Search NASA⌕ Search

NASA NTRS · 19930086241

Investigation of Perforated Convergent-divergent Diffusers with Initial Boundary Layer

Abstract

An experimental investigation was made at Mach number 1.90 of the performance of a series of perforated convergent-divergent supersonic diffusers operating with initial boundary layer, which was induced and controlled by lengths of cylindrical inlets affixed to the diffusers. Supercritical mass-flow and peak total-pressure recoveries were decreased slightly by use of the longest inlets (4 inlet diameters in length). Combinations of cylindrical inlets, perforated diffusers, and subsonic diffuser were evaluated as simulated wind tunnels having second throats. Comparisons with noncontracted configurations of similar scale indicated conservatively computed power reductions of 25 percent.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Weinstein, Maynard I. 1950-08-15. Investigation of Perforated Convergent-divergent Diffusers with Initial Boundary Layer. https://ntrs.nasa.gov/citations/19930086241

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related reports

Investigation of Pressure Recovery of a Single-conical-shock Nose Inlet at Mach Number 5.4

An experimental investigation of the performance of a single-conical-shock diffuser was conducted at a Mach number of 5.4 and a Reynolds number based on model diameter of 375,000. Total-pressure recoveries of 13.7 and 13.1 percent were obtained at angles of attack of 0 degrees and 3 degrees, respectively. The corresponding kinetic energy efficiencies were 86.4 percent at an angle of attack of 0 degrees and 86.0 percent at an angle of attack of 3 degrees.

DIFFUSERS, SUPERSONIC↗

Experimental Investigation of a Two-dimensional Split-wing Ram-jet Inlet at Mach Number of 3.85

Performance characteristics of a two-dimensional isentropic diffuser have been experimentally determined at a Mach number of 3.85. At zero angle of attack, a maximum total-pressure recovery of 0.41 was obtained with a supercritical mass-flow ratio of 0.95. As a consequence of the twin-duct arrangement of the diffuser, a large discontinuity in pressure recovery and mass flow with a characteristic hysteresis was encountered between critical and subcritical operation. An asymmetric shock pattern with large-scale separation and flow reversal in one of the passages occurred at reduced mass flows. Pressure and force data presented for an angle-of-attack range from zero to 4 degrees.

DIFFUSERS, SUPERSONIC↗

Pressure Recovery, Drag, and Subcritical Stability Characteristics of Three Conical Supersonic Diffusers at Stream Mach Numbers from 1.7 to 2.0

A study of a 20 degree and a 25 degree half-angle high mass-flow ratio conical supersonic inlet was made on a 16-inch ram jet in the 8- by 6-foot supersonic tunnel. A greater range of stable subcritical operation was obtained with the low mass-flow ratio inlets; a greater range was obtained with the 25 degree than with the 20 degree half-angle low mass-flow ratio inlet. The high mass-flow ratio inlet had the least drag.

DIFFUSERS, SUPERSONIC↗