Structural Shape Sensing from Strain Data Using the Basis Function Method

Abstract

An aircraft shape must be measured during flight to implement an active trim shape control, such as an active dihedral control for a highly flexible aircraft with a high-aspect-ratio wing, and an active sonic boom control for a supersonic transport aircraft. A basis function method for linear as well as geometrically nonlinear structural shape sensing is proposed in this study. Basis functions can be mode shapes, linear static deformation shapes, or geometrically nonlinear static deformation shapes. The proposed basis function method is validated using a high-aspect-ratio wing, a swept test plate, and the National Aeronautics and Space Administration Low Boom Flight Demonstration mission X-59 Quiet Supersonic Technology (QueSST) aircraft (Lockheed Martin, Bethesda, Maryland). A large structural deformation of a high-aspect-ratio wing is successfully captured using the proposed basis function method with less than 0.3-percentprediction error at the wing-tip section. The basis function method gives excellent deformation prediction, even with stress concentration. Performance of the basis functions is compared using the X-59 stabilator sample case. In most of the sample load cases, static deformations give a better correlation with the target deformation than do mode shapes. Wing shape sensing with sparse strain data is also demonstrated in this study using the X-59 QueSST aircraft. Predicted structural deformations match reasonably with the target deformations even without strain gauges on some structural components. The predicted deformations have a good match with the target deformations.