteristics in Mg-doped GaN grown on mesa structures has been observed, with the sidewall luminescence being different from that of the flat regions. A comparison with the luminescence characteristics of Mg-doped GaN epilayers with different Mg concentrations indicates that the sidewall has a significantly lower Mg content. Here, this observed non-uniform Mg distribution is attributed to the dependence of Mg incorporation efficiency on the crystal orientation of the growth surface, which should impact the electrical performance of power devices.

36 MATERIALS SCIENCE↗

Threshold Switching and Memory Behaviors of Epitaxially Regrown GaN-on-GaN Vertical $p-n$ Diodes With High Temperature Stability

This letter reports the observation of threshold switching and memory behaviors of epitaxially regrown GaN-on-GaN vertical p-n diodes. This mechanism was ascribed to the conductive path formed by traps in the insulating layer at the regrowth interface after soft breakdown. The device can reliably switch more than 1000 cycles at both room temperature and 300 °C with small fluctuation on the set and reset voltage. The set voltage increased with the increasing temperature due to the enhanced thermal detrapping effect that made it harder to form conductive path at high temperatures. Besides, the device showed memory behaviors when the reset voltage was higher than 4.4 V. This letter can serve as an important reference to further developing GaN-based memory devices and integrated circuits.

36 MATERIALS SCIENCE↗

Investigation of GaN-on-GaN vertical p - n diode with regrown p -GaN by metalorganic chemical vapor deposition

Here, to mimic selective-area doping, p -GaN was regrown on an etched GaN surface on GaN substrates by metalorganic chemical vapor deposition. Vertical GaN-on-GaN p - n diodes were fabricated to investigate the effects of the etch-then-regrowth process on device performance. The crystal quality of the sample after each epitaxial step was characterized by X-ray diffraction, where the etch-then-regrowth process led to a very slight increase in edge dislocations. A regrowth interfacial layer was clearly shown by transmission electron microscopy. Strong electroluminescence was observed with three emission peaks at 2.2 eV, 2.8 eV and 3.0 eV, respectively. The forward current density increased slightly with the increasing temperature, while the reverse current density was almost temperature independent indicating tunneling as the reverse transport mechanism. This result is very similar to the reported Zener tunnel diode comprising a high doping profile at the junction interface. High levels of silicon and oxygen concentrations were observed at the regrowth interface with a distribution width of ~100 nm. This work provides valuable information of p -GaN regrowth and regrown GaN p - n diodes, which can serve as an important reference for developing selective doping for advanced GaN power electronics for high voltage and high power applications.

42 ENGINEERING↗

Nonpolar vertical GaN-on-GaN p–n diodes grown on free-standing $(10\bar{1}0)$ m -plane GaN substrates

We report nonpolar vertical GaN-on-GaN p–n diodes grown on m-plane free-standing substrates. Cathodoluminescence measurements showed that the nonpolar p-GaN had a high quality with very few deep-level states. The device exhibited good rectifying behaviors with a turn-on voltage of 4.0 V, on-resistance of 2.3 mΩ∙cm 2 , and high on/off ratio of 10 10 . The reverse current leakage was described by a trap-assisted space-charge- limited current conduction mechanism. The critical electrical field was calculated to be 2.0 MV/cm without field plates or edge termination. Finally, these results pave the way for development of novel nonpolar power electronics and polarization-engineering-related advanced power devices.

36 MATERIALS SCIENCE↗

High Performance Vertical GaN-on-GaN p-n Power Diodes With Hydrogen-Plasma-Based Edge Termination

This letter reports the first implementation of a hydrogen-plasma-based edge termination technique (HPET) in vertical GaN p-n power diodes grown on bulk GaN substrates using metalorganic chemical vapor deposition. The device with a 9-μm-thick drift layer exhibited a high breakdown voltage (V bd ) of 1.57 kV, a low ON-resistance (R ON ) of 0.45 mQ · cm 2 (or 0.70 mQ · cm 2 with current spreading considered) and a high Baliga's figure-of-merit (V $2\atop{bd}$/R ON ) of 5.5 GW/cm 2 (or 3.6 GW/cm 2 ) without passivation or field plate, which are close to the theoretical limit of GaN. This technique enabled a significant reduction in leakage current (~10 6 times at -300 V) and a huge enhancement in V bd (from ~300 V to 1.57 kV). Furthermore, the device showed good forward characteristics with a turn-ON voltage of 3.5 V, an ON-current of ~2 kA/cm 2 (or 1.3 kA/cm 2 ), an ON/OFF ratio of -10 9 , and an ideality factor of 1.4. This work shows the HPET can serve as an effective, low cost, and easy-to-implement edge termination technique for high voltage and high power GaN p-n power diodes.

36 MATERIALS SCIENCE↗

Analysis of low efficiency droop of semipolar InGaN quantum well light-emitting diodes by modified rate equation with weak phase-space filling effect

We study the low efficiency droop characteristics of semipolar InGaN light-emitting diodes (LEDs) using modified rate equation incoporating the phase-space filling (PSF) effect where the results on c-plane LEDs are also obtained and compared. Internal quantum efficiency (IQE) of LEDs was simulated using a modified ABC model with different PSF filling (n{sub 0}), Shockley-Read-Hall (A), radiative (B), Auger (C) coefficients and different active layer thickness (d), where the PSF effect showed a strong impact on the simulated LED efficiency results. A weaker PSF effect was found for low-droop semipolar LEDs possibly due to small quantum confined Stark effect, short carrier lifetime, and small average carrier density. A very good agreement between experimental data and the theoretical modeling was obtained for low-droop semipolar LEDs with weak PSF effect. These results suggest the low droop performance may be explained by different mechanisms for semipolar LEDs.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

Crystal orientation dependent intersubband transition in semipolar AlGaN/GaN single quantum well for optoelectronic applications

The optical properties of intersubband transition in a semipolar AlGaN/GaN single quantum well (SQW) are theoretically studied, and the results are compared with polar c-plane and nonpolar m-plane structures. The intersubband transition frequency, dipole matrix elements, and absorption spectra are calculated for SQW on different semipolar planes. It is found that SQW on a certain group of semipolar planes (55° < θ < 90° tilted from c-plane) exhibits low transition frequency and long wavelength response with high absorption quantum efficiency, which is attributed to the weak polarization-related effects. Furthermore, these semipolar SQWs show tunable transition frequency and absorption wavelength with different quantum well thicknesses, and stable device performance can be achieved with changing barrier thickness and Al compositions. All the results indicate that the semipolar AlGaN/GaN quantum wells are promising candidate for the design and fabrication of high performance low frequency and long wavelength optoelectronic devices.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

High-power low-droop violet semipolar (303{sup ¯}1{sup ¯}) InGaN/GaN light-emitting diodes with thick active layer design

Devices grown on nonpolar and semipolar planes of GaN offer key performance advantages over devices grown on the conventional c-plane, including reduced polarization fields. This allows for a wider design space on semipolar planes for light emitting diodes (LEDs) to address the problem of efficiency droop at high current densities. LED structures with very thick (10–100 nm) InGaN single-quantum-well/double heterostructure active regions were grown using conventional metal organic chemical vapor deposition on semipolar (303{sup ¯}1{sup ¯}) free-standing GaN substrates and processed and packaged using conventional techniques. Simulated band diagrams showed reduced polarization fields on the (303{sup ¯}1{sup ¯}) plane. The calculated critical thickness for misfit dislocation formation is higher on the (303{sup ¯}1{sup ¯}) plane than on other semipolar planes, such as (202{sup ¯}1{sup ¯}), allowing for thicker active regions than our previous work to further reduce droop. The higher critical thickness was confirmed with defect characterization via cathodoluminescence. A trend is demonstrated in lower efficiency droop for devices with thicker active regions. Thermal droop characteristics of these devices are also presented. These observed results were utilized to demonstrate over 1 W of output power at a current density of 1 kA/cm{sup 2} from a single 0.1 mm{sup 2} LED device.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗