NASA NTRS · 20210003534
This paper will descrive a new exciting concept for using microwave systems for Earth remote sensing.
Explore connections, maps & timelines
Njoku, E., Wilson, W.. 1999-06-13. Future Radiometer Systems for Earth Remote Sensing. https://ntrs.nasa.gov/citations/20210003534
Cite the original work for its findings. Save a collection to share your selection of sources.
KEEP EXPLORING
This paper presents the validation of a digital signal processing technique that can be used to estimate radiometric sky noise, and hence, atmospheric absorption, within existing digital receivers at little/no additional cost. To demonstrate this, a receiver was constructed that simultaneously records the beacon signal power from the ALPHASAT Aldo Paraboni technology demonstration payload, as well as the integrated noise power in the adjacent band. Calibration from the digital radiometer is performed using tip-curve calibration procedures. Atmospheric fading is then obtained by observing the beacon as well as the radiometric signals. This enables the comparison of fading obtained by the two techniques and provides a means to calibrate the received beacon power level to obtain total atmospheric attenuation. It is shown that for low levels of fading, up to a few dB, the two techniques provide good agreement. This approach can therefore provide a low-cost option for geostationary mmwave satellite channel measurements in the low fading regime, which can be useful in the design and operation of the feeder links in emerging satcom systems.
The Tropical Rainfall Measurement Mission (TRMM) is a joint U.S. and Japan mission to observe tropical rainfall, which was launched by H-II No. 6 from Tanegashima in Japan at 6:27 JST on November 28, 1997. After the two-month commissioning of TRMM satellite and instruments, the original nominal mission lifetime was three years. In fact, the operations has continued for approximately 17.5 years. This paper provides a summary of the long term operations of TRMM.
We are currently developing a 118/183 GHz sensor that will enable observations of temperature and precipitation profiles over land and ocean. The 118/183 GHz system is well suited for a CubeSat deployment as ~10cm antenna aperture provides sufficiently small footprint sizes (is approx. 25km). This project will enable low cost, compact radiometer instrumentation at 118 and 183 GHz that would fit in a 6U CubeSat with the objective of mass-producing this design to enable a suite of small satellites to image the key geophysical parameters that are needed to improve prediction of extreme weather events. We will take advantage of past and current technology developments at JPL viz. HAMSR (High Altitude Microwave Scanning Radiometer), Advanced Component Technology (ACT'08) to enable low-mass and low-power high frequency airborne radiometers. The 35 nm InP enabling technology provides significant reduction in power consumption (Low Noise Amplifier + Mixer Block consumes 24 mW). In this paper, we will describe the design and implementation of the 118 GHz temperature sounder and 183 GHz humidity sounder instrument on the 6U CubeSat. In addition, a summary of radiometer calibration and retrieval techniques of the temperature and humidity will be discussed. The successful demonstration of this instrument on the 6U CubeSat would pave the way for the development of a constellation consisting of suite of these instruments. The proposed constellation of these 6U CubeSat radiometers would allow sampling of tropospheric temperature and humidity with fine temporal (on the order of minutes) and spatial resolution (is approx. 25 km).