Engineering topics

de Matthaeis, Paolo

Publications and source records attributed to de Matthaeis, Paolo.

7 records

NASA NTRS2019

Detection of Residual “Hot Spots” in RFI-Filtered SMAP Data

Radio frequency interference (RFI) is a well-documented problem for passive remote sensing of the Earth at L-band even though the measurements are made in the protected band at 1.413 GHz. Consequently, filtering for RFI is an important early step in the processing of measurements made by the SMAP (Soil Moisture Active/Passive) radiometer. However, the filtered data still include regions with suspiciously high antenna temperatures. One possible cause of these “hot spots” is interference not fully detected during RFI filtering. This paper presents evidence supporting this hypothesis and describes an algorithm to identify these “hot spots” so that they can be removed from the measurements. The impact of removing these “hot spots” is generally small, but evidence is presented that the brightness temperature and soil moisture improve when the hot spots are removed.

Soldo, Yan↗

NASA NTRS2017

Localization of L-Band RFI Sources from SMAP Data

RFI (Radio-Frequency Interference) in the 1400-1427 MHz band degrades the quality of measurements made by satellite missions such as SMAP (Soil Moisture Active/Passive), Aquarius and SMOS (Soil Moisture and Ocean Salinity). A technique is presented here to estimate the location on the ground of RFI sources using SMAP measurements. The results of this technique have been validated against data derived by other means.

Soldo, Yan↗

NASA NTRS2017

RFI Statistical Distribution and Missed Detection in Aquarius Radiometer Measurements

Aquarius is an microwave active/passive sensor whose main goal is to globally estimate sea surface salinity from space. Two instruments, a radar scatterometer and a radiometer, operate at L-band observing the same surface footprint almost simultaneously. The sensitivity to sea surface salinity (SSS) is given by the radiometer, while the scatterometer measurements provide a correction for sea surface roughness. Although the primary objective is the measurement of SSS, the instrument combination operates continuously, acquiring data over land and sea ice as well. Radio Frequency Interference (RFI) can occur in both the radiometer and the scatterometer bands of operation, and for this reason detection and mitigation of RFI was included in the data processing of both active and passive instruments. This paper will focus on the RFI processing for the Aquarius radiometer only and provide an update on the efforts to reduce the amount of missed RFI detection.

RFI↗

NASA NTRS2017

L-band RFI Detected by SMOS and Aquarius

Ocean salinity and soil moisture are key parameters for understanding the global water cycle, weather, and climate. These parameters are being measured with spaceborne radiometers operating in the L-band window at 14001427 MHz. Although man-made activity in this band is prohibited, radio frequency interference (RFI) is still a problem over significant portions of the earth. This paper reports a comparison of the RFI environment in this window as observed by two L-band radiometer systems, Aquarius and Soil Moisture and Ocean Salinity. The observed RFI environment depends on the sources and also on the characteristics of the instrument. Comparing the observations provides insight into the extent of the problem (actual sources), the influence of the instrument on the observation of RFI, and on potential ways of mitigating the effects. As this report shows, the global distribution of RFI is largely consistent between the two instruments, but the details, especially at low levels of RFI, depend on the characteristics of the instrument.

microwave radiometry↗

NASA NTRS2016

L-Band RFI in Japan

In recent years, three instruments have been launched into orbit with the aim of producing global maps of sea surface salinity and soil moisture using the 1400-1427 MHz band: SMOS, Aquarius and SMAP. Although this frequency band is allocated to passive measurements only, RFI (Radio-Frequency Interference) is present in the data of all three missions. On a global scale, the three sensors have observed approximately the same distribution of RFI. Japan is an important exception that has implications for the design of RFI detection algorithms. RFI in Japan is caused by a large number of emitters belonging to the same system (TV receivers) and for this reason some traditional RFI detection strategies detect little to no RFI over Japan. The study of this case has led to an improvement of the approach to detect RFI in Aquarius data.

Aquarius↗

NASA NTRS2016

Analysis of RFI Statistics for Aquarius RFI Detection and Mitigation Improvements

Aquarius is an L-band active/passive sensor designed to globally map sea surface salinity from space. Two instruments, a radar scatterometer and a radiometer, observe the same surface footprint almost simultaneously. The radiometer is the primary instrument for sensing sea surface salinity (SSS), while the scatterometer is included to provide a correction for sea surface roughness, which is a primary source of error in the salinity retrieval. Although the primary objective is the measurement of SSS, the instrument combination operates continuously, acquiring data over land and sea ice as well. An important feature of the data processing includes detection and mitigation of Radio Frequency Interference (RFI) which is done separately for both active and passive instruments. Correcting for RFI is particularly critical over ocean because of the high accuracy required in the brightness temperature measurements for SSS retrieval. It is also necessary for applications of the Aquarius data over land, where man-made interference is widespread, even though less accuracy is required in this case. This paper will provide an overview of the current status of the Aquarius RFI processing and an update on the ongoing work on the improvement of the RFI detection and mitigation performance.

Microwave remote sensing↗

NASA NTRS2012

Aquarius Radiometer RFI Detection, Mitigation, and Impact Assessment

The Aquarius/SAC-D satellite was launched on 10 June 2011 into a sun-synchronous polar orbit and the Aquarius microwave radiometers [1] became operational on 25 August 2011. Since that time, it has been measuring brightness temperatures at 1.4 GHz with vertical, horizontal and 3rd Stokes polarizations . Beginning well before the launch, there has been the concern that Radio Frequency Interference (RFI) could have an appreciable presence. This concern was initiated by, among other things, its prevalence in both early [2] and more recent [3,4] aircraft field experiments using 1.4 GHz radiometers, as well as by the strong RFI environment encountered during the recent ESA SMOS mission, also at 1.4 GHz [5]. As a result, a number of methods for RFI detection and mitigation have been developed and tested. One in particular, "glitch detection" and "pulse blanking" mitigation has been adapted for use by Aquarius [6, 7]. The early on-orbit performance of the Aquarius RFI detection and mitigation algorithm is presented here, together with an assessment of the global RFI environment at 1.4 GHz which can be derived from the Aquarius results.

Ruf, Christopher↗