Engineering topics
Zuffada, Cinzia
Publications and source records attributed to Zuffada, Cinzia.
Comparison of SAR and CYNSS surface water extent metrics over the Yucatan Lake wetland site
Wetlands have a major role in the carbon cycle, outgassing large quantities of carbon dioxide and methane through processes that are directly and strongly influenced by the duration and timing of inundation. Therefore, understanding the seasonal pattern of inundation can be a component for regional to global scale carbon models. Measurement of inundation extent also establishes a benchmark for the current status of wetland areas, useful in assessing the future impacts of climate change. The incorporation of frequent measurements of inundation extent into large-scale hydrological models would permit the evaluation of more detailed seasonal and longer-term floodplain dynamics and their associated management implications.The Cyclone GNSS (CYGNSS) constellation of satellites launched in 2016, and carries receivers capable of receiving data from L-band GNSS reflections. Delay Doppler maps (DDM) are generated on board and telemetered to the ground, along with a small number of raw data takes that can be used for special processing on the ground for evaluation purposes. It has been previously shown that these data can be sensitive to inundation.The NASA ISRO Synthetic Aperture Radar, currently planned for launch in January 2023, has both an L-band and S-band SAR for earth imaging. The L-band SAR, which will image the Earth's land mass twice every 12 days, has a requirement for measuring wetland inundation extent at the 1 ha scale. One of the sites that will be used to validate this requirement is Yucatan Lake, Louisiana. This oxbow lake and surrounding area located adjacent to the Mississippi river experiences periodic and extensive flooding in the surrounding forest areas.In 2019, NASA's UAVSAR fully polarimetric airborne L-band SAR conducted a flight campaign to image a dozen sites in the SE USA at approximately 12-day intervals and both in the morning and evening, to simulate the type of data NISAR will obtain. One site imaged during this campaign was the Yucatan Lake area, spanning water stages from low to high flood conditions.It has been demonstrated previously that GNSS reflectometry such as that measured by CYGNSS may be used to characterize surface inundation. It has also been known for decades that L-band SAR may be used to characterize not only the presence of open water, but also the presence of subcanopy inundation in forested areas. In this paper we will present results comparing data from these two types of instruments.
State of the Art in GNSS-R Capabilities Over Inland Waters
GNSS Reflectometry (GNSS-R) measurements are very sensitive to the presence of inland waters such as wetlands, floods, rivers and lakes. This paper reviews the basic characteristics of a GNSS-R ‘water detection’ product, including resolution and temporal sampling of wetlands, and discusses the main known sources of errors.
Improved Orbit Determination of the Cygnss Satellites and its Application to Gnss-R Ocean Altimetry
The accuracy of spaceborne ocean surface altimetry depends on precise knowledge of the altimeter satellite orbit. Previous studies of the potential utility of CYGNSS GNSS Reflectometry (GNSS-R) measurements for ocean altimetry have identified its orbit error as a limiting factor. To address this, a recent firmware upgrade to the CYGNSS satellites have enabled the downlink of additional GPS raw measurements from its navigation receiver and increased numerical precision in open-loop GNSS-R tracking information. In this paper, we present improvements to the accuracy of both the orbit determination and the ocean surface height retrievals as a result of these recent upgrades. JPL’s GipsyX software is used to process 120 days of GPS navigation measurements for one of the 8 CYGNSS satellites. Incorporating high fidelity dynamic models and antenna group delay correction, daily orbit overlaps throughout the period show mean RMS differences of 3 cm in height, 7 cm in cross-track, and 10 cm in along-track. Applying these new orbits reduced the standard deviation of retrieved surface height anomalies. When spatially averaged, the sea surface height anomalies were reduced from 1.0 m to 0.8 m. Further improvements are expected using new ionospheric corrections and re-tracking methods currently in development.
Assessing the Altimetric Measurement from CYGNSS Data
The Cyclone Global Navigation Satellite System (CYGNSS) mission was designed to study hurricane intensification by measuring wind speeds in tropical cyclones. However, the delay-Doppler maps (DDM) that are produced can be used to estimate the sea surface height (SSH) at the specular reflection point on the ocean surface. Proofof-concept studies that DDMs are suitable to solve for SSH have been recently reported (Clarizia et al., 2016; Mashburn et al., 2018), based on data acquired by the demonstration satellite experiment Tech Demo Sat - 1 (TDS-1) carrying a GNSS-R receiver similar to the ones onboard CYGNSS. Although the precision of each 1sec averaged SSH is considerably lower than that of the existing satellite altimeters, by virtue of the dense coverage and frequent revisit time exhibited by the constellation of 8 microsats, the error may be smoothed down considerably by optimal interpolation (Li et al., 2016). Hence the CYGNSS dataset presents a potential opportunity to sample the tropical oceans, and investigate the sensitivity of the SSH measurements to mesoscale eddies. Our objective is to analyze the CYGNSS data and test a suite of retrieval algorithms, including that of Mashburn et al., 2018 to obtain SSH, to understand the error sources and possible corrections when available. Because of the limited antenna gain of the CYGNSS instrument, the power SNR for general wind conditions is expected to be too low to accurately track the reflection point contribution, resulting in altimetry errors of the order of several meters. Other significant error sources are the CYGNSS satellites orbit knowledge, the ionosphere, the troposphere, the mean sea surface and the tides; some of these errors can be reduced by using models. The corrected SSH data will be assimilated into the ROMS high-resolution ocean model to investigate their ability to reproduce mesoscale eddies in the tropical oceans.
Robotic Exploration of Earth and Space at NASA’s Jet Propulsion Laboratory (JPL)
UNKNOWN
Wetland Mapping and Measurement of Flood Inundated Area Using Ground-Reflected GNSS Signals in a Bistatic Radar System
No abstract available