Search NASA⌕ Search

Engineering topics

Zhen, Zhao

Publications and source records attributed to Zhen, Zhao.

Image phase shift invariance based cloud motion displacement vector calculation method for ultra-short-term solar PV power forecasting

Irradiance received on the earth's surface is the main factor that affects the output power of solar PV plants, and is chiefly determined by the cloud distribution seen in a ground-based sky image at the corresponding moment in time. It is the foundation for those linear extrapolation-based ultra-short-term solar PV power forecasting approaches to obtain the cloud distribution in future sky images from the accurate calculation of cloud motion displacement vectors (CMDVs) by using historical sky images. Theoretically, the CMDV can be obtained from the coordinate of the peak pulse calculated from a Fourier phase correlation theory (FPCT) method through the frequency domain information of sky images. The peak pulse is significant and unique only when the cloud deformation between two consecutive sky images is slight enough, which is likely possible for a very short time interval (such as 1?min or shorter) with common changes in the speed of cloud. Sometimes, there will be more than one pulse with similar values when the deformation of the clouds between two consecutive sky images is comparatively obvious under fast changing cloud speeds. This would probably lead to significant errors if the CMDVs were still only obtained from the single coordinate of the peak value pulse. However, the deformation estimation of clouds between two images and its influence on FPCT-based CMDV calculations are terrifically complex and difficult because the motion of clouds is complicated to describe and model. Therefore, to improve the accuracy and reliability under these circumstances in a simple manner, an image-phase-shift-invariance (IPSI) based CMDV calculation method using FPCT is proposed for minute time scale solar power forecasting. First, multiple different CMDVs are calculated from the corresponding consecutive images pairs obtained through different synchronous rotation angles compared to the original images by using the FPCT method. Second, the final CMDV is generated from all of the calculated CMDVs through a centroid iteration strategy based on its density and distance distribution. Third, the influence of different rotation angle resolution on the final CMDV is analyzed as a means of parameter estimation. Simulations under various scenarios including both thick and thin clouds conditions indicated that the proposed IPSI-based CMDV calculation method using FPCT is more accurate and reliable than the original FPCT method, optimal flow (OF) method, and particle image velocimetry (PIV) method.

14 SOLAR ENERGY↗

Modeling of plasma chemistry in an atmospheric pressure Ar/NH{sub 3} cylindrical dielectric barrier discharge described using the one-dimensional fluid model

The keynote of our research is to study the gas phase chemistry in an atmospheric pressure Ar/NH{sub 3} cylindrical dielectric barrier discharge, which is very important to produce the iron-nitride magnetic fluid. For this purpose, a home-made one dimensional fluid model with the Scharfetter-Gummel method has been developed. The equations solved are the particle balances, assuming a drift-diffusion approximation for the fluxes, and the electron energy equation. The self-consistent electric field is obtained by the simultaneous solution of Poisson's equation. The simulations were carried out for the different ammonia concentrations (2%, 3.5%, and 7%), at a voltage of 1 kV, and a driving frequency of 20 kHz. It concluded that the major ion products of Ar are Ar{sup +} and Ar{sub 2}{sup +}. Ar{sup +} is the most important positive ions, followed by Ar{sub 2}{sup +}. It is shown that the NH{sup +} density is smaller than that of the other ammonia ions. The density of NH{sub 4}{sup +} is more than that of the other ammonia ions when the ammonia concentration increased. The diffuse mode can be established after the discharge was ignited, and the mode changes to filamentary mode with an increase in ammonia concentration.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Simulation of an Ar/NH{sub 3} low pressure magnetized direct current discharge

A two-dimensional fluid model has been used to investigate the properties of plasma in an Ar/NH{sub 3} low pressure magnetized direct current discharge. We compared the simulation results with the theoretical and experimental results of the other gas discharge in which the magnetic field is considered. Results that obtained using this method are in good agreement with literature. The simulation results show that the positive ammonia ion density follows the positive argon ion density. The Ar{sub 2}{sup +} density is slightly higher than the Ar{sup +} density at 100 mTorr. The largest ammonia ion is NH{sub 3}{sup +} ion, followed by NH{sub 2}{sup +}, NH{sub 4}{sup +}, and NH{sup +} ions. The contribution of NH{sup +} ions to the density of the positive ammonia ions is marginal. The influence of pressure on the plasma discharge has been studied by simulation, and the mechanisms have been discussed. The average plasma density increases as pressure increased. The plasma density appears to be more inhomogeneous than that at the lower pressure. The ratio of charge particles changed as pressure increased. The Ar{sup +} density is slightly higher than the Ar{sub 2}{sup +} density as the pressure increased. It makes NH{sub 4}{sup +} ratio increase as pressure increased. It shows that the electron temperature drops with rising pressure by numerical calculation.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Numerical analysis of a mixture of Ar/NH{sub 3} microwave plasma chemical vapor deposition reactor

A two-dimensional fluid model has been used to investigate the properties of plasma in Ar/NH{sub 3} microwave electron cyclotron resonance discharge at low pressure. The electromagnetic field model solved by the three-dimensional Simpson method is coupled to a fluid plasma model. The finite difference method was employed to discrete the governing equations. 40 species (neutrals, radicals, ions, and electrons) are consisted in the model. In total, 75 electron-neutral, 43 electron-ion, 167 neutral-neutral, 129 ion-neutral, 28 ion-ion, and 90 3-body reactions are used in the model. According to the simulation, the distribution of the densities of the considered plasma species has been showed and the mechanisms of their variations have been discussed. It is found that the main neutrals (Ar*, Ar**, NH{sub 3}{sup *}, NH, H{sub 2}, NH{sub 2}, H, and N{sub 2}) are present at high densities in Ar/NH{sub 3} microwave electron cyclotron resonance discharge when the mixing ratio of Ar/NH{sub 3} is 1:1 at 20 Pa. The density of NH is more than that of NH{sub 2} atom. And NH{sub 3}{sup +} are the most important ammonia ions. But the uniformity of the space distribution of NH{sub 3}{sup +} is lower than the other ammonia ions.

74 ATOMIC AND MOLECULAR PHYSICS↗

Polarization and charge transfer in the hydration of chloride ions

A theoretical study of the structural and electronic properties of the chloride ion and water molecules in the first hydration shell is presented. The calculations are performed on an ensemble of configurations obtained from molecular dynamics simulations of a single chloride ion in bulk water. The simulations utilize the polarizable AMOEBA force field for trajectory generation and MP2-level calculations are performed to examine the electronic structure properties of the ions and surrounding waters in the external field of more distant waters. The ChelpG method is employed to explore the effective charges and dipoles on the chloride ions and first-shell waters. The quantum theory of atoms in molecules (QTAIM) is further utilized to examine charge transfer from the anion to surrounding water molecules. The clusters extracted from the AMOEBA simulations exhibit high probabilities of anisotropic solvation for chloride ions in bulk water. From the QTAIM analysis, 0.2 elementary charges are transferred from the ion to the first-shell water molecules. The default AMOEBA model overestimates the average dipole moment magnitude of the ion compared to the quantum mechanical value. The average magnitude of the dipole moment of the water molecules in the first shell treated at the MP2-level, with the more distant waters handled with an AMOEBA effective charge model, is 2.67 D. This value is close to the AMOEBA result for first-shell waters (2.72 D) and is slightly reduced from the bulk AMOEBA value (2.78 D). The magnitude of the dipole moment of the water molecules in the first solvation shell is most strongly affected by the local water-water interactions and hydrogen bonds with the second solvation shell, rather than by interactions with the ion.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗