Dimensional stability considerations for cryogenic metals

Abstract

Work performed as part of an effort to identify, and where possible separate out, some of the factors that contribute to dimensional stability in cryogenic wind tunnel models is reported. Initial problems were encountered with two dimensional models made of 15-5 PH stainless steel, which warped significantly after being subjected to cryogenic testing in the 0.3 Meter Transonic Cryogenic Tunnel. Subsequently, an effort was undertaken to investigate the mechanisms that could cause model warpage during cryogenic testing. The two basic mechanisms that can lead to warpage are (1) metallurgical structural instability in which one phase transforms partially or fully into a second phase which has a different crystal structure and volume, and (2) deformation due to the creation, or relief, of unbalanced induced or residual stresses. In the case of the 15-5 PH airfoils, it is highly probable that metallurgical instability was responsible for most of the observed warpage. A particular specimen configuration was established for use in the systematic evaluation of the factors influencing warpage. Preliminary studies of a specimen made of VASCOMAX 200 suggest the possibility of manipulating the stresses in the surface layers by appropriate combinations of milling and grinding steps. This opens up the possibility of correcting or establishing the required surface profile of an airfoil.