Engineering topics

de Campo, Liliana

Publications and source records attributed to de Campo, Liliana.

5 records

DOE OSTI2022

Uniformity and volume-representativity of consecutive submillimetre wafers of shale for SANS and USANS investigations

(Ultra) Small Angle Neutron Scattering (SANS/USANS) is a non-destructive technique suitable for characterization of porous structures from nano- to micro-pore size (1 nm to 20 μm), which has been widely used to characterize accessible and inaccessible porosity in tight unconventional hydrocarbon reservoirs (e.g., shales). Here, in this study, SANS and USANS are used to examine the degree of nano- to micropore uniformity of the rock body on sub-millimetre to centimetre scale. This study presents a test of the hypothesis of volume representativity of pore structure information measured by SANS and USANS for shale wafers (0.22–1 mm) cut from six North American unconventional shale cores of different maturities (New Albany Shale and Marcellus Shale). Experimental reproducibility of USANS is further investigated for two wafers measured using various acquisition times. All samples show that fluctuations of the relative intensity generally decrease from the USANS Q-range (pore size from around 200 nm to 20 μm) to most of the SANS Q-range (pore size from around 5 nm to 700 nm), and peaks in the SANS large-Q region (for pores smaller than about 5 nm). There is a positive correlation between the spatial fluctuation of the relative SANS intensity and the scattering power of shales. In addition, the scattering intensity and its fluctuations is larger for the less mature shale cores. Shale is known to be highly heterogenous and the hypothesis of uniformity does not apply at sub-millimetre scale even for samples that appear homogeneous at visual inspection. This study presents an approach to minimise the variation through sample selection, data interpretation methodology and instrumental reproducibility tests. The best values of the microstructural spatial uniformity for the apparently homogeneous sections of a core (i.e., the SANS and USANS intensity variation) is less than ±10%.

01 COAL, LIGNITE, AND PEAT↗

DOE OSTI2022

How to avoid multiple scattering in strongly scattering SANS and USANS samples

Small Angle Neutron Scattering (SANS) and Ultra Small Angle Neutron Scattering (USANS) are the only available experimental techniques to provide seamless non-destructive measurements of the geometry of the accessible and inaccessible pore structure of rocks from sub-nanopore size to the scale of macropores. They have therefore become the measurement of choice for tight reservoir rocks such as organic rich shales. A simplifying assumption in the analysis is, however, that during the path of neutrons through the sample each neutron is only scattered once. Shales are samples with a high scattering power and Multiple Scattering (MS) may occur which requires special modelling for deconvolution of the results. The approach to avoid MS is to simply reduce the sample thickness to <0.15–0.5 mm. Here, in this work, we present a systematic method on wavelength selection and preparation of samples to optimise extraction of microstructural data and minimise parasitic errors. Experimentally measured SAS transmission (TSAS) values are used as a practical criterion for estimation of the extent of MS. Generous beamtime allocations allowed robust testing revealing that sample thicknesses can be twice as thick as predicted using the standard protocol. Analysing thicker samples is particularly beneficial for statistically relevant characterisation of heterogeneous samples making the new protocol the method of choice for such samples.

(U)SANS↗

DOE OSTI2021

Accessibility of Pores to Methane in New Albany Shale Samples of Varying Maturity Determined Using SANS and USANS

The accessibility of pores to methane has been investigated in Devonian New Albany Shale Formation early-mature (Ro = 0.50%) to post-mature (Ro = 1.40%) samples. A Marcellus Shale Formation sample was included to expand the maturation range to Ro 2.50%. These are organic matter-rich rocks with total organic carbon (TOC) values of 3.4 to 14.4% and porosity values of 2.19 to 6.88%. Contrast matching small-angle neutron scattering (SANS) and ultra-small angle neutron scattering (USANS) techniques were used to generate porosity-related data before and after pressure cycling under hydrostatic (in a vacuum and at 500 bar of deuterated methane) and uniaxial stress (0 to ca. 350 bar) conditions. Our results showed that the accessible porosity was small for the samples studied, ranging from zero to 2.9%. No correlation between the accessible porosity and TOC or mineralogical composition was revealed, and the most likely explanation for porosity variation was related to the thermal transformation of organic matter and hydrocarbon generation. Pressure caused improvements in accessible porosity for most samples, except the oil window sample (Ro = 0.84%). Our data show that densification of methane occurs in nanopores, generally starting at diameters smaller than 20 nm, and that the distribution of methane density is affected by pressure cycling.

03 NATURAL GAS↗

DOE OSTI2021

Deformation of pores in response to uniaxial and hydrostatic stress cycling in Marcellus Shale: Implications for gas recovery

One of the main challenges during gas production from shale reservoirs is low recovery rate. One contributing factor to this outcome is an insufficient understanding of pore systems, especially pore behaviour following changes in reservoir conditions or resulting from gas production practices. Because the pressure in the producing well can be controlled, understanding the effects of pressure variation on the pore size distribution and methane trapping is necessary to help design optimal conditions to improve the gas recovery rate. This work is the first systematic study of sub-millimeter pore deformation in shale caused by uniaxial and hydrostatic stress up to 100 MPa. Overmature samples from the Middle Devonian Marcellus Shale were analyzed using neutron scattering (SANS and USANS) techniques to interpret the response of nanopores to stress cycling of magnitude and duration compatible with the hydraulic fracturing treatments. Experiments reported here are performed at a series of uniaxial pressures up to 100 MPa and at hydrostatic pressures of deuterated methane 0 and 50 MPa. Since at the original depth of the shale samples’ burial of 2184 m the hydrostatic pressure is approximately 27 MPa and the lithostatic pressure is about 55 MPa, the experimental conditions reasonably well simulate the reservoir pressure regime. Our SANS and USANS results show that different pore sizes are affected by uniaxial stress in different ways. Specifically, in the pore size range from 1 nm to 800 nm, a decrease of pore density with pressure is observed, with the most depleted being mesopores of about 100 nm in diameter. The observed decrease is likely related to deformation of kerogen, followed by a loss of pore nano-volume, as well as methane trapped in the micropores. For pores larger than 5 μm, USANS data suggest that the negative trend is reversed at above 74 MPa, and the number density of large macropores may increase with increased stress even above the original value. The increased number of macropores at high pressure may create new interconnected conduits for gas migration, resulting in a better recovery rate. Another important finding of this study is an irreversible rearrangement of pore size distribution taking place after pressure cycling. Furthermore, this irreversible reorganization of pore size distribution should be taken into account during management of well production to maximize recovery rate.

03 NATURAL GAS↗

DOE OSTI2021

Pore accessibility and trapping of methane in Marcellus shale

Accessibility of pore space in unconventional reservoirs is an important factor influencing both methane storage capacity and the kinetics of methane desorption. The determination of open (accessible) versus closed (inaccessible) porosity is therefore vital for the prediction of gas production potential. This study investigates accessibility of pores to methane in overmature middle Devonian Marcellus shale samples (cut parallel and perpendicular to bedding) using small and ultra-small neutron scattering (SANS and USANS) with contrast matching (CM), supplemented by other complementary techniques, such as mercury injection capillary pressure (MICP) and low pressure gas (N2 and CO2) adsorption. Our results demonstrate that for the samples studied, only about 6 % of pores with diameter 25-500 nm are accessible to methane. The accessibility fraction for pores larger than 500 nm is 35%. For nanopores smaller than 25 nm, pore accessibility could not be quantitatively determined due to increased methane density and condensation effects in confinement. Our observations indicate that methane penetrates the accessible small mesopores and micropores down to at least 1 nm in diameter, and the density of confined deuterated methane (CD4) is 0.68 g/cm3 for pores of diameter 25 nm and gradually increases with the decreased pore size. Moreover, elevated gas pressure causes formation of additional high-density methane nano-clusters. These clusters have a form of slightly anisotropic polydisperse discs oriented along bedding plane, about 1-12 nm in diameter and with average thickness of 3.6 nm. Utilizing samples cut parallel and perpendicular to the bedding, this study also briefly addresses anisotropy of pores. Based on the iso-size intensity ratio R, our SANS and USANS results demonstrate anisotropy in the out-of-bedding direction and suggest that the degree of anisotropy depends on the pore size. Specifically, for pore diameters ~2.5 to 250 nm, the extent of anisotropy is smaller than for pores ~500 nm to 6 µm in diameter. Finally, comparison of pore size distribution results calculated from SANS/USANS to those obtained using MICP shows good agreement at low pressures, but large difference at pressures above 1000 bar. Here, this discrepancy requires further testing; it is possible that the high mercury pressure used in MICP alters the mesopore and micropore structure of shales.

03 NATURAL GAS↗