Uncovering Hazards Using a Multi-Objective Optimization to Explore the Faulty State-Space

Abstract

Considering resilience when designing complex engineered systems is crucial to ensure the system is safe under unexpected hazardous scenarios. Traditional risk-based approaches, such as Failure Modes and Effects Analysis (FMEA) are useful for designing the system to mitigate hazardous scenarios that can be identified by the designer, but often require experience or prior knowledge of system failures to generate. More recently, researchers have developed simulation tools that enable the designer to model large sets of hazardous scenarios (driven by both internal faults and external factors) through simulation. While these tools enable a wider scope of fault modes to be evaluated (e.g., by injecting combined set of fault modes or injecting modes at different times), the resulting assessments (like FMEA) still require knowledge of the specific modes to be evaluated. However, failure to analyze a wide variety of fault scenarios can lead to an incomplete picture of the system resilience, especially to "surprise events'' which may be difficult for the designer to identify and predict beforehand. To overcome this challenge, previous work developed a fault sampling approach for resilience simulations which would procedurally-generate a wide variety of potential faults by systematically perturbing the health states of the system. While the resulting fault modes generated covered a much larger space hazards than would be otherwise considered (and identified many unique failure trajectories which would not have otherwise been identified), it also significantly increased the computational cost of the analysis and resulted in the simulation and analysis of a large set of essentially duplicate scenarios. Additionally, as the number of dimensions in the faulty state-space increases, the full elaboration of possible modes becomes computationally infeasible, justifying the use of a more targeted search. To resolve this limitation, this work proposes the use of a multiobjective optimization algorithm to search the health state space for potential fault modes that are both (1) hazardous and (2) unique. To solve this type of problem, this work proposes the use of a cooperative co-evolutionary algorithm. To demonstrate this approach, it will be applied to a model of an autonomous rover which uses line markings to navigate, focusing on potential hazards in the drive system which could cause the rover to crash. To determine the merit of the approach, it will further be compared with the previously-presented range elaboration approach and a random mode generation approach on the basis of computational efficiency and found modes.