Solidification in immiscible systems: The influence of processing conditions on resulting microstructures

Abstract

Research carried out over the past two decades in which attempts have been made to produce desirable microstructures in immiscible alloys is reviewed. Factors affecting the formation of desirable microstructures in immiscible alloys are addressed and some of the techniques that have been successful in controlling these factors in order to produce useful structures are discussed. Some of the intended applications of these alloys require a dispersion of one phase in the other, while other applications favor the use of aligned, fibrous microstructures with continuity of both phases. The microstructures obtained in immiscible alloys are often strongly influenced by processing conditions. Perhaps the most well known effect is gravity induced sedimentation of the denser immiscible phase during solidification. This difficulty with sedimentation led to low gravity processing in attempts to produce dispersed microstructures. However, experimentation under low gravity conditions soon revealed that many other factors, including wetting of the crucible walls and surface tension driven flows, often resulted in complete separation and coalescence of the two immiscible phases. The production of aligned fibrous microstructures in hypermonotectic alloys appears to be even more difficult than the formation of a dispersion. Here, in addition to sedimentation and crucible wetting, convective and interfacial instabilities must be considered as well. Calculation of the limits of stability during directional solidification were carried out but require experimental verification.